单选题A new network has been configured using OSPF as the routing protocol. With which network type will OSPF establish router adjacencies but not perform the DR/BDR election process?（）A point-to-pointB Backbone area 0C Broadcast multicastD Non-broadcast multi-accessE The DR/BDR process is done for all interface types

考题 Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?（）A. Network BB. Network A and Network BC. Network AD. neither Network A nor Network B

查看答案

考题 Refer to the exhibit. Two routers are connected by Frame Relay and are running OSPF bet ween them. Each router has been configured with the appropriate network statements under router ospf 1, but the routers are not forming an adjacency. Which of the following three commands could be configured on each router to correct this problem?（）A. RouterC(config - if)#ip ospf network broadcast RouterD(config - if)#ip ospf network broadcastB. RouterC(config - if)#ip ospf network point - to - point RouterD(config - if)#ip ospf network point - to - pointC. RouterC(config - router)#neighbor 10.100. 100.4 RouterD(config - router)#neighbor 10.100.100.3D. RouterC(config - router)#neighbor 10.255.255.254 RouterD(config - router)#neighbor 10.255.255.253

查看答案

考题 An OSPF interface has been configured with the bandwidth 64 command. What will be the calculated OSPF cost of this link?() A.1B.10C.1562D.64000E.128000

查看答案

考题 Refer to the exhibit. Looking at the topology diagram and the partial router configurations shown, which statement is true? () A.The NProuter has two OSPF neighbors in the Full adjacency stateB.The NProuter serial0/0 interface has the OSPF dead timer set to 10 secondsC.The NProuter serial0/0 interface has been configured with an OSPF network type of pointtopointD.The 10.1.1.1 and 10.1.1.2 routers are not using the default OSPF dead and hello timers settingE.The Mismatched error is caus ed by the expiration of the OSPF timers

查看答案

考题 A new network has been configured using OSPF as the routing protocol. With which network type will OSPF establish router adjacencies but not perform the DR／BDR election process?() A. point-to-pointB. Backbone area 0C. Broadcast multicastD. Non-broadcast multi-accessE. The DR/BDR process is done for all interface types

查看答案

考题 The Testking network has been configured with OSPF as the routing protocol.What is the default administrative distance of the OSPF routing protocol?() A.90B.100C.110D.120E.130F.170G.200

查看答案

考题 An administrator types in the command router ospf 1 and receives the er ror message: "OSPF process 1 cannot start." (Output is omitted.) What should be done to correctly set up OSPF?() A. Ensure that an interface has been configured with an IP addressB. Ensure that IP classless is enabledC. Ensure that the interfaces can ping their directly connected neighborsD. Ensure that an interface has been configured with an IP address and is up

查看答案

考题 OSPF is configured over a Frame Relay network as shown in the exhibit. All PVCs are active.However, R1 and R3 fail to see all OSPF routes in their routing tables. The show ip ospf neighbor command executed on R2 shows the state of t he neighbors. What should be done to fix the problem? （）A. The ip ospf network broadcast command should be configured on each Frame Relay interfaceB. The ip ospf network non -broadcast command should be configured on each Frame Relay interfaceC. Th e ip ospf priority value on the spoke routers should be set to 0D. The ip ospf priority value on the hub router should be set to 0E. The neighbor command should be configured under the OSPF routing process on all routers

查看答案

考题 A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?（）A. oneB. threeC. twoD. zero

查看答案

考题 Acme Costume Company is connecting its manufacturing facilties to its stores with a small pointto-multipoint Frame Relay IP WAN. Little growth is expected in the network infrastructure.Up to this point the company has been using a dial-on-demand network. Dropping WAN costs, however, have led them to consider using a high-speed WAN solution to improve access. Which two routing protocols could you deploy to support the new larger network while keeping costs down?（）A、RIPB、RIPv2C、EIGRPD、OSPF

查看答案

考题 The Testking network has been configured with OSPF as the routing protocol.What is the default administrative distance of the OSPF routing protocol?（）A、90B、100C、110D、120E、130F、170G、200

查看答案

考题 A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）A、For the two vlans to communicate，a network statement for the trunk interface needs to be added to the OSPF configuration.B、For the two vlans to communicate， a network statement for each subinterface needs to be added to the OSPF configuration.C、Direct inter-vlan communication does not require OSPFD、OSPF cannot be used if router-on-a-stick is configured on the router

查看答案

考题 How will router A choose a path to the 10.1.2.0/24 network when different routing protocols are configured (Choose three.)（）。A、If RIPv2 is the routing protocol, only the path AD will be installed in the routing table by default.B、If RIPv2 is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.C、If EIGRP is the routing protocol, only the path AD will be installed in the routing table by default.D、If EIGRP is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.E、If EIGRP and OSPF are both running on the network, the EIGRP paths will be installed in the routing table.F、If EIGRP and OSPF are both running on the network, the OSPF paths will be installed in the routing table.

查看答案

考题 Acme Costume Company is connecting its manufacturing facilties to its stores with a small point-to-multipoint Frame Relay IP WAN. Little growth is expected in the network infrastructure.Up tothis point the company has been using a dial-on-demand network. Dropping WAN costs， however，have led them to consider using a high-speed WAN solution to improve access. Which two routingprotocols could you deploy to support the new larger network while keeping costs down？（）A、 RIPB、 RIPv2C、 EIGRPD、 OSPF

查看答案

考题 Multicast is being deployed in the network， and only ip pim sparse-dense mode has been configured on all interfaces in the network to support a new video streaming application. No other multicast configuration was applied anywhere in the network. Since enabling multicast， the network monitoring tools show periodic spikes in link utilization throughout the network， even in areas where the video application is not being used. What could be a possible cause？（）A、PIM sparse mode is being used.B、PIM dense mode is being used.C、The BGP multicast address family has not been configured.D、IGMP version 3 is being used.E、IP PIM neighbor filters have not been applied.

查看答案

考题 A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem? （）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0A、The process id is configured improperlyB、The OSPF area is configured improperlyC、The network wildcard mask is configured improperlyD、The network number is configured improperlyE、The AS is configured improperlyF、The network subnet mask is configuerd improperly

查看答案

考题 Router R1 exists in an Enterprise that uses EIGRP as its routing protocol. The show ip route command output on router R1 lists the following phrase: "Gateway of last resort is 1.1.1.1 to network 2.0.0.0". Whic h of the following is most likely to have caused this output to occur on R1?（）A、R1 has been configured with an ip default- network 2.0.0.0 command.B、R1 has been configured with an ip route 0.0.0.0 0.0.0.0 1.1.1.1 command.C、R1 has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.D、Another router has been configured with an ip default - network 2.0.0.0 command.E、Another router has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.

查看答案

考题 A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?（）A、oneB、threeC、twoD、zero

查看答案

考题 A new system has been installed and the network connection is very slow. The network administrators are sure that the network port is set to 100 full duplex. What command will display the configured and current speed settings of the adapter?（）A、lsdevB、lsattrC、entstatD、ifconfig

查看答案

考题单选题An administrator types in the command router ospf 1 and receives the er ror message: "OSPF process 1 cannot start." (Output is omitted.) What should be done to correctly set up OSPF？（）A Ensure that an interface has been configured with an IP addressB Ensure that IP classless is enabledC Ensure that the interfaces can ping their directly connected neighborsD Ensure that an interface has been configured with an IP address and is up

查看答案

考题单选题The Testking network has been configured with OSPF as the routing protocol.What is the default administrative distance of the OSPF routing protocol?（）A 90B 100C 110D 120E 130F 170G 200

查看答案

考题单选题You have just created a new VLAN on your network for inter-VLAN routing. What is one step that you should include in your VLAN-based implementation and verification plan？（）A Verify that different native VLANs exist between two switches for security purposes.B Verify that the switch is configured to allow for trunking on the switch ports.C Verify that each switch port has the proper IP address space assigned to it for the new VLAN. D Verify that the VLAN virtual interface has been correctly created and enabled.

查看答案

考题单选题A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（） Router(config)#router ospf 1 Router(config-router)#network 10.0.0.0 255.0.0.0 area 0A The process id is configured improperlyB The OSPF area is configured improperlyC The network wildcard mask is configured improperlyD The network number is configured improperlyE The AS is configured improperlyF The network subnet mask is configuerd improperly

查看答案

考题单选题You try to add a new router into the established Testking OSPF network. The networks attached to the new router do not appear in the routing tables of the other OSPF routers.The new router was configured for OSPF in the following way: Router(config)# router ospf 99 Router(config-if)# network 10.0.0.0 255.0.0.0 area 0 Based on this information, what is the most likely problem?（）A The process id is configured improperly.B The OSPF area is configured improperly.C The network wildcard mask is configured improperly.D The network number is configured improperly.E The AS is configured improperly.F The network subnet mask is configured improperly.G All of the above are likely problems.

查看答案

考题多选题How will router A choose a path to the 10.1.2.0/24 network when different routing protocols are configured (Choose three.)（）。AIf RIPv2 is the routing protocol, only the path AD will be installed in the routing table by default.BIf RIPv2 is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.CIf EIGRP is the routing protocol, only the path AD will be installed in the routing table by default.DIf EIGRP is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.EIf EIGRP and OSPF are both running on the network, the EIGRP paths will be installed in the routing table.FIf EIGRP and OSPF are both running on the network, the OSPF paths will be installed in the routing table.

查看答案

考题单选题A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）A For the two vlans to communicate，a network statement for the trunk interface needs to be added to the OSPF configuration.B For the two vlans to communicate， a network statement for each subinterface needs to be added to the OSPF configuration.C Direct inter-vlan communication does not require OSPFD OSPF cannot be used if router-on-a-stick is configured on the router

查看答案

考题多选题Acme Costume Company is connecting its manufacturing facilties to its stores with a small pointto-multipoint Frame Relay IP WAN. Little growth is expected in the network infrastructure.Up to this point the company has been using a dial-on-demand network. Dropping WAN costs, however, have led them to consider using a high-speed WAN solution to improve access. Which two routing protocols could you deploy to support the new larger network while keeping costs down?（）ARIPBRIPv2CEIGRPDOSPF

查看答案

网友您好， 请在下方输入框内输入要搜索的题目：

网友您好，请在下方输入框内输入要搜索的题目：