网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
A router has two FastEthernet interfaces and needs to connect to four vlans in the local network.How can you accomplish this task,using the fewest physical interfaces and without decreasing network performance?（）
- A、Add two more FastEthernet interfaces.
- B、Add a second router to handle the vlan traffic.
- C、Use a hub to connect the four vlans with a FastEthernet interface on router.
- D、Implement a router-on-a-stick configuration.
参考答案
更多 “A router has two FastEthernet interfaces and needs to connect to four vlans in the local network.How can you accomplish this task,using the fewest physical interfaces and without decreasing network performance?（）A、Add two more FastEthernet interfaces.B、Add a second router to handle the vlan traffic.C、Use a hub to connect the four vlans with a FastEthernet interface on router.D、Implement a router-on-a-stick configuration.” 相关考题
考题
阅读路由器Router的部分配置信息，解释(5)～(7)处的命令，将答案填写在答题纸上相应的位置。Router(config)interface fastEthernet1/0.1Router(config-subif)encapsulation isl 11 (5)Router(config-subif)ip addreSs 192.168.1.1 255.255.255.240 (6)Router(config-subif)exitRouter(config)interface fastEthernet1/0.2Router(config-subif)encapsulation isl 12Router(config-subif)ip address 192.168.1.33 255.255.255.224Router(config-subif)exitRouter(config)interface fastEthernet1/0.3Router(config-subif)encapsulation isl 13Router(config-subif)ip address 192.168.1.129 255.255.255.192Router(config-subif)exitRouter(config)ip routing (7)
考题
Which two conditions, when met, allow an IS－IS Level 2 router to be considered attached?()
A. You can reach other Level 2 routers.B. It can reach at least one other defined area.C. The router is reachable by at least two ES-IS nodes.D. It has at least one enabled reachable prefix with a valid metric defined.
考题
Refer to the exhibit. Which two statements are true about the partial configuration that is shown? ()
A. The first DHCP client to connect to the FastEthernet 0/1 interface will receive the IP address 10.10.0.1.B. DHCP requests received on the FastEthernet 0/1 interface will be forwarded to 10.0.0.2.C. The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP a ddress 10.0.0.1D. The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address 10.0.0.6.E. Hosts connected to the FastEthernet0/1 interface will not receive DHCP replies from the router.
考题
Refer to the exhibit. What two statements are true?()
A. This is the designated router (DR) on the FastEthernet 0/0 link.B. The output was generated by the show ip interface c ommand.C. The router was configured with the commands:r outer ospf 1 network 172.16.6.0 0.0.0.255 area 1D. The IP address of the backup designated router (BDR) is FE80::205:5FFF:FED3:5808.E. Interface FastEthernet 0/0 was configured with the ipv6 o spf 1 area 1 command.F. OSPF version 2 has been enabled to support IPv6.
考题
A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?（）A. oneB. threeC. twoD. zero
考题
Which two commands correctly verify whether port security has been configured on port FastEthernet 0／12 on a switch?()
A. SW1#show swithport port-security interface FastEthernet 0/12B. SW1# show swithport port-secure interface FastEthernet 0/12C. SW1# show port-secure interface FastEthernet 0/12D. SW1#show running-configE. SW1#show port-security interface FastEthernet 0/12
考题
Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? ()
A.Router1 has specific boot system command that instruct it to load IOS from TFTP server.B.Router1 is acting as a TFTP server for other routers.C.Router1 cannot locate a valid IOS image in flash memory.D.Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.E.Cisco routers will first attempt to load a image from TFTP for management purposes.
考题
Which two commands correctly verify whether port security has been configured on port FastEthernet0/12 on a switch？（）A、SW1#shows withport port-security interface FastEthernet0/12B、SW1#shows withport port-secure interface FastEthernet0/12C、SW1#show port-secure interface FastEthernet0/12D、SW1#show running-config
考题
A company has a Frame Relay WAN with one central - site router and 100 branch office routers. A partial mesh of PVCs exists: one PVC between the central site and each of t he 100 branch routers. All routers use point - to - point subinterfaces and one subnet per PVC. Which of the following is true about OSPF in this design?（）A、The central site router has 100 fully adjacent neighborships with the 100 branchesB、The central site router has neighborships with all branch routers, but fully adjacent neighbors with only two branchesC、The central site router has a neighborship with the Frame Relay switcHD、None of the other answers is correct
考题
A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）A、For the two vlans to communicate，a network statement for the trunk interface needs to be added to the OSPF configuration.B、For the two vlans to communicate， a network statement for each subinterface needs to be added to the OSPF configuration.C、Direct inter-vlan communication does not require OSPFD、OSPF cannot be used if router-on-a-stick is configured on the router
考题
Which two commands correctly verify whether port security has been configured on portFastEthernet 0/12on a switch？（）A、SW1#show swithport port-security interface FastEthernet 0/12B、SW1# show swithport port-secure interface FastEthernet 0/12C、SW1# show port-secure interface FastEthernet 0/12D、SW1#show running-config
考题
Router R1 and R2 are both configured for HSRP. Which two statements about the HSRP priorities of these two routers are true？（）A、 To assign the HSRP router priority in a standby group， the standby group-number priority priority-value global configuration command must be used.B、 The default priority of a router is zero （0）.C、 The no standby priority command assigns a priority of 100 to the router.D、 Assuming that preempting has also been configured， the router with the lowest priority in an HSRP group would become the active router.E、 When two routers in an HSRP standby group are configured with identical priorities， the router with the highest configured IP address will become the active router.
考题
Which two commands correctly verify whether port security has been configured on port FastEthernet 0/12 on a switch？（）A、SW1#show swithport port-security interface FastEthernet 0/12B、SW1# show swithport port-secure interface FastEthernet 0/12C、SW1# show port-secure interface FastEthernet 0/12D、SW1#show running-configE、SW1#show port-security interface FastEthernet 0/12
考题
Which two commands correctly verify whether port security has been configured on port FastEthernet 0/12 on a switch?（）A、SW1#show swithport port-security interface FastEthernet 0/12B、SW1# show swithport port-secure interface FastEthernet 0/12C、SW1# show port-secure interface FastEthernet 0/12D、SW1#show running-config
考题
HSRP has been configured between two Company devices. What kind of message does an HSRP configured router send out every 3 seconds？（）A、 RetireB、 CoupC、 ResignD、 SendE、 Hello
考题
Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? （）A、Router1 has specific boot system command that instruct it to load IOS from TFTP server.B、Router1 is acting as a TFTP server for other routers.C、Router1 cannot locate a valid IOS image in flash memory.D、Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.E、Cisco routers will first attempt to load a image from TFTP for management purposes.
考题
A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?（）A、oneB、threeC、twoD、zero
考题
Which two conditions, when met, allow an IS-IS Level 2 router to be considered attached?（）A、You can reach other Level 2 routers.B、It can reach at least one other defined area.C、The router is reachable by at least two ES-IS nodes.D、It has at least one enabled reachable prefix with a valid metric defined.
考题
单选题A router has two FastEthernet interfaces and needs to connect to four vlans in the local network.How canyou accomplish this task，using the fewest physical interfaces and withoutdecreasing networkperformance？（）A
Add two more FastEthernet interfaces.B
Add a second router to handle the vlan traffic.C
Use a hub to connect the four vlans with a FastEthernet interface on router.D
Implement a router-on-a-stick configuration.
考题
多选题HSRP has been configured between two Company devices. Which of the following describe reasons for deploying HSRP？ （）AHSRP provides redundancy and fault toleranceBHSRP allows one router to automatically assume the function of the second router if the second router failsCHSRP allows one router to automatically assume the function of the second router if the second router startsDHSRP provides redundancy and load balancing
考题
单选题A company has a small network，consisting of a single switch and a single router.The switch has beenconfigured with two vlans，and route-on-a-stick is being configured on the router for inter-vlan routing.Atrunk is configured to connect the switch to the router.What is the minimum number of router subinterfacesthat are required for all the vlans to communicate？（）A
oneB
threeC
twoD
zero
考题
多选题Which two commands correctly verify whether port security has been configured on port FastEthernet 0/12 on a switch?（）ASW1#show swithport port-security interface FastEthernet 0/12BSW1#show swithport port-secure interface FastEthernet 0/12CSW1#show port-secure interface FastEthernet 0/12DSW1#show running-config
考题
多选题Which two commands correctly verify whether port security has been configured on portFastEthernet 0/12on a switch？（）ASW1#show swithport port-security interface FastEthernet 0/12BSW1# show swithport port-secure interface FastEthernet 0/12CSW1# show port-secure interface FastEthernet 0/12DSW1#show running-config
考题
多选题Which two commands correctly verify whether port security has been configured on port FastEthernet 0/12 on a switch？（）ASW1#show swithport port-security interface FastEthernet 0/12BSW1# show swithport port-secure interface FastEthernet 0/12CSW1# show port-secure interface FastEthernet 0/12DSW1#show running-configESW1#show port-security interface FastEthernet 0/12
考题
单选题A router has two FastEthernet interfaces and needs to connect to four vlans in the local network.How can you accomplish this task，using the fewest physical interfaces and without decreasing network performance？（）A
Add two more FastEthernet interfaces.B
Add a second router to handle the vlan traffic.C
Use a hub to connect the four vlans with a FastEtherneti nterface on router.D
Implement a router-on-a-stick configuration.
考题
单选题A company has a Frame Relay WAN with one central - site router and 100 branch office routers. A partial mesh of PVCs exists: one PVC between the central site and each of t he 100 branch routers. All routers use point - to - point subinterfaces and one subnet per PVC. Which of the following is true about OSPF in this design?（）A
The central site router has 100 fully adjacent neighborships with the 100 branchesB
The central site router has neighborships with all branch routers, but fully adjacent neighbors with only two branchesC
The central site router has a neighborship with the Frame Relay switcHD
None of the other answers is correct
考题
单选题A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）A
For the two vlans to communicate，a network statement for the trunk interface needs to be added to the OSPF configuration.B
For the two vlans to communicate， a network statement for each subinterface needs to be added to the OSPF configuration.C
Direct inter-vlan communication does not require OSPFD
OSPF cannot be used if router-on-a-stick is configured on the router
热门标签
最新试卷