网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
What are the possible trunking modes for a switch port?（）
- A、transparent
- B、auto
- C、on
- D、desirable
- E、client
- F、forwarding
参考答案
更多 “What are the possible trunking modes for a switch port?（）A、transparentB、autoC、onD、desirableE、clientF、forwarding” 相关考题
考题
When a switch port is used as a VLAN trunk, which of the following trunk modes are valid? (Select all that apply.)A. BlockingB. AutoC. DesirableD. OnE. TransparentF. Learning
考题
What are the switch and bridge port characteristics of a layer two spanning－tree network that is fully converged?()
A. All switch and bridge ports are in the forwarding state.B. All switch and bridge ports are in the stand-by state.C. All switch and bridge ports are assigned as either root or designated ports.D. All switch and bridge ports are in either the forwarding or blocking state.E. All switch and bridge are either blocking or looping.
考题
What are the possible trunking modes for a switch port?()
A. transparentB. autoC. onD. desirableE. clientF. forwarding
考题
Which are valid modes for a switch port used as a VLAN trunk?()
A.transparentB.autoC.onD.desirableE.blockingF.forwarding
考题
Which are valid modes for a switch port used as a VLAN trunk? ()
A.transparentB.autoC.onD.desirable
考题
WhicharevalidmodesforaswitchportusedasaVLANtrunk?(Choosethree.)()
A.transparentB.autoC.onD.desirableE.blockingF.forwarding
考题
Which are valid modes for a switch port used as a VLAN trunk (Choose three.)()。
A.transparentB.autoC.onD.desirableE.blockingF.forwarding
考题
What are the possible trunking modes for a switch port? ()
A.transparentB.autoC.onD.desirableE.clientF.forwarding
考题
Refer to the diagram. Which three statements describe the router port configuration and the switch port configuration as shown in the topology? ()
A.The Router1 WAN port is configured as a trunking port.B.The Router1 port connected to Switch1 is configured using subinterfaces.C.The Router1 port connected to Switch1 is configured as 10 Mbps.D.The Switch1 port connected to Router1 is configured as a trunking port.E.The Switch1 port connected to Host B is configured as an access port.F.The Switch1 port connected to Hub1 is configured as full duplex.
考题
What are the possible trunking modes for a switch port? （）A、transparentB、autoC、onD、desirableE、clientF、forwarding
考题
You examine the port statistics on a Cisco Catalyst switch and notice an excessive number offrames are being dropped. Which of the following are possible reasons for the drops？（）A、Unknown destination MAC addressB、Bad cablingC、MAC forwarding table is fullD、Port configured for half duplexE、Port configured for full duplexF、Network congestion
考题
Which two of the following statements describe a routed switch port on a multilayer switch？（）A、Layer 2 switching and Layer 3 routing are mutually supported.B、The port will not be associated with any VLAN.C、The routed switch port supports VLAN subinterfaces.D、The routed switch port is used when a switch has only one port per VLAN or subnet.E、The routed switch port ensures that STP remains in the forwarding state.
考题
Which are valid modes for a switch port used as a VLAN trunk (Choose three.)（）。A、transparentB、autoC、onD、desirableE、blockingF、forwarding
考题
You work as a network Technician. A new workstation has consistently been unable to obtain anIP address from the DHCP server when the workstation boots. Older workstations function normally， and the new workstation obtains an address when manually forced to renew its address. What should be configured on the switch to allow the workstation to obtain an IP address at boot？（）A、UplinkFast on the switch port connected to the serverB、BackboneFast on the switch port connected to the serverC、PortFast on the switch port connected to the workstationD、trunking on the switch
考题
What two things will occur when an edge port receives a BPDU？（）A、The port immediately transitions to the Forwarding state.B、The switch generates a Topology Change Notification （TCN） BPDU.C、The port immediately transitions to the err-disable state.D、The port becomes a normal STP switch port.
考题
The network administrator is trying to add Switch1 to the network， but the 802.1Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine. What are three possible causes of this problem？ （）A、The trunking configuration mode on Switch1 is set to Off.B、The trunking configuration mode on the other end is set to On.C、The trunking configuration mode on the other end is set to Desirable.D、Cisco Discovery Protocol is not running on the other end.E、There is a VTP domain name mismatch.F、Switch1 does not support 802.1Q.
考题
Which statement is correct about RSTP port roles？（）A、The designated port is the switch port on every nonroot bridge that is the chosen path to theroot bridge. There can be only one designated port on every switch. The designated portassumes the forwarding state in a stable active topology. All switches connected to a given segment listen to all BPDUs and determine the switch that will be the root switch for a particular segment.B、The disabled port is an additional switch port on the designated switch with a redundant link to the segment for which the switch is designated. A disabled port has a higher port ID than the disabled port on the designated switch. The disabled port assumes the discarding state in astable active topology.C、The backup port is a switch port that offers an alternate path toward the root bridge. The backup port assumes a discarding state in a stable， active topology. The backup port will be present on nondesignated switches and will make a transition to a designated port if the current designated path fails.D、The root port is the switch port on every nonroot bridge that is the chosen path to the root bridge. There can be only one root port on every switch. The root port assumes the forwarding state in a stable active topology.
考题
Which are valid modes for a switch port used as a VLAN trunk?（）A、transparentB、autoC、onD、desirableE、blockingF、forwarding
考题
When a switch port is used as a VLAN trunk, which of the following trunk modes are valid?（）A、BlockingB、AutoC、DesirableD、OnE、TransparentF、Learning
考题
When configuring port security on a Cisco Catalyst switch port， what is the default action taken by the switch if a violation occurs？ （）A、protect （drop packets with unknown source addresses）B、restrict （increment SecurityViolation counter）C、shut down （access or trunk port）D、transition （the access port to a trunking port）
考题
Which are valid modes for a switch port used as a VLAN trunk? （）A、transparentB、autoC、onD、desirable
考题
多选题What two things will occur when an edge port receives a BPDU？（）AThe port immediately transitions to the Forwarding state.BThe switch generates a Topology Change Notification （TCN） BPDU.CThe port immediately transitions to the err-disable state.DThe port becomes a normal STP switch port.
考题
多选题Which are valid modes for a switch port used as a VLAN trunk? （）AtransparentBautoConDdesirableEblockingFforwarding
考题
多选题What are the possible trunking modes for a switch port?（）AtransparentBautoConDdesirableEclientFforwarding
考题
多选题When a switch port is used as a VLAN trunk, which of the following trunk modes are valid?（）ABlockingBAutoCDesirableDOnETransparentFLearning
热门标签
最新试卷