网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
A server has been having a memory problem. What feature can be used to determine the failing memory module？（）
- A、Reboot the server
- B、RSA II
- C、LightPath Diagnostics
- D、ServerGuide
参考答案
更多 “A server has been having a memory problem. What feature can be used to determine the failing memory module？（）A、Reboot the serverB、RSA IIC、LightPath DiagnosticsD、ServerGuide” 相关考题
考题
Which of the following does an out－of－memory error indicate on a printer?()
A. A faulty memory module in the printer.B. A postscript print job has been sent to the printer.C. A large print job has been sent to the printer.D. The printer firmware needs to be updated.
考题
When enabling IPS on an ISR using the Cisco SDM IPS Wizard， in what location can the SDF be placed？（）A、On the RAM of the ISRB、On the USB memory stick of the ISRC、On the NVRAM of the ISRD、On the IPS Module of the ISRE、On the Flash memory of the ISR
考题
After applying a new ACL on a device， its CPU utilization rose significantly and many messages startingwith "%SEC-6-IPACCESSLOG" appeared on the Syslog server.What can be done to resolve this situation？（）A、Increase memory allocation for ACLs.B、Remove all entries from the ACL and use a single permit ip any any statement.C、Remove the log keyword from each ACL entry.D、Reboot the device after the ACL has been applied.
考题
AIX 5L and SUN Solaris have differing approaches at handling processor failures. Which statement best describes how AIX handles processor failures？（）A、If AIX discovers a processor with too many recoverable errors during runtime， it will dynamically turn off that processor， while the rest of the system keeps running.B、If AIX detects a failing processor it will automatically move all resources to another processor. The failed processor can be hot-swapped and the new replacement becomes the active processor.C、If AIX determines a processor is failing， it will perform diagnostics to determine which processor function can be disabled and dynamically reallocate all CPU and memory resources thus isolating the failure condition and preventing a reboot.D、If AIX senses a processor level error condition， internal diagnostics are activated to determine the severity of the problem. After the failure threshold is met， a message is broadcast to the service processor informing the operator to perform a system reboot.
考题
What are two benefits of the modular design of the Junos OS?（）A、Each module uses application-specific integrated circuits (ASICs).B、Each module runs in its own protected memory space.C、Each module can be individually restarted.D、Each module is supported across all Junos platforms.
考题
An administrator is adding additional memory into a server that registers 1GB of memory in the OS and notices that the system has 2GB of memory physically installed； however， the server only shows 1GB of memory during POST. Which of the following is the MOST likely reason for this？（）A、 The OS does not support more than 1GB of memory.B、 The system memory has different manufacture dates.C、 Two of the memory sticks are defective.D、 The server is using memory interleaving.
考题
A technician has to populate a server motherboard with memory. The board has a memory bus speed of 800 MHz. Which of the following memory types should be used？（）A、DDR3B、SDRAMC、DDRD、DDR2
考题
Which of the following does an out-of-memory error indicate on a printer?（）A、A faulty memory module in the printer.B、A postscript print job has been sent to the printer.C、A large print job has been sent to the printer.D、The printer firmware needs to be updated.
考题
The technician is repairing a PC which appears to have a failing RAM module. After replacing the module, the extra memory still is not registering. Which of the following is MOST likely the issue?（）A、Jumper settings are incorrectB、The RAM module is defectiveC、The memory slot is defectiveD、CMOS needs to be flashed
考题
The administrator has just installed a new memory module into the server. Now， the server is not showing the new memory. Which of the following should the administrator perform FIRST？（）A、System rebootB、Reseat the memoryC、Install the latest firmwareD、Install the latest driver
考题
A customer is trying to remotely upgrade their system BIOS firmware on their xSeries server through their RSA adapter. What feature would best fit the requirement？（）A、Use the remote update feature of the RSAB、Use the remote diskette/CD feature on the RSAC、Insert the diskette in the server， flash the BIOS， and reboot the server.D、Use the remote POST function of the RSA to flash the BIOS
考题
After purchasing the Active Memory Expansion （AME） Enablement Feature，what tasks must be completed before AME can be used？（）A、Enable using active partition properties with DLPARB、Enter the activation key via the AIX 6.1 command line and reboot AIXC、Enter the activation key via the HMC,power cycle the managed system and start the LPARD、Enter the activation key via the HMC,modify the partition profile and restart the LPAR
考题
A customer has a Power 770 running an SAP ERP workload on AIX 7. It has a single partition with 12 cores and 48GB of memory and the CPU is underutilized at 46% with 1000 users. Memory utilization is at 80%. The number of users will increase to 1700, increasing memory utilization by 37%. Which of the following supports this requirement?（）A、Active Memory ServerB、Active Memory SharingC、Active Memory PoolingD、Active Memory Expansion
考题
A Power 720 has AIX 6.1 and Linux partitions.During normal workloads there is more than enough memory available to the LPARs. During month-end processing one partition becomes memory constrained. What can help overcome this situation？（）A、Active Memory Sharing （AMS）B、Active Memory Expansion （AME）C、Integrated Virtual Memory （IVM）D、Memory Capacity on Demand （CoD）
考题
An application vendor wants to choose a fault tolerant platform for their new application. The application benefits from multiple processors and has been tested on Red Hat Advanced Server 3. To determine the memory requirements for the application， which of the following is the best procedure？（）A、The application should be tested and baselines should be measured with simulated user loads.B、The application should be tested with the minimum amount of memory then increase the memory in increments until an acceptable response is achieved.C、The application should be tested with differing amounts of memory and the fastest response time is reached it should be used as the acceptable configuration.D、The application should be tested with the maximum amount of memory then decrease the memory in increments until an acceptable price/performance ratio is reached.
考题
Why should you sell IBM memory to your customer at the time of the system sale？ （）A、IBM Memory is tested and supported in IBM systems， plus it automatically assumes the balance of system warranty. It is much more difficult to sell memory upgrades to customers after the server has been purchased.B、IBM memory is no different to third party memory， so memory can be sold at any time after the sale with ease.C、IBM memory needs a ServicePac to be sold for warranty to be implemented， so can only be sold at time of system sale.D、You should sell IBM memory at the time of system sale， as Servers can not be expanded once configured in SSCT.
考题
A customer is experiencing problems with a rack mount server. The problem might be a failing memory module. Which of the following can be used to find the failing module without going to the physical server？（）A、Light Path DiagnosticsB、Remote PresenceC、Integrated Management Module （IMM）D、Advanced Management Module （AMM）
考题
Your database is configured in shared server mode. However， your senior DBA asks you to modify the value ofthe PRIVATE_SGA limit in the profile of the users. What could be the reason for this（）A、To limit the User Global Area （UGA） memory allocated to a session from the SGAB、To limit the amount of memory to be used for the dispatcher queue of a session in SGAC、To limit the amount of memory to be used for the request pool in System Global Area （SGA）D、To control the amount of memory allocated in SGA for the local variables for each shared server process
考题
单选题Your database is configured in shared server mode. However， your senior DBA asks you to modifythe value of the PRIVATE_SGA limit in the profile of the users. What could be the reason for this（）A
to limit the User Global Area （UGA） memory allocated to a session from the SGAB
to limit the amount of memory to be used for the dispatcher queue of a session in SGAC
to limit the amount of memory to be used for the request pool in System Global Area （SGA）D
to control the amount of memory allocated in SGA for the local variables for each shared server process
考题
单选题When enabling IPS on an ISR using the Cisco SDM IPS Wizard， in what location can the SDF be placed？（）A
On the RAM of the ISRB
On the USB memory stick of the ISRC
On the NVRAM of the ISRD
On the IPS Module of the ISRE
On the Flash memory of the ISR
考题
单选题A technician has to populate a server motherboard with memory. The board has a memory bus speed of 800 MHz. Which of the following memory types should be used？（）A
DDR3B
SDRAMC
DDRD
DDR2
考题
单选题A server has been having a memory problem. What feature can be used to determine the failing memory module？（）A
Reboot the serverB
RSA IIC
LightPath DiagnosticsD
ServerGuide
考题
单选题The technician is repairing a PC which appears to have a failing RAM module. After replacing the module, the extra memory still is not registering. Which of the following is MOST likely the issue?（）A
Jumper settings are incorrectB
The RAM module is defectiveC
The memory slot is defectiveD
CMOS needs to be flashed
考题
单选题Which of the following does an out-of-memory error indicate on a printer?（）A
A faulty memory module in the printer.B
A postscript print job has been sent to the printer.C
A large print job has been sent to the printer.D
The printer firmware needs to be updated.
考题
单选题An administrator is adding additional memory into a server that registers 1GB of memory in the OS and notices that the system has 2GB of memory physically installed; however, the server only shows 1GB of memory during POST. Which of the following is the MOST likely reason for this?（）A
The OS does not support more than 1GB of memory.B
The system memory has different manufacture dates.C
Two of the memory sticks are defective.D
The server is using memory interleaving.
考题
单选题A Power 720 has AIX 6.1 and Linux partitions.During normal workloads there is more than enough memory available to the LPARs. During month-end processing one partition becomes memory constrained. What can help overcome this situation？（）A
Active Memory Sharing （AMS）B
Active Memory Expansion （AME）C
Integrated Virtual Memory （IVM）D
Memory Capacity on Demand （CoD）
考题
单选题AIX 5L and SUN Solaris have differing approaches at handling processor failures. Which statement best describes how AIX handles processor failures？（）A
If AIX discovers a processor with too many recoverable errors during runtime， it will dynamically turn off that processor， while the rest of the system keeps running.B
If AIX detects a failing processor it will automatically move all resources to another processor. The failed processor can be hot-swapped and the new replacement becomes the active processor.C
If AIX determines a processor is failing， it will perform diagnostics to determine which processor function can be disabled and dynamically reallocate all CPU and memory resources thus isolating the failure condition and preventing a reboot.D
If AIX senses a processor level error condition， internal diagnostics are activated to determine the severity of the problem. After the failure threshold is met， a message is broadcast to the service processor informing the operator to perform a system reboot.
热门标签
最新试卷