网友您好, 请在下方输入框内输入要搜索的题目:

题目内容 (请给出正确答案)
Refer to the exhibit. What is required to complete the IPv6 routing configurations shown?()

A. Interface authentication must be configured

B. The routing processes must be configured with an area ID

C. IP unicast routing must be enabled

D. IPv4 ad dresses must be applied to the interfaces


参考答案

更多 “ Refer to the exhibit. What is required to complete the IPv6 routing configurations shown?() A. Interface authentication must be configuredB. The routing processes must be configured with an area IDC. IP unicast routing must be enabledD. IPv4 ad dresses must be applied to the interfaces ” 相关考题
考题 What does the SRP distribute to the line modules when a routing table changes?() A.updated RIB-OutB.link-state informationC.an incremental updateD.the complete routing table

考题 Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?()A. Network BB. Network A and Network BC. Network AD. neither Network A nor Network B

考题 Refer to the exhibit. R1 and R2 have been configured to share routing information via EIGRP. What will be the result of the configuration section shown for R2? () A. Any routes learned by R2 from the interface tied to the 172.16.0.0 network will not be advertised to neighbors on the 192.168.2.0 network.B. Only routes learned by R2 from the interface tied to the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network.C. Only the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network.D. All networks, except the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network .

考题 Refer to the exhibit. Which statement about dynamic routing protocols for this network is true? () A.No dynamic interior routing protocol can summarize as shownB.Unless configured otherwise, EIGRP would automatically summa rize the prefixes as shown in the exhibitC.With this IP addressing scheme, EIGRP can be manually configured to summarize prefixes at the specified summarization pointsD.The IP address design lends itself to OSPF Each summarizing router would be an ABR, summarizing to the next area in the address hierarchy

考题 Refer to the exhibit. The partial configuration for an OSPF ASBR and an Area 0 ABR is shown. Assume the OSPF configurations throughout the network are operable. Which statement about these configurations is true? ()A. The ASBR route - maps are basically useless, because there are no deny prefix - lists.B. LSA Type 5s wil l not be received by the ABR from the ASBR.C. The OSPF backbone will not learn any RFC 1918 addresses.D. The matched prefix - list addresses will be given a metric of 255, which is essentially unreachable.

考题 Refer to the exhibit. A partial routing configuration is shown. Complete the configuration so that only the default - network is redistributed from EIGRP 190 into EIGRP 212. Which ACL statement completes the configuration correctly? ()A. access - list 100 permit ip 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0 .0B. access - list 100 permit ip host 0.0.0.0 anyC. access - list 100 permit ip any host 0.0.0.0D. A default -network cannot be redistributed between routing processes.

考题 Refer to the exhibit. Looking at the topology diagram and the partial router configurations shown, which statement is true? () A.The NProuter has two OSPF neighbors in the Full adjacency stateB.The NProuter serial0/0 interface has the OSPF dead timer set to 10 secondsC.The NProuter serial0/0 interface has been configured with an OSPF network type of pointtopointD.The 10.1.1.1 and 10.1.1.2 routers are not using the default OSPF dead and hello timers settingE.The Mismatched error is caus ed by the expiration of the OSPF timers

考题 Refer to the exhibit. When you examine the routing table of R1 and R4, you are not able to see the R1 Ethernet subnet on the R4 routing ta ble. You are also not able to see the R4 Ethernet subnet on the R1 routing table.Which configuration change should be made to resolve this issue? Select the routers where the configuration change will be required, and select the required EIGRP configur ation command(s).()A. R1 and R4B. R2 and R3C. ip summary-address eigrp 1 10.1.1.0 255.255.255.0 and ip summary - address eigrp 110.2.2.0 255.255.255.0D. variance 2E. eigrp stub connectedF. no auto - summary

考题 Refer to the parti al configurations in the exhibit. What address is utilized for DR and BDR identification on Router1?() A. the serial 1/1 addressB. the serial 2/0 addressC. a randomly generated internal addressD. the configured router - id address

考题 Refer to the exhibit. On the basis of the output, what two conclusions can be reached?() A. The default administrative distance has been changed.B. IS - IS is not enabled.C. Three physical interfaces are taking part in integrated IS - IS.D. IS - IS is not redistributing any oth er routing protocols.E. There are two neighboring routers sending IS - IS routing information.F. Address summarization is configured.

考题 Refer to the exhibit. What three statements are true about the IS - IS configuration?() A.The router is in area 49.0001.0002B.The router acts as a Level 1 - 2 routerC.CLNS routing is enable d for the routerD.The router has a system ID of 0003.0004E.The interfaces have a functional IS - IS configurationF.The network service access point selector (NSEL) byte has a value of 0

考题 Refer to the exhibit. Which two statement s are correct?() A. All the routes were redistributed into BGP from an IGPB. All the routes were originated by BGP with the network commandC. All six routes will be installed in the routing tableD. Four routes will be installed in the routing ta bleE. Two routes will be installed in the routing table

考题 Refer to the exhibit. What is the most appropriate summarization for these routes?() A.10.0.0.0/21B.10.0.0.0/22C.10.0.0.0/23D.10.0.0.0/24

考题 Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?() A.data link layerB.application layerC.access layerD.session layerE.network layer

考题 Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with RouterC?()A、As numbers must be changed to match on all the routers.B、Loopback interface must be configured so a DR is elected.C、The no auto-summary command is needed on Router A and Router C.D、Router B needs to have two network statements, one for each connected network.

考题 Refer to the exhibit.   What are three of the basic components of a VoIP network?()A、software voice applicationsB、multipoint control unit (MCU)  C、gatekeeper  D、call agentE、interactive voice response (IVR) systems  F、softphones

考题 What does the SRP distribute to the line modules when a routing table changes?()A、updated RIB-OutB、link-state informationC、an incremental updateD、the complete routing table

考题 Refer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?()A、The Serial0/0 interface is passing traffic.B、The DLCI 100 was dynamically allocated by the routerC、The Serial0/0 interface acquired the IP address of 172.16.3.1 from a DHCP serverD、The DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloudE、The mapping between DLCI 100 and the end station IP address 172.16.3.1 was learned through Inverse ARP

考题 多选题Refer to the exhibit. Which two statements are correct? (Choose two.)()AAll six routes will be installed in the routing table.BTwo routes will be installed in the routing table.CFour routes will be installed in the routing table.DAll the routes were redistributed into BGP from an IGP.EAll the routes were originated by BGP with the network command.

考题 单选题Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?()A data link layerB application layerC access layerD session layerE network layer

考题 单选题Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with RouterC?()A As numbers must be changed to match on all the routers.B Loopback interface must be configured so a DR is elected.C The no auto-summary command is needed on Router A and Router C.D Router B needs to have two network statements, one for each connected network.

考题 多选题Refer to the exhibit. Which two statements are correct?()AAll six routes will be installed in the routing tableBTwo routes will be installed in the routing tableCFour routes will be installed in the routing tableDAll the routes were redistributed into BGP from an IGPEAll the routes were originated by BGP with the network command

考题 单选题Refer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?()A The Serial0/0 interface is passing traffic.B The DLCI 100 was dynamically allocated by the routerC The Serial0/0 interface acquired the IP address of 172.16.3.1 from a DHCP serverD The DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloudE The mapping between DLCI 100 and the end station IP address 172.16.3.1 was learned through Inverse ARP

考题 单选题What does the SRP distribute to the line modules when a routing table changes?()A updated RIB-OutB link-state informationC an incremental updateD the complete routing table

考题 多选题Refer to the exhibit.   What are three of the basic components of a VoIP network?()Asoftware voice applicationsBmultipoint control unit (MCU)CgatekeeperDcall agentEinteractive voice response (IVR) systemsFsoftphones

考题 单选题Refer to the exhibit. Given the DHCP pool configuration shown on Router A, the Cisco IP phone will not boot up in the Teleworker location. What is missing from the Teleworker DHCP pool configuration?()A The DHCP pool needs to have an import all statement. B The DHCP pool is missing an option 150 ip 10.59.138.1 statement.C The DHCP pool is missing an option 139 ip 10.59.138.1 statementD The DHCP pool is missing a dns-server 10.59.138.1 statement.

考题 单选题What is required to complete this form?A Government authorizationB An identification photoC Proof of employmentD A separate instructional booklet