网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
面蚀 surface erosion
参考答案
更多 “面蚀 surface erosion” 相关考题
考题
材料：Spark erosion is caused by a voltage discharge between the main bearing and journal surface. The cause of the potential is the development of a galvanic element between the ship’s hull, sea water, and the propeller shaft/crankshaft.The oil film acts as a dielectric. The puncture voltage in the bearing depends on the thickness of the oil film. With increasing engine ratings, the specific load in the main bearing is increased. his will reduce the oil film thickness, and enable the discharge to take place at a lower voltage level.Since the hydrodynamic oil film thickness varies through a rotation cycle, the discharge will take place at roughly the same instant during each rotation cycle, i.e. when the film thickness is at its minimum. The roughening will accordingly be concentrated in certain areas on the journal surface. In the early stages, the roughened areas can resemble pitting erosion. but later, as the roughness increases, the small craters will scrape off and pick up white metal-hence the silvery white appearance.Therefore, to ensure protection against spark erosion, the potential level must be kept at maximum 80 mV, which is feasible today with a high efficiency earthing device. If an earthing device is installed, its effectiveness must be checked regularly. Spark erosion is only observed in main bearings and main bearing journals.问题：According to the paragraph one, a voltage between the main bearing and journal surface is produced by______.A.propeller rotationB.leakage from M/E electric control unitC.a galvanic elementD.friction between the main bearing and journal surface______engine ratings increase, the hydrodynamic oil film between the main bearing and journal surface is______.A.The lower/thinnerB.The higher/the thickerC.The lower/thickerD.The higher/thinnerWhen will the spark erosion take place on the journal surface during each rotation cycle?A.when the film thickness is at its minimumB.when the film thickness is at its maximumC.when the engine is on its compression strokeD.when the engine is on its exhaust strokeDuring the engine room watch keeping, which equipment must be noted to ensure protection against spark erosion?A.the antifouling plantB.the earthing deviceC.the main engine electric heating coilsD.the shaft generator请帮忙给出每个问题的正确答案和分析，谢谢！
考题
单选题Surface irregularities, such as erosion and pitting on injection pump plungers, will（）A
increase ignition delayB
affect fuel oil meteringC
affect engine performance at low speedD
only disappear due to fuel oil abrasion
考题
名词解释题面蚀 surface erosion
热门标签
最新试卷