网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
问答题
In a run sparse-dense-mode multicast network， when rendezvous point down ， will the recipient receive the packets send by the source？why？
参考答案
参考解析
解析：
暂无解析
更多 “问答题In a run sparse-dense-mode multicast network， when rendezvous point down ， will the recipient receive the packets send by the source？why？” 相关考题
考题
Refer to the exhibit. IP multicast for group address 224.1.1.1 has been enabled on all router s in the network. Hosts on Network A receive the multicast traffic. However, hosts on Network B do not. On the basis of outputs provided, what could be the cause of the problem? （）A. The route to 224.69.15.0/24 will be out Ethernet 0B. The reverse path forwarding (RPF) for the route 224.2.0.1 failed to find the interface on which the multicast packet was rece ivedC. Multicast route to 224.69.15.0/24 was added to the mroute table and created by a source directly connected to the routerD. Multicast route to 10.16.0.0/16 was added to the mroute table and created by a source directly connected to the routerE. This router received an IGMP host report from a group member or a PIM join message
考题
What is an important step to take when verifying a newly proposed network security solution？ （）A、Test the design on a pilot network for expected results prior to implementing on the production network.B、Run a network audit to determine types of traffic in use on the network.C、Launch campus updates into the production network and monitor impact to see if configuration changes are needed.D、Create an interruption of data flow to determine test "back-door" access methods.
考题
When designing the Network Admission Control （NAC） Appliance for the Enterprise Campus Network， which of the following requirements would help the designer to narrow down the NAC choices， from Virtual Gateway to Real IP Gateway， or from In-band to Out-band？（）A、 QoS ToS/DSCP values are required to be forwarded transparentlyB、 Device redundancy is requiredC、 Per-user ACL support is requiredD、 Multicast service support is required
考题
Which two statements are tru e about the rendezvous point (RP) in a multicast network?（）A、The multicast sources must register with the RP to form the multicast distribution treeB、An RP is required only in networks running Protocol Independent Multicast dense mode ( PIM DM)C、The multicast receivers must register with the RP to form the multicast distribution treeD、An RP is required only in networks running Protocol Independent Multicast sparse mode (PIM SM)E、An RP is required only in networks running Pro tocol Independent Multicast sparse - dense mode (PIM - SDM)F、To form the multicast distribution tree, the multicast sources register with and the receivers join the RP
考题
Which two restrictions must the Enterprise Campus network designer consider when evaluatingWAN connectivity options？ （）A、 OSPF over multicast EMS or VPLS network may not have consistent broadcast or multicastperformanceB、 IP multicast is not supported over Lover 3 MPLS VPN； instead a Layer 2 MPLS WN must beutilized with service provider supportC、 QoS requirements with MPLS-VPN must be implemented by the service providerD、 Hierarchical VPLS designs are the least scalableE、 IGMP snooping is not on option with VPLS or EMS； instead administrative scoping or allowingsufficient bandwidth for unnecessary multicast traffic at the edge links is required
考题
Multicast is being deployed in the network， and only ip pim sparse-dense mode has been configured on all interfaces in the network to support a new video streaming application. No other multicast configuration was applied anywhere in the network. Since enabling multicast， the network monitoring tools show periodic spikes in link utilization throughout the network， even in areas where the video application is not being used. What could be a possible cause？（）A、PIM sparse mode is being used.B、PIM dense mode is being used.C、The BGP multicast address family has not been configured.D、IGMP version 3 is being used.E、IP PIM neighbor filters have not been applied.
考题
In a run sparse-dense-mode multicast network， when rendezvous point down ， will the recipient receive the packets send by the source？why？
考题
What is the purpose of a rendezvous point (RP)?（）A、acts as a meeting place for sources and receivers of multicast trafficB、used in PIM dense m ode to create a database of all multicast sourcesC、used in PIM dense and sparse mode to create a database of all multicast sourcesD、acts as the designated router for a broadcast segment when multicast routing is enabled
考题
Which three statements are true about Source Specific Multicast？（）A、Is best suited for applications that are in the one-to-many category.B、SSM uses shortest path trees only.C、The use of SSM is recommended when there are many sources and it is desirable to keep the amount of mroute state in the routers in the network to a.D、There are no RPs to worry about.
考题
Which two of these are characteristics of multicast routing？ （）A、 multicast routing uses RPFB、 multicast routing is connectionless.C、 In multicast routing， the source of a packet is known.D、 When network topologies change， multicast distribution trees are not rebuilt， but use the originalpathE、 Multicast routing is much like unicast routing， with the only difference being that it has a a groupof receivers rather than just one destination
考题
Which three IP multicast related statements are true？ （Choose three.） （）A、 Multicast addresses 224.0.1.0 through 238.255.255.255 are called globally scoped addresses. They are used to multicast data between organizations and across the InternetB、 The multicast address 224.0.0.1 is a globally scoped address that has been reserved for the Network Time Protocol （NTP） by the IANAC、 Multicast addresses 239.0.0.0 through 239.255.255.255 are called limited scope addresses. They are constrained to a local group or organizationD、 Multicast addresses 224.0.0.5 and 224.0.0.6 are limited scoped addresses that have been reserved for OSPFE、 Multicast addresses 224.0.0.0 through 224.0.0.255 are used for network protocols on local LAN segments. Because they are always transmitted with a Time to Live （TTL） of 1， they are never forwarded by a router
考题
What is the benefit of using Anycast RP via RFC 4610 for IP multicast RP redundancy？（） A、 Improves convergence of the multicast network due to enhanced RPF checksB、 Simplifies the number of control plane protocols over other RP redundancy methodsC、 Eliminates the use of Protocol Independent Multicast （PIM） in the topologyD、 Increases the administrative distances in Multicast Source Discovery Protocol （MSDP） configuration
考题
A small office in which all workstations are using an ISP provided IP range has noticed a consistent decrease in network traffic speed. The decrease does not occur when the gateway to the ISP is disconnected. Which of the following should the administrator implement?（） A、Multicast addressingB、Load balancingC、Address translationD、DHCP
考题
When the length of the run queues， process or thread dispatches interrupts， and lock contention metrics and statistics are analyzed for performance， which of the following resources is being analyzed？（）A、 CPUB、 MemoryC、 Disk I/OD、 Network I/O
考题
Company.com is adding a new I/O drawer to an existing p5-570 with four LPARs and wants to re-balance the network cards in the I/O drawers. What is the best way to accomplish this？（）A、Add the devices as virtual adapters to a VIO server first,then add the I/O drawer and create the shared ethernet adaptersB、Power down the partitions,run the diag a command when the system is brought back up and reconfigure the network cardsC、Use the rmdev command to remove the devices,shut down the partitions and move the cads,then run the cfgmgr command after rebootD、Detach the network cards,run rmdev on the devices and then dynamically reassign theadapters to the partitions and reconfigure
考题
多选题When HSRP is configured on a network, which two of these items are provided, which are shared between the routers that run HSRP ?（） (choose two)AShared single interfaceBIP AddressCTCP-based hello packetsDMAC address
考题
单选题When designing the Network Admission Control （NAC） Appliance for the Enterprise Campus Network， which of the following requirements would help the designer to narrow down the NAC choices， from Virtual Gateway to Real IP Gateway， or from In-band to Out-band？（）A
QoS ToS/DSCP values are required to be forwarded transparentlyB
Device redundancy is requiredC
Per-user ACL support is requiredD
Multicast service support is required
考题
单选题Your network contains a single Active Directory domain. All servers run Windows Server 2008 R2. You deploy a new server that runs Windows Server 2008 R2. The server is not connected to the internal network. You need to ensure that the new server is already joined to the domain when it first connects to the internal network. What should you do（）A
From a domain controller， run sysprep.exe and specify the /oobe parameter. From the new server， run sysprep.exeB
From a domain controller， run sysprep.exe and specify the /generalize parameter. From the new server， run syspreC
From a domain-joined computer， run djoin.exe and specify the /provision parameter. From the new server， run djoinD
From a domain-joined computer， run djoin.exe and specify the /requestodj parameter. From the new server， run djo
考题
单选题When the length of the run queues， process or thread dispatches interrupts， and lock contention metrics and statistics are analyzed for performance， which of the following resources is being analyzed？（）A
CPUB
MemoryC
Disk I/OD
Network I/O
考题
单选题When using Overlay Transport Virtualization （OTV）， how do L2 multicast frames traverse the overlay？（）A
The L2 multicast frames are encapsulated in an OTV packet using the configured control-group multicast address for transportB
The L2 multicast frames are dropped because multicast cannot be carried across the overlay C
The L2 multicast frames are encapsulated in an OTV packet using the configured data-group multicast address for transportD
The L2 multicast frames are forwarded natively across the overlay based on their multicast IDs
考题
单选题A customer is purchasing a 12-way p5-570 to run light development workloads on eight AIX 5.3 partitions with two network adapters each. When the current network configuration was reviewed， it was discovered that they only have four Ethernet ports available on their network switch. Which of the following solutions would prevent them from having to buy another network switch or hub？（）A
Add two HMCs with two Ethernet adapters each and run EtherChannel for the original eight partitions.B
Add two HMCs with two Ethernet adapters each and run Virtual Ethernet for the original eight partitions.C
Add two hosting partitions with two Ethernet adapters each and run EtherChannel for the original eight partitions.D
Add two hosting partitions with two Ethernet adapters each and run Virtual Ethernet for the original eight partitions.
考题
多选题Which two restrictions must the Enterprise Campus network designer consider when evaluatingWAN connectivity options？ （）AOSPF over multicast EMS or VPLS network may not have consistent broadcast or multicastperformanceBIP multicast is not supported over Lover 3 MPLS VPN； instead a Layer 2 MPLS WN must beutilized with service provider supportCQoS requirements with MPLS-VPN must be implemented by the service providerDHierarchical VPLS designs are the least scalableEIGMP snooping is not on option with VPLS or EMS； instead administrative scoping or allowingsufficient bandwidth for unnecessary multicast traffic at the edge links is required
考题
问答题On a multicast environment， what is process for installing and run an application on host？
考题
多选题Which two multicast protocol statements are true?（）ASparse mode multicast uses a pull model to send multicast traffic to where it is requestedBDense mode multicast uses a push model to flood traffic throughout the network and then prunes the unwanted trafficCDense mode multicast requires explicit join messa ges from their membersDSparse mode uses reverse path forwarding (RPF) to prune off redundant flowsEThe primary use of sparse mode multicast is for test labs and router performance testing
热门标签
最新试卷