网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? （）
- A、TE1
- B、TE2
- C、NT1
- D、NT2
参考答案
更多 “A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? （）A、TE1B、TE2C、NT1D、NT2” 相关考题
考题
[说明]下面是某路由器的部分配置信息，解释部分语句的含义。[配置路由器信息]Current configuration：!hostname router1isdn switch-type basic-net3 (1)!interface Ethernet0ip address 10.0.0.1 255.255.255.0ip nat inside (2)!interface bri 0ip address negotiated (3)ip nat outsideencapsulation PPPPPP authentication pap callin (4)PPP multlink (5)dialer-group 1dialer string 2633PPP pap sent-username 263 password 263 (6)ip route 0.0.0.0 0.0.0.0 bri 0access-list 2 permit any (7)dialer-list 1 protocol ip permit (8)ip nat inside source list 2 interface bri 0 overload (9)……End
考题
【问题2】（3分）根据图4-1的配置，补充完成下面路由器的配置命令：Router（config）# interface （3）Router（config-if）#ip address 10.10.1.1 255.255.255.0Router（config-if）#no shutdownRouter（config-if）#exitRouter（config）# interface （4）Router（config-if）# ip address 192.168.1.1 255.255.255.0Router（config）# interface （5）Router（config-if）# ip address 10.10.2.1 255.255.255.0
考题
You would like to operate IS－IS on interface atm 6／0.33 with an IP address of 192.168.1.1／24.Which set of commands accomplishes this?()
A. router isis network 192.168.1.0 0.0.0.255B. router isis network 192.168.1.0 255.255.255.0C. interface atm 6/0.33 ip address 192.168.1.1 255.255.255.0 router isisD. interface atm 6/0.33 ip address 192.168.1.1 255.255.255.0 ip router isis
考题
Which ISDN device converts the four－wire BRI signals from an S／T interface into two－wire signals of a U interface?()
A.TE1B.NT-2C.TAD.TE2E.NT-1
考题
Which device enables a router serial interface to connect to the ISDN BRI?()
A.NT2B.NT1C.TED.TAE.TE1
考题
You have just obtained a modular Cisco router with 2 serial connections and a BRI／U interface. What other physical piece of hardware is required in order to establish an ISDN connection?()
A. Nothing. The router is already suitable.B. A BRI WAN interface in the router.C. An external NT1 to terminate the local loop.D. A TA/NT1 device on the router.
考题
What is the reason for configuring a passive interface on a router?()
A. Allows interfaces to share common IP addresses.B. Allows an interface to remain up without the aid of keepalives.C. Allows a router to send routing and not receive updates via that interface.D. Allows a routing protocol to forward updates that is missing its IP address.E. Allows a router to receive routing updates on an interface but not send updates via that interface.
考题
Usetheoutputfromtheroutershowninthegraphicabovetodeterminewhichofthefollowingarecorrect.()
A.Router John uses alink-state routing protocol.B.Router John will receive routing updates on the Serial0/0 interface.C.Router John will receive routing updates on the Serial0/1 interface.D.Router John will send routing updates out the Serial0/0 interface.E.Router John will send routing updates out the FastEthernet0/0 interface.F.Router John will send routing updates out the Serial0/1 interface.
考题
Use the output from the router shown in the graphic above to determine which of the following are correct.()
A. Router John uses a link-state routing protocol.B. Router John will receive routing updates on the Serial0/0 interface.C. Router John will receive routing updates on the Serial0/1 interface.D. Router John will send routing updates out the Serial0/0 interface.E. Router John will send routing updates out the FastEthernet0/0 interface.F. Router John will send routing updates out the Serial0/1 interface.
考题
You have just obtained a modular Cisco router with 2 serial connections and a BRI/U interface. What other physical piece of hardware is required in order to establish an ISDN connection?（）A、Nothing. The router is already suitable.B、A BRI WAN interface in the router.C、An external NT1 to terminate the local loop.D、A TA/NT1 device on the router.
考题
Which of these statements accurately identifies how Unicast Reverse Path Forwarding can be employed to prevent the use of malformed or forged IP sources addresses？（）A、It is applied only on the input interface of a router.B、It is applied only on the output interface of a router.C、It can be configured either on the input or output interface of a router.D、It cannot be configured on a router interface.E、It is configured under any routing protocol process.
考题
Which device enables a router serial interface to connect to the ISDN BRI?（）A、NT2B、NT1C、TED、TAE、TE1
考题
Which three causes could prevent a host from getting an IPv6 address with stateless autoconfiguration？（）A、The autoconfig command is missing from the router interface.B、IPv6 multicast routing is not enabled on the router interface.C、IPv6 unicast routing is not enabled on the router interface.D、The router interface is configured with a /63 mask.E、The router interface is configured with a /65 mask.
考题
OSPF is enabled on router A. You execute the following command on router A and receive theaccompanying output:RouterA#ping 224.0.0.5 repeat1Type escape sequence to abort.Sending 1, 1 00 - byte ICMP Echos to 224.0.0.5, timeout is 2 seconds:Reply to request 0 from 10.100.100.1, 4 ms10.100.100.1 is the IP address of a loopback interface on router A. What can you conclude about router A?（）A、Only the router A loopback interface is parti cipating in the OSPF routing processB、None of the router A interfaces are participating in the OSPF routing processC、Router A is using the loopback interface IP address as its OSPF router IDD、Router A does not have any reachable OSPF neighbors
考题
The Peanut router is able to successfully ping the Serial 0 and Ethernet 0 interface of the Popcorn router, but a ping issued to the Ethernet 1 interface fails. Based on the above output, what are the potential causes of this problem?（）A、The Popcorn router is not forwarding RIP updates.B、The Popcorn router did not include network 192.168.12.0 in its routing configuration.C、The Ethernet1 interface of the Popcorn router is shutdown.D、The clockrate is not present in the configuration of one of the routers.E、The Serial interface of the Popcorn router is not operating.
考题
What is the reason for configuring a passive interface on a router?（）A、Allows interfaces to share common IP addresses.B、Allows an interface to remain up without the aid of keepalives.C、Allows a router to send routing and not receive updates via that interface.D、Allows a routing protocol to forward updates that is missing its IP address.E、Allows a router to receive routing updates on an interface but not send updates via that interface.
考题
What is true about access control on bridged and routed VLAN traffic？ （）A、 Router ACLs can be applied to the input and output directions of a VLAN interface.B、 Bridged ACLs can be applied to the input and output directions of a VLAN interface.C、 Only router ACLs can be applied to a VLAN interface.D、 VLAN maps and router ACLs can be used in combination.E、 VLAN maps can be applied to a VLAN interface
考题
Which ISDN device converts the four-wire BRI signals from an S/T interface into two-wire signals of a U interface?（）A、TE1B、NT-2C、TAD、TE2E、NT-1
考题
You would like to operate IS-IS on interface atm 6/0.33 with an IP address of 192.168.1.1/24. Which set of commands accomplishes this?（）A、router isis network 192.168.1.0 0.0.0.255B、router isis network 192.168.1.0 255.255.255.0C、interface atm 6/0.33 ip address 192.168.1.1 255.255.255.0 router isisD、interface atm 6/0.33 ip address 192.168.1.1 255.255.255.0 ip router isis
考题
单选题Which device enables a router serial interface to connect to the ISDN BRI?（）A
NT2B
NT1C
TED
TAE
TE1
考题
单选题A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? （）A
TE1B
TE2C
NT1D
NT2
考题
多选题The Peanut router is able to successfully ping the Serial 0 and Ethernet 0 interface of the Popcorn router, but a ping issued to the Ethernet 1 interface fails. Based on the above output, what are the potential causes of this problem?（）AThe Popcorn router is not forwarding RIP updates.BThe Popcorn router did not include network 192.168.12.0 in its routing configuration.CThe Ethernet1 interface of the Popcorn router is shutdown.DThe clockrate is not present in the configuration of one of the routers.EThe Serial interface of the Popcorn router is not operating.
考题
单选题Which ISDN device converts the four-wire BRI signals from an S/T interface into two-wire signals of a U interface?（）A
TE1B
NT-2C
TAD
TE2E
NT-1
考题
单选题You have just obtained a modular Cisco router with 2 serial connections and a BRI/U interface. What other physical piece of hardware is required in order to establish an ISDN connection?（）A
Nothing. The router is already suitable.B
A BRI WAN interface in the router.C
An external NT1 to terminate the local loop.D
A TA/NT1 device on the router.
考题
单选题Which of these statements accurately identifies how Unicast Reverse Path Forwarding can be employed to prevent the use of malformed or forged IP sources addresses？（）A
It is applied only on the input interface of a router.B
It is applied only on the output interface of a router.C
It can be configured either on the input or output interface of a router.D
It cannot be configured on a router interface.E
It is configured under any routing protocol process.
考题
名词解释题BRI（Basic Rate Interface）基本速率接口
热门标签
最新试卷