网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
Which three should be documented after upgrading a SCSI RAID controller？（）
- A、 disk utilization
- B、 installation date
- C、 adapter baselines
- D、 location slot of the RAID controller
- E、 status of the adapter card installation
- F、 RAID controller information （warranty， specifications etc.）
参考答案
更多 “Which three should be documented after upgrading a SCSI RAID controller？（）A、 disk utilizationB、 installation dateC、 adapter baselinesD、 location slot of the RAID controllerE、 status of the adapter card installationF、 RAID controller information （warranty， specifications etc.）” 相关考题
考题
You have a print server named Server1 that runs Windows Server 2003 Service Pack (SP2). Server1 isconfigured as shown in the following table.All the hard disks are 136 GB and are connected to a SCSI controller.You need to identify which disk configuration will provide the best performance for printing.Which disk configuration should you implement? （）A. one RAID-0 volumeB. one RAID-1 volumeC. one RAID-5 volumeD. two RAID-1 volumes
考题
A server has six drives of equal size attached to a RAID controller. Which of the following RAID levels would provide the FASTEST performance?()
A. RAID 5B. RAID 1+0C. RAID 0D. RAID 1
考题
A server consists of two 72GB SCSI drives and four 146GB SCSI drives. All drives are attached to a RAID controller. The system administrator has decided to configure all six drives in a RAID 5 array.How much usable disk space will this array have?（）A.288GBB.360GBC.432GBD.728GB
考题
A server has six drives of equal size attached to a RAID controller. Which of the following fault tolerant RAID levels would allow the maximum amount of data to be stored?()
A. RAID 1 +0B. RAID 5C. RAID 0D. RAID 1
考题
You are the network administrator for Ezonexam.com.You need to upgrade a computer from Windows NT Server 4.0 to Windows 2000 server. The server has dual processors, 2 GB of RAM, a RAID controller with five SCSI hard disks in an array, and a generic 10/100-MB network adapter. You begin the installation of the Windows 2000 Server operating system.During the text portion of the installation, you receive the following error message:"Stop 0x00000078 Inaccessible_boot_device."You want to successfully upgrade the computer.What should you do? (Each answer presents part of the solution. Choose two)A．Start the computer by using a DOS disk and run FDISK.B．Update the firmware on the RAID controller.C．Restart the installation. During the text-mode setup-mode setup, press F6.D．Restart the installation. During the text-mode setup, create a new partition.E．Insert a floppy disk containing the OEM SCSI driver and specify the additional driver.
考题
An administrator recently installed a known good RAID adapter. During boot up， the administrator is able to access the RAID configuration utility； however， when the administrator checks for the card in the operating system， it does not show up. Which of the following should the administrator do FIRST？（）A、Move the RAID adapter to another slot.B、Perform a baseline of the system.C、Contact the reseller of the adapter for a replacement card.D、Check the RAID adapter’s manufacturer for the latest drivers.
考题
You plan to install Windows 7 on a computer that contains a single hard disk drive. The hard disk drive isconnected to a RAID controller. During the installation, you discover that the Windows 7 installation mediadoes not include the files required to install the RAID controller. You need ensure that you can installWindows 7 on the hard disk drive. What should you do?（）A、Insert the Windows installation media and press F8 during the computer s power-on self test (POST).B、Insert the Windows installation media and press F6 during the computer s power-on self test (POST).C、Start the computer from the Windows installation media. From the Install Windows dialog box, click Load Driver.D、Start the computer from the Windows installation media. From the Install Windows dialog box, click Drive options (advanced).
考题
An administrator just installed a new RAID controller card into a server. The firmware is current for the controller card. When the server is powered up the administrator notices that the RAID controller card is not recognized during POST. Which of the following is the cause of the problem？（）A、The hard drives were not plugged into the server correctly.B、The controller driver is outdated and needs to be updated from the OEMs website.C、The firmware for the server is too old and does not support the new RAID controller card.D、The cable from the controller to the hard drive backplane is not connected.
考题
A server has six drives of equal size attached to a RAID controller. Which of the following RAID levels would provide the FASTEST performance？（）A、 RAID 5B、 RAID 1+0C、 RAID 0D、 RAID 1
考题
Before installing a firmware update on a RAID controller which of the following should be done？（）A、 Check for corresponding driver updates.B、 Rebuild any arrays on the controller.C、 Check for corresponding OS updates.D、 Install a redundant BIOS on the controller.
考题
Which of the following RAID arrays should be used to achieve the MOST performance？（）A、 Four drives with RAID 0B、 Three drives with RAID 5C、 Four drives with RAID 10D、 Two drives with RAID 50
考题
A server has six drives of equal size attached to a RAID controller. Which of the following fault tolerant RAID levels would allow the maximum amount of data to be stored?（）A、RAID 1 +0B、RAID 5C、RAID 0D、RAID 1
考题
A technician needs to install the first SCSI controller in an application server. The SCSI card is factory-configured with a SCSI ID of 1. Which SCSI ID should the technician configure the card before installation？（）A、 0B、 1C、 4D、 7
考题
A server consists of two 72GB SCSI drives and four 146GB SCSI drives. All drives are attached to a RAID controller. The system administrator has decided to configure all six drives in a RAID 5 array. How much usable disk space will this array have?（）A、288GBB、360GBC、432GBD、728GB
考题
A company installed a new server to manage its electronic image storage. They have two distinct image sizes： 2KB and 16KB. Two distinct arrays are created on a ServeRAID adapter. The first array will store all of the 2KB images， and the second array will store all the 16KB images. The RAID stripe size was left at the default size of 8KB. After installation， a performance problem is identified. According to performance monitoring， 80% of the images are 16KB. Which of the following will best optimize performance？（）A、Change the stripe size on the RAID controllerB、Change the stripe size to 1024K on the RAID controllerC、Change the stripe size on the RAID controller for the first arrayD、Change the stripe size on the RAID controller for the second array
考题
A distribution customer requires a fault-tolerant disk subsystem for their x3650 M2 server. They purchased and attached two EXP3000 External Expansion Enclosures to a ServerRAID MR10M RAID controller. The customer requires the highest performance possible， regardless of cost for the EXP-based drives. Which RAID level meets these requirements？（）A、RAID-1B、RAID-5C、RAID-10D、RAID-50
考题
A server has two PCI-X buses with four Active PCI-X slots. Slots 1 and 2 are on the first PCI-X bus （100MHz） and slots 3 and 4 are on the second PCI-X bus （133MHz）. The customer requires you to install adapter A and adapter B on day one. After the server has been installed and configured， the server must be running 24 by 7 with no downtime. Three months later， adapter C needs to be hot added. All the adapters are 64-bit and capable of speeds up to 133MHz. The customer’s priority is to have no downtime， and performance is secondary. Based on the information provided， into which slots should adapters A and B be installed in and later into which slot would adapter C be hot-added？（）A、Adapter A in slot 1， adapter B in slot 4 and hot-add adapter C in slot 3B、Adapter A in slot 1， adapter B in slot 3 and hot-add adapter C in slot 2C、Adapter A in slot 2， adapter B in slot 4 and hot-add adapter C in slot 3D、Adapter A in slot 3， adapter B in slot 1 and hot-add adapter C in slot 4
考题
You are configuring a virtual machine （VM） that is running on a Windows Server 2008 R2 host server. The primary virtual disk is connected to IDE Controller 0. You need to add a virtual disk to the VM without shutting down the VM. What should you do？（）A、Add the virtual disk to IDE Controller 0.B、Add the virtual disk to IDE Controller 1.C、Add the virtual disk to an existing SCSI controller.D、Add a virtual network adapter to the VM. Attach an iSCSI disk to the VM through the virtual network adapter.
考题
You are a professional level SQL Sever 2008 Database Administrator in an international corporation named Wiikigo. You are experienced in managing databases in an enterprise-level organization, optimizing and sustaining the database life cycle. In the company, your job is to implement solutions on security, troubleshooting, deployment and optimization. A SQL Server 2008 instance is managed by you. A new database should be deployed, and the capacity requirements listed below should be satisfied. There should be 275 GB for the database data file, while there should be 50 GB for the transaction log file. There are six 100-GB disk drives which are accessible for the database in the storage array. The six disks are attached to a redundant array of independent disks (RAID) controller, and the controller supports RAID levels 0, 1, 5, and 10. Since you are the technical support, you are required to maximize the write performance of the transaction log. In addition, you should protect the database and transaction log files, when a drive fails. The storage system should be designed. From the following four storage configuration, which one should you utilize?（）A、A single RAID 5 volume should be utilized. B、A RAID 1 volume and a RAID 5 volume should be utilized.C、A single RAID 10 volume should be utilized. D、A RAID 0 volume and a RAID 5 volume should be utilized.
考题
Which of the following hardware components is necessary for a server to access data directly on afiber channel based SAN？（）A、Gigabit NICB、RAID controller cardC、SATA controller cardD、Host bus adapter
考题
多选题Which three should be documented after upgrading a SCSI RAID controller？（）Adisk utilizationBinstallation dateCadapter baselinesDlocation slot of the RAID controllerEstatus of the adapter card installationFRAID controller information （warranty， specifications etc.）
考题
单选题Before installing a firmware update on a RAID controller which of the following should be done？（）A
Check for corresponding driver updates.B
Rebuild any arrays on the controller.C
Check for corresponding OS updates.D
Install a redundant BIOS on the controller.
考题
单选题An administrator just installed a new RAID controller card into a server. The firmware is current for the controller card. When the server is powered up the administrator notices that the RAID controller card is not recognized during POST. Which of the following is the cause of the problem？（）A
The hard drives were not plugged into the server correctly.B
The controller driver is outdated and needs to be updated from the OEMs website.C
The firmware for the server is too old and does not support the new RAID controller card.D
The cable from the controller to the hard drive backplane is not connected.
考题
单选题A server has six drives of equal size attached to a RAID controller. Which of the following fault tolerant RAID levels would allow the maximum amount of data to be stored？ （）A
RAID 1+0B
RAID 5C
RAID 0D
RAID 1
考题
单选题A server consists of two 72GB SCSI drives and four 146GB SCSI drives. All drives are attached to RAID controller. The system administrator has decided to configure all six drives in a RAID 5 array. How much usable disk space will this array have？（）A
288GBB
360GBC
432GBD
728GB
考题
单选题A server has six drives of equal size attached to a RAID controller. Which of the following RAID levels would provide the FASTEST performance？（）A
RAID 5B
RAID 1+0C
RAID 0D
RAID 1
考题
单选题Which of the following RAID arrays should be used to achieve the MOST performance？（）A
Four drives with RAID 0B
Three drives with RAID 5C
Four drives with RAID 10D
Two drives with RAID 50
热门标签
最新试卷