网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
Refer to Topic TestKing.com in iPAD document.Which switch is the root bridge for VLAN 1?（）
- A、TestKingD
- B、TestKing1
- C、TestKing2
- D、TestKing3
参考答案
更多 “Refer to Topic TestKing.com in iPAD document.Which switch is the root bridge for VLAN 1?（）A、TestKingDB、TestKing1C、TestKing2D、TestKing3” 相关考题
考题
Refer to Topic TestKing.com in iPAD document.Which switch is the root bridge for VLAN 1?()
A.TestKingDB.TestKing1C.TestKing2D.TestKing3
考题
Refer to Topic TestKing.com in iPAD document.Which ports on TestKing3 are operating as trunks?()
A.Fa0/1B.Fa0/3C.Fa0/4D.Fa0/6E.Fa0/9F.Fa0/12
考题
Refer to Topic TestKing.com in iPAD document.To which port of TestKing3 is router VLAN－R1 connected?()
A. Fa 0/1B. Fa 0/3C. Fa 0/6D. Fa 0/8E. Fa 0/9F. Fa 0/12
考题
Refer to Topic TestKing.com in iPAD document.What interface did Sw－AC3 associate with source MAC address 0010.5a0c.ffba?()
A.Fa0/1B.Fa0/3C.Fa0/6D.Fa0/8E.Fa0/9F.Fa/12
考题
Refer to Topic TestKing.com in iPAD document.What happens to the network when TestKingX is reconnected and a trunk exists between the two switches?()
A. All VLANs except the default VLAN will be removed from all switches.B. All existing switches will have the students, admin, faculty, Servers, Management,Production, and no-where VLANs.C. The VLANs Servers, Management, Production, and no-where will replace the VLANs on SwX.D. The VLANs Servers, Management, Production, and no-where will be removed from existing switches.
考题
What are the switch and bridge port characteristics of a layer two spanning－tree network that is fully converged?()
A. All switch and bridge ports are in the forwarding state.B. All switch and bridge ports are in the stand-by state.C. All switch and bridge ports are assigned as either root or designated ports.D. All switch and bridge ports are in either the forwarding or blocking state.E. All switch and bridge are either blocking or looping.
考题
Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning－tree instance of vlan 1?()
A. the switch with the lowest MAC addressB. the switch with the higest MAC addressC. the switch witch the higest IP addressD. the switch with the lowest IP address
考题
Refer to the exhibit. The output that is shown is generated at a switch. Which three of these statements are true? ()
A.All ports will be in a state of discarding, learning, or forwarding.B.Thirty VLANs have been configured on this switch.C.The bridge priority is lower than the default value for spanning tree.D.All interfaces that are shown are on shared media.E.All designated ports are in a forwarding state.F.The switch must be the root bridge for all VLANs on this switch.
考题
Refer to the exhibit. Which statement is true?()
A.The Fa0/11 role confirms that SwitchA is the root bridge for VLAN 20.B.VLAN 20 is running the Per VLAN Spanning Tree Protocol.C.The MAC address of the root bridge is 0017.596d.1580.D.SwitchA is not the root bridge, because not all of the interface roles are designated.
考题
Refer to the exhibit. Why has this switch not been elected the root bridge for VLAN1?()
A.It has more than one interface that is connected to the root network segment.B.It is running RSTP while the elected root bridge is running 802.1d spanning tree.C.It has a higher MAC address than the elected root bridge.D.It has a higher bridge ID than the elected root bridge.
考题
Refer to the exhibit. Given the output shown from this Cisco Catalyst 2950, what is the most likely reason that interface FastEthernet 0／10 is not the root port for VLAN 2?()
A.This switch has more than one interface connected to the root network segment in VLAN 2.B.This switch is running RSTP while the elected designated switch is running 802.1d Spanning Tree.C.This switch interface has a higher path cost to the root bridge than another in the topology.D.This switch has a lower bridge ID for VLAN 2 than the elected designated switch.
考题
Refer to the exhibit. Based on the information given. Which switch will be elected root bridge and why?()
A.Switch A ,because it has the lowest MAC addressB.Switch C,because it has the lowest priorityC.Switch B,because it has the highest MAC addressD.Switch C,because it is the most centrally located switchE.Switch A,because it is the most centrally located switchF.Switch D,because it has the highest priority
考题
Refer to the exibit. Three cisco 2950 switches are set to their default priority sttings.During the spanningtree process,which switch will be elected as the root bridge?()
A.Switch3B.Switch4C.Switch2D.Switch1
考题
Refer to Topic TestKing.com in iPAD document.Which ports on TestKing3 are operating as trunks?（）A、Fa0/1B、Fa0/3C、Fa0/4D、Fa0/6E、Fa0/9F、Fa0/12
考题
Refer to Topic TestKing.com in iPAD document.What happens to the network when TestKingX is reconnected and a trunk exists between the two switches?（）A、All VLANs except the default VLAN will be removed from all switches.B、All existing switches will have the students, admin, faculty, Servers, Management,Production, and no-where VLANs.C、The VLANs Servers, Management, Production, and no-where will replace the VLANs on SwX.D、The VLANs Servers, Management, Production, and no-where will be removed from existing switches.
考题
Refer to the exibit. Three cisco 2950 switches are set to their default priority sttings.During the spanningtree process,which switch will be elected as the root bridge?（）A、Switch3B、Switch4C、Switch2D、Switch1
考题
Refer to the exhibit A frame on vlan 1on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?（）A、trunk mode mismatchesB、vlans that do not correspond to a unique IP subnetC、native vlan mismatchesD、allowing only vlan 2 on the destination.
考题
Refer to Topic TestKing.com in iPAD document.To which port of TestKing3 is router VLAN-R1 connected?（）A、Fa 0/1B、Fa 0/3C、Fa 0/6D、Fa 0/8E、Fa 0/9F、Fa 0/12
考题
Which statement is correct about RSTP port roles？（）A、The designated port is the switch port on every nonroot bridge that is the chosen path to theroot bridge. There can be only one designated port on every switch. The designated portassumes the forwarding state in a stable active topology. All switches connected to a given segment listen to all BPDUs and determine the switch that will be the root switch for a particular segment.B、The disabled port is an additional switch port on the designated switch with a redundant link to the segment for which the switch is designated. A disabled port has a higher port ID than the disabled port on the designated switch. The disabled port assumes the discarding state in astable active topology.C、The backup port is a switch port that offers an alternate path toward the root bridge. The backup port assumes a discarding state in a stable， active topology. The backup port will be present on nondesignated switches and will make a transition to a designated port if the current designated path fails.D、The root port is the switch port on every nonroot bridge that is the chosen path to the root bridge. There can be only one root port on every switch. The root port assumes the forwarding state in a stable active topology.
考题
Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?（）A、the switch with the lowest MAC addressB、the switch with the higest MAC addressC、the switch witch the higest IP addressD、the switch with the lowest IP address
考题
Refer to the output shown on switch SW1 below： VLAN 1 bridge priority set to 8192. VLAN 1 bridge max aging time set to 20.VLAN 1 bridge hello time set to 2. VLAN 1 bridge forward delay set to 15. Switch is now the root switch for active VLAN 1. What command would you enter to reproduce this output？
考题
单选题Refer to the exhibit A frame on vlan 1 on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?（）A
trunk mode mismatchesB
vlans that do not correspond to a unique IP subnetC
native vlan mismatchesD
allowing only vlan 2 on the destination.
考题
单选题Refer to Topic TestKing.com in iPAD document.Which switch is the root bridge for VLAN 1?（）A
TestKingDB
TestKing1C
TestKing2D
TestKing3
考题
单选题Refer to the exibit. Three cisco 2950 switches are set to their default priority sttings.During the spanningtree process,which switch will be elected as the root bridge?（）A
Switch3B
Switch4C
Switch2D
Switch1
考题
问答题Refer to the output shown on switch SW1 below： VLAN 1 bridge priority set to 8192. VLAN 1 bridge max aging time set to 20.VLAN 1 bridge hello time set to 2. VLAN 1 bridge forward delay set to 15. Switch is now the root switch for active VLAN 1. What command would you enter to reproduce this output？
考题
单选题Refer to Topic TestKing.com in iPAD document.To which port of TestKing3 is router VLAN-R1 connected?（）A
Fa 0/1B
Fa 0/3C
Fa 0/6D
Fa 0/8E
Fa 0/9F
Fa 0/12
考题
多选题Refer to Topic TestKing.com in iPAD document.Which ports on TestKing3 are operating as trunks?（）AFa0/1BFa0/3CFa0/4DFa0/6EFa0/9FFa0/12
热门标签
最新试卷