网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
单选题
A server has failed after a tested and scheduled change control has been implemented. Which of the following is the FIRST thing the server technician should do？（）
A
Perform a root cause analysis.
B
Escalate the problem.
C
Notify stakeholders.
D
Establish a plan of action.
参考答案
参考解析
解析：
暂无解析
更多 “单选题A server has failed after a tested and scheduled change control has been implemented. Which of the following is the FIRST thing the server technician should do？（）A Perform a root cause analysis.B Escalate the problem.C Notify stakeholders.D Establish a plan of action.” 相关考题
考题
After a server has been installed into a rack, an administrator must ensure which of the following?()
A. Warm air flow is permitted through the front bezelB. The system is labeled so that it can be identifiedC. Verify the change control process can be implementedD. Determine the correct power requirements
考题
You are the network administrator of a medium-sized company， and users are complaining that they cannotsend emails to some organizations. During your troubleshooting， you notice that your DNS MX record isblacklisted by several public blacklist filters. After clearing these listings for your IP address， and assumingthat your email server has the right virus protection in place， what are two possible solutions to prevent thisfrom happening in the future？（）A、Change your Internet provider.B、Change your public IP address.C、Allow the email server to send traffic only to TCP port 25.D、Put your email server in a DMZ.E、Use a separate public IP address for your email server only.
考题
After performing the initial steps in installing the server OS from a DVD-ROM， the server reboots and goes back into the setup wizard. Which of the following is the MOST likely cause for this problem？（）A、The DVD-ROM drive has failed.B、An installation file copied from the DVD to the hard drive is corrupt.C、Faulty OS installation DVDD、Incorrect boot sequence in the BIOS
考题
Your company has recently deployed a server that runs windows server 2008. The server has the ip information shown below.Ip address 192.168.46.186Subnet mask: 255.255.255.192Default gateway: 192.168.46.1Users on remote subnets report that they are unable to connect to the server.You need to ensure all users are able to connect to the server.What should you do?（）A、Change the IP address to192.168.46.129B、Change the IPaddress to192.168.46.200C、Change thes ubnet mask to a 24-bitmaskD、Change the subnet mask to a 27-bitmask.
考题
A server has a single failed hard drive in an array that is accessed through a hot plug backplane to ease replacement of failed drives. After replacing the drive several times， each of the replacement drives failed to power up and rebuild as the failed drive. Which of the following is the MOST likely cause of the failures？（）A、 The backplane has failed and needs to be replaced.B、 The array must be disbanded and recreated from a backup source to recognize the replacement drive.C、 There is a conflict with the optical drive on the server.D、 The server power supply is failing and not providing enough power for all the drives.
考题
A server has lost communication to its drives located on a fiber channel SAN.An administrator notices that the indicator lights on both the HBA and the SAN switch are not lit.Which of the following are the MOST likely causes of the problem？（）A、Failed HBAB、Failed switch portC、Faulty fiber cableD、Faulty driverE、Failed hard drivesF、Faulty configuration
考题
A Windows 2003 server has the operating system installed on a software RAID mirror. After a failure of one disk in the array the server will no longer boot up. The other drive is still functioning. Which of the following should be done to correct the issue？ （）A、 Edit the boot.ini file.B、 Change to a hardware RAID solution.C、 Recreate the array.D、 Edit the active drive in the array.
考题
While reviewing the backup logs a server administrator notices that a backup job for an application server on the same subnet has failed. Which of the following is MOST likely the problem？（）A、The remote agent was not running.B、The management card has failed.C、The proxy server was blocking access.D、The hardware firewall was blocking access.
考题
A Windows OS has failed to load after a successful power on self test. Which of the following steps will help troubleshoot the problem?（）A、Change the time and date in the BIOS.B、Replace the keyboard.C、Check for media in the optical drive.D、Add more RAM.
考题
After a server has been installed into a rack, an administrator must ensure which of the following?（）A、Warm air flow is permitted through the front bezelB、The system is labeled so that it can be identifiedC、Verify the change control process can be implementedD、Determine the correct power requirements
考题
Which of the following is MOST likely to occur if the temperature in the server room is cooled too quickly after a power outage？（）A、Server forms condensationB、Server will not POSTC、Server’s services will not startD、Server response times are slow due to temperature change
考题
A server has been intermittently shutting off. The power going to the server was tested and is giving the appropriate voltages. Which of the following tools would be used to test the power supply？（）A、 POST diagnostic cardB、 OTDRC、 TDRD、 Multimeter
考题
Which of the following could BEST be used to recover a failed RAID 1 disk after it has been replaced？（）A、 Tape restore utilitiesB、 Imaging utilitiesC、 Partitioning utilitiesD、 Array management utilities
考题
After rebooting one Virtual IO （VIO） server in a redundant environment， the following command output from the client partition shows that the path to the shared disk from the rebooted VIO server remains in a failed state. Vio_client1# lspath Failed hdisk0 vscsi0 Enabled hdisk0 vscsi1 What must the administrator do to ensure that the path is automatically restored when a VIO server is brought back into service？ （）A、 On both VIO servers， modify the inittab making chdev the last command， so that they will start during VIO server reboot.B、 On both VIO servers， change the following parameters and reboot each of them in turn hcheck_interval =60 hcheck_mode=interactiveC、 On client logical partition， modify the inittab making chdev the last command， so that they will start during client partition reboot.D、 On the client logical partition， change the following parameters and reboot the client hcheck_interval =60hcheck_mode=interactive
考题
A server is being set up at a client location. The system has been powered up for a clean install of the base OS. The CD is in the drive. After 5 minutes, the system is hung. There is no activity with the CD-ROM drive and nothing to select on the screen. Which of the following procedures should be performed next?（）A、Boot off diskette and change boot device to CDB、Change the bootlist for normal mode and rebootC、Reboot and press 5/F5 after keyboard is displayed on the screenD、Press enter to open SP menus once OK is showing in the LEDs
考题
WebSphere Commerce has been successfully installed and tested. WebSphere Commerce Analyzer has been installed and the extraction programs have run with no errors but there is no data in any reports when viewed from the WebSphere Commerce Accelerator. What could be the cause of this problem？（）A、The WebSphere Commerce application server was not startedB、The web server was not startedC、SSL has not been configured on the web serverD、The appropriate listeners were not enabled in Configuration ManagerE、The database server was not started
考题
Your company has a server that runs Windows Server 2008. Certification Services is configured as a stand-alone Certification Authority （CA） on the server. You need to audit changes to the CA configuration settings and the CA security settings. Which two tasks should you perform（）A、Configure auditing in the Certification Services snap-in.B、Enable auditing of successful and failed attempts to change permissions on files in the %SYSTEM32% /CertSrv directory.C、Enable auditing of successful and failed attempts to write to files in the %SYSTEM32%/CertLog directory.D、Enable the Audit object access setting in the Local Security Policy for the Certification Services server.
考题
单选题While reviewing the backup logs a server administrator notices that a backup job for an application server on the same subnet has failed. Which of the following is MOST likely the problem？（）A
The remote agent was not running.B
The management card has failed.C
The proxy server was blocking access.D
The hardware firewall was blocking access.
考题
单选题After a server has been installed into a rack， an administrator must ensure which of the following？（）A
Warm air flow is permitted through the front bezelB
The system is labeled so that it can be identifiedC
Verify the change control process can be implementedD
Determine the correct power requirements
考题
多选题Your company has a server that runs Windows Server 2008 R2. Active Directory Certificate Services （AD CS） is configured as a standalone Certification Authority （CA） on the server. You need to audit changes to the CA configuration settings and the CA security settings. Which two tasks should you perform（）AConfigure auditing in the Certification Authority snap-in.BEnable auditing of successful and failed attempts to change permissions on files in the %SYSTEM32%/CertSrv directory.CEnable auditing of successful and failed attempts to write to files in the %SYSTEM32%/CertLog directory.DEnable the Audit object access setting in the Local Security Policy for the Active Directory Certificate Services （AD CS） server.
考题
单选题A server has a single failed hard drive in an array that is accessed through a hot plug backplane to ease replacement of failed drives. After replacing the drive several times， each of the replacement drives failed to power up and rebuild as the failed drive. Which of the following is the MOST likely cause of the failures？（）A
The backplane has failed and needs to be replaced.B
The array must be disbanded and recreated from a backup source to recognize the replacement drive.C
There is a conflict with the optical drive on the server.D
The server power supply is failing and not providing enough power for all the drives.
考题
单选题After performing the initial steps in installing the server OS from a DVD-ROM， the server reboots and goes back into the setup wizard. Which of the following is the MOST likely cause for this problem？（）A
The DVD-ROM drive has failed.B
An installation file copied from the DVD to the hard drive is corrupt.C
Faulty OS installation DVDD
Incorrect boot sequence in the BIOS
考题
多选题Your company has a server that runs Windows Server 2008 R2. Active Directory Certificate Services （AD CS） is configured as a standalone Certification Authority （CA） on the server. You need to audit changes to the CA configuration settings and the CA security settings. Which two tasks should you perform（）AConfigure auditing in the Certification Authority snap-in.BEnable auditing of successful and failed attempts to change permissions on files in the %SYSTEM32%/CertSrv direCEnable auditing of successful and failed attempts to write to files in the %SYSTEM32%/CertLog directory.DEnable the Audit object access setting in the Local Security Policy for the Active Directory Certificate Services
考题
单选题A server has been intermittently shutting off. The power going to the server was tested and is giving the appropriate voltages. Which of the following tools would be used to test the power supply？（）A
POST diagnostic cardB
OTDRC
TDRD
Multimeter
考题
单选题Your company has recently deployed a server that runs Windows Server 2008. The server has the IP information shown below. IP address 192.168.46.186 Subnet mask： 255.255.255.192 Default gateway： 192.168.46.1 Users on remote subnets report that they are unable to connect to the server. You need to ensure all users are able to connect to the server. What should you do？ （）A
Change the IP address to 192.168.46.129B
Change the IP address to 192.168.46.200C
Change the subnet mask to a 24-bit maskD
Change the subnet mask to a 27-bit mask.
考题
单选题A Windows 2003 server has the operating system installed on a software RAID mirror. After a failure of one disk in the array the server will no longer boot up. The other drive is still functioning. Which of the following should be done to correct the issue？ （）A
Edit the boot.ini file.B
Change to a hardware RAID solution.C
Recreate the array.D
Edit the active drive in the array.
考题
单选题Which of the following should be performed after a maintenance kit has been applied and fullfunctionality tested?（）A
Roller regenerator appliedB
Page count resetC
New network settings appliedD
Printer drum replacement
热门标签
最新试卷