网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
单选题
For the interface ge-1/2/3.4, what does "ge" represent?（）
A
SONET/SDH
B
Gigabit Ethernet
C
Aggregated Ethernet
D
GRE
参考答案
参考解析
解析：
暂无解析
更多 “单选题For the interface ge-1/2/3.4, what does "ge" represent?（）A SONET/SDHB Gigabit EthernetC Aggregated EthernetD GRE” 相关考题
考题
In the exhibit, what does the () symbol indicate?()
A. There is a software issue with ge-1/0/1.0 interface.B. There is a hardware issue with ge-1/0/1.0 interface.C. The next hop of 172.25.213.11 is selected.D. The next hop of 172.25.213.11 is not resolvable.
考题
When configuring PPP over ATM interfaces, what does the profile utility accomplish?()
A.It binds an interface to a virtual router.B.It allows for dynamic interface creation.C.It assigns a Domain Name Server for a session.D.It identifies the RADIUS server to use for authentication
考题
For the interface ge－1／2／3.4, what does the "ge" represent?()
A. Gigabit EthernetB. SONET/SDHC. Aggregated EthernetD. GRE
考题
Referring to the exhibit, what are two differences between the active and candidate configurations?()
A. The ge-0/0/0 interface was added to the candidate configuration.B. Area 0 was added to the active configuration.C. Area 1 was added to the candidate configuration.D. The ge-0/0/0 interface was added to the active configuration.
考题
In the exhibit, there are four static routes that route traffic through different interfaces.Which interface does the router use if traffic is sent to the 99.0.0.1 destination?()
A. ge-0/0/1B. ge-0/0/2C. ge-0/0/3D. ge-0/0/4
考题
After issuing the show interfaces terse command, you notice that the status of one interface is "up down". What does this indicate?"()
A.Layer 1 on the interface is up but Layer 2 is down.B.Layer 2 on the interface is up but Layer 3 has not been configured.C.The interface is administratively up but the link status is down.D.The interface is up but has been administratively turned off.
考题
Router R1 has been conf igured with an ipv6 route 2000::／64 S0／0／0 64 command.Which of the following does the 64 at the end of the command represent?()
A. MetricB. Administrative distanceC. Timeout (seconds)D. Prefix lengthE. Interface ID
考题
Refertotheexhibit.Inthediagram,theswitchesarerunningIEEE802.1wRSPT.Onwhichportsshouldrootguardbeenabledinordertofacilitatedeterministicrootbridgeelectionundernormalandfailurescenarios?()
A.GE-3/1，GE-3/2B.FE-2/1，FE-3/2C.GE-1/1，GE-1/2D.GE-4/1，GE-4/2E.GE-2/1，GE-2/2F.GE-3/1，GE-3/2，GE-4/1，GE-4/2，FE-2/1，FE-3/2
考题
Refer to the exhibit. What does the (*) represent in the output?()
A.Packet is destined for a local interface to the router.B.Packet was translated, but no response was received from the distant device.C.Packet was not translated, because no additional ports are available.D.Packet was translated and fast switched to the destination.
考题
In the OSNR model for EDFA amplifiers, SNR OUT = 1/(1/SNR IN + FhvB/P IN ), what does SNR IN represent?（）A、the signal to noise of the current optical amplifierB、the signal to noise of the previous amplifier or sourceC、the signal to noise introduced by the optical multiplexerD、the accumulated noise to signal ratio of the optical channel
考题
A standard IP access list is applied to an Ethernet interface of a router. What does this standard access list filter on?（）A、The source and destination addressesB、The destination port numberC、The destination addressD、The source addressE、All of the above
考题
What does the mac packet-classify command do when applied to an interface configuration？（）A、 It enables MAC ACLs to be applied to only IP packets that enter the interface.B、 It enables MAC ACLs to be applied to only non-IP packets that enter the interface.C、 It enables MAC ACLs to be applied to all packets that enter the interface.D、 It enables MAC ACLs to be used for QoS settings.
考题
Router R1 has been conf igured with an ipv6 route 2000::/64 S0/0/0 64 command.Which of the following does the 64 at the end of the command represent?（）A、MetricB、Administrative distanceC、Timeout (seconds)D、Prefix lengthE、Interface ID
考题
You issue the command telnet interface ge-1/1/0 10.10.10.1 source 192.168.100.1 bypass-routing. Which statement is correct?（）A、The bypass-routing parameter is ignored when using private IP addressing.B、The telnet session will have the source IP address 10.10.10.1.C、The telnet session will connect to the neighboring device's interface ge-1/1/0.D、Return traffic for the telnet session might not arrive at interface ge-1/1/0.
考题
A BGP router is configured with bgp dampening 8 300 1500 20 route-map 1 .What does the value of 20 represent?（）A、reuseB、suppressC、half-lifeD、max-suppress-time
考题
When configuring PPP over ATM interfaces, what does the profile utility accomplish?（）A、It binds an interface to a virtual router.B、It allows for dynamic interface creation.C、It assigns a Domain Name Server for a session.D、It identifies the RADIUS server to use for authentication
考题
单选题In the exhibit, there are four static routes that route traffic through different interfaces.Which interface does the router use if traffic is sent to the 99.0.0.1 destination?（）A
ge-0/0/1B
ge-0/0/2C
ge-0/0/3D
ge-0/0/4
考题
单选题After issuing the show interfaces terse command, you notice that the status of one interface is "up down". What does this indicate?"（）A
Layer 1 on the interface is up but Layer 2 is down.B
Layer 2 on the interface is up but Layer 3 has not been configured.C
The interface is administratively up but the link status is down.D
The interface is up but has been administratively turned off.
考题
单选题You have just configured the network interface on systemA . The following information is From systemB， you test the network connectivity by sending ICMP ECHO_REQUEST packets to systemA. The following message is displayed： no answer from systemA What is most likely the problem？（）A
The interface is not plumbed.B
The interface is not configured.C
The interface does not have valid routes configured.D
The interface is not marked as
考题
单选题When the average of a list of course grades is multiplied by the number of courses, the result is n. What does n represent?A
Half the number of coursesB
Half the sum of course gradesC
The number of coursesD
The average of the course gradesE
The sum of the course grades
考题
单选题Click the Exhibit button. Referring to the exhibit, which statement contains the correct gateway parameters?（）A
[edit security ike] user@host# show gateway ike-phase1-gateway { policy ike-policy1; address 10.10.10.1; dead-peer-detection { interval 20; threshold 5; } external-interface ge-1/0/1.0; }B
[edit security ike] user@host# show gateway ike-phase1-gateway { ike-policy ike-policy1; address 10.10.10.1; dead-peer-detection { interval 20; threshold 5; } external-interface ge-1/0/1.0; }C
[edit security ike] user@host# show gateway ike-phase1-gateway { policy ike1-policy; address 10.10.10.1; dead-peer-detection { interval 20; threshold 5; } external-interface ge-1/0/1.0; }D
[edit security ike] user@host# show gateway ike-phase1-gateway { ike-policy ike1-policy; address 10.10.10.1; dead-peer-detection { interval 20; threshold 5; } external-interface ge-1/0/1.0; }
考题
单选题A common class of wire rope used for mooring is the 6x19 class. What does the 6 represent?（）A
Factor of safetyB
Number of wires per strandC
Number of strands per wire ropeD
Number of wires in the core
考题
单选题For the interface ge-1/2/3.4, what does "ge" represent?（）A
SONET/SDHB
Gigabit EthernetC
Aggregated EthernetD
GRE
考题
单选题What does the number one 1 represent for interface fe-0/0/1？（）A
port numberB
PCI slot numberC
channel numberD
virtual PIC number
考题
单选题When configuring PPP over ATM interfaces, what does the profile utility accomplish?（）A
It binds an interface to a virtual router.B
It allows for dynamic interface creation.C
It assigns a Domain Name Server for a session.D
It identifies the RADIUS server to use for authentication
考题
单选题A BGP router is configured with bgp dampening 8 300 1500 20 route-map 1 .What does the value of 20 represent?（）A
reuseB
suppressC
half-lifeD
max-suppress-time
考题
单选题You issue the command telnet interface ge-1/1/0 10.10.10.1 source 192.168.100.1 bypass-routing. Which statement is correct?（）A
The bypass-routing parameter is ignored when using private IP addressing.B
The telnet session will have the source IP address 10.10.10.1.C
The telnet session will connect to the neighboring device's interface ge-1/1/0.D
Return traffic for the telnet session might not arrive at interface ge-1/1/0.
热门标签
最新试卷