网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
What is the purpose of IS-IS level boundaries?（）
- A、Restrain the formation of adjacencies.
- B、Control the flooding scope of link-state PDUs.
- C、Partition the L2 backbone into multiple domains.
- D、Aggregate L1 domains into a contiguous backbone.
参考答案
更多 “What is the purpose of IS-IS level boundaries?（）A、Restrain the formation of adjacencies.B、Control the flooding scope of link-state PDUs.C、Partition the L2 backbone into multiple domains.D、Aggregate L1 domains into a contiguous backbone.” 相关考题
考题
What are two requirements when using AppFlow?（） (Choose two.)A、Quality of service must be enabled.B、NSC compression must be enabled.C、PFA's TCP Acceleration (AFP) must be enabled.D、AppFlow must be configured on the client-side device first.
考题
Two Level 1 routers are exchanging Hello packets with different Area IDs.What occurs between these routers?（）A、An Adjacency is formed.B、No IS-IS PDUs are sentC、An Adjacency does not form.D、An Adjacency forms but traffic is not forwarded.
考题
An OSPF non-backbone area follows external routes to be flooded within the area. These external routes are propagated into other areas. However， external routes from other areas are not allowed to enter this area. Which type of OSPF area does this describe？（）A、stub areaB、transit areaC、border areaD、not-so-stubby area
考题
A users Junos Pulse client uses 802.1X to access a wired network and is failing to authenticate. You run a packet capture from the users PC and notice that immediately after the client machine sends an EAPoL-start packet, an EAP-failure packet is returned. You review the RADIUS troubleshooting logs on the MAG Series device and do not see any authentication attempts from the user. Other users on the same Ethernet switch are successfully authenticating. Which device is sending the EAP-failure packet to the workstation?（）A、The RADIUS serverB、The EAPoL serverC、The workstation's network adapterD、The Ethernet switch
考题
Which configuration command sets the MPLS interface bandwidth to 15 Mbps?（）A、set bandwidth 15B、mpls bandwidth 15C、set bandwidth 15000D、mpls bandwidth 15000
考题
By default, if equal-cost paths exist for the same destination, which action will the router take?（）A、Drop half the traffic.B、Make a copy of the traffic and send it to both destinations.C、Load-balance traffic between the available paths.D、Randomly select one of the available paths to send traffic.
考题
Which statement describes a security zone?（）A、A security zone can contain one or more interfaces.B、A security zone can contain interfaces in multiple routing instances.C、A security zone must contain two or more interfaces.D、A security zone must contain bridge groups.
考题
The output of the show aaa domain-map displays the following information: Domain: isp1.com; virtual-router: vr1; loopback: 1 Domain: isp2.com; virtual-router: vr2; loopback: 1 Domain: none; virtual-router: vr3; loopback: 1 Domain: default; virtual-router: vr4; loopback: 1 The end user supplies a login name of joe@isp7.com . Which virtual router is responsible for authenticating this user?（）A、vr1B、vr2C、vr3D、vr4
考题
Which command would you type to see a concise display of which interfaces are up and which are down?（）A、show interfaces briefB、show interfaces statusC、show ip interface briefD、show interfaces terse
考题
When using a 40 Gbps switch fabric,how much full duplex bandwidth is available to each slot?（）A、1.25GbpsB、1.65GbpsC、2.55GbpsD、5.00Gbps
考题
What are three terminating actions for firewall filters?（）A、rejectB、dropC、permitD、acceptE、discard
热门标签
最新试卷