网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
Which two multicast protocol statements are true?（）
- A、Sparse mode multicast uses a pull model to send multicast traffic to where it is requested
- B、Dense mode multicast uses a push model to flood traffic throughout the network and then prunes the unwanted traffic
- C、Dense mode multicast requires explicit join messa ges from their members
- D、Sparse mode uses reverse path forwarding (RPF) to prune off redundant flows
- E、The primary use of sparse mode multicast is for test labs and router performance testing
参考答案
更多 “Which two multicast protocol statements are true?（）A、Sparse mode multicast uses a pull model to send multicast traffic to where it is requestedB、Dense mode multicast uses a push model to flood traffic throughout the network and then prunes the unwanted trafficC、Dense mode multicast requires explicit join messa ges from their membersD、Sparse mode uses reverse path forwarding (RPF) to prune off redundant flowsE、The primary use of sparse mode multicast is for test labs and router performance testing” 相关考题
考题
Regarding DHCP (dynamic host configuration protocol), which two of the following choices below are true? (Select two answer choices)A. The DHCP Discover message uses FF-FF-FF-FF-FF as the Layer 2 destination address.B. The DHCP Discover message uses UDP as the transport layer protocol.C. The DHCP Discover message uses a special Layer 2 multicast address as the destination address.D. The DHCP Discover message uses TCP as the transport layer protocol.E. The DHCP Discover message does not use a Layer 2 destination address.F. The DHCP Discover message does not require a transport layer protocol.
考题
What are two commands that can be used to configure MBGP for multicast?()
A. Under the BGP group, configure family inet any.B. Use the set protocol MBGP command to enable MBGP.C. Under the BGP group, configure family inet multicast.D. Use the set rib-group command to copy the multicast routes into inet.1.
考题
Which two multicast protocol statements are true?()
A. Sparse mode multicast uses a pull model to send multicast traffic to where it is requestedB. Dense mode multicast uses a push model to flood traffic throughout the network and then prunes the unwanted trafficC. Dense mode multicast requires explicit join messa ges from their membersD. Sparse mode uses reverse path forwarding (RPF) to prune off redundant flowsE. The primary use of sparse mode multicast is for test labs and router performance testing
考题
Which two statements are tru e about the rendezvous point (RP) in a multicast network?()
A. The multicast sources must register with the RP to form the multicast distribution treeB. An RP is required only in networks running Protocol Independent Multicast dense mode ( PIM DM)C. The multicast receivers must register with the RP to form the multicast distribution treeD. An RP is required only in networks running Protocol Independent Multicast sparse mode (PIM SM)E. An RP is required only in networks running Pro tocol Independent Multicast sparse - dense mode (PIM - SDM)F. To form the multicast distribution tree, the multicast sources register with and the receivers join the RP
考题
Which two statements are true about Internet Group Management Protocol (IGMP) snooping?()
A. IGMP snooping and Cisco Group Membership Protocol (CGMP) can be used simultaneously on a switch.B. IGMP snooping a nd Cisco Group Membership Protocol (CGMP) were developed to help Layer 3 switches make intelligent forwarding decisions on their own.C. IGMP snooping examines IGMP join/leave messages so that multicast traffic is forwarded only to hosts that sent an IG MP message toward the router.D. IGMP snooping is an IP multicast constraining mechanism for Layer 2 switches.E. IGMP snooping is enabled with the ip multicast - routing global configuration command.
考题
Which three statements are true about the Internet Group Management Protocol (IGMP)? ()
A. There are three IGMP modes: dense mode, sparse mode, and sparse - dense modeB. IGMP is used to register individual hosts with a multicast groupC. IGMP version 3 enables a multicast receiving host to specify to the router which sources it should forward traffic fromD. IGMP messages a re IP datagrams with a protocol value of 2, destination address of 224.0.0.2, and a TTL value of 1E. IGMP is a multicast routing protocol that makes packet - forwarding decisions independent of other routing protocols such as EIGRPF. IGMP snooping ru ns on Layer 3 routers
考题
Which two statements are true about the rendezvous poin t (RP) in a multicast network?（）A、The multicast sources must register with the RP to form the multicast distribution tree.B、An RP is required only in networks running Protocol Independent Multicast dense mode (PIM DM).C、The multicast receivers must register with the RP to form the multicast distribution tree.D、An RP is required only in networks running Protocol Independent Multicast sparse mode (PIM SM).E、An RP is required only in networks running Protocol Independent Multicast sparse - dense mode (PIM - SDM).F、To form the multicast distribution tree, the multicast sources register with and the receivers join the RP.
考题
Which type of domains is interconnected using Multicast Source Discovery Protocol？（）A、PIM-SMB、PIM-DMC、PIM-SSMD、DVMRP
考题
Which two statements are tru e about the rendezvous point (RP) in a multicast network?（）A、The multicast sources must register with the RP to form the multicast distribution treeB、An RP is required only in networks running Protocol Independent Multicast dense mode ( PIM DM)C、The multicast receivers must register with the RP to form the multicast distribution treeD、An RP is required only in networks running Protocol Independent Multicast sparse mode (PIM SM)E、An RP is required only in networks running Pro tocol Independent Multicast sparse - dense mode (PIM - SDM)F、To form the multicast distribution tree, the multicast sources register with and the receivers join the RP
考题
Which two of these multicast deployments are most susceptible to attacks from unknown sources？（）A、 ASMB、 BiDir PIMC、 PIM-SM RPD、 RP-SwitchoverE、 Source Specific Multicast
考题
In order to configure two routers as anycast RPs， which of these requirements， af a minimum， must besatisfied？（）A、Multicast Source Discovery Protocol mesh-groups must be configured between the two anycast RPs.B、The RPs must be within the same IGP domain.C、Multicast Source Discovery Protocol must be configured between the two anycast RPs.D、The two anycast RPs must be IBGP peers.
考题
In order to configure two routers as anycast RPs，which of these requirements，at a minimum， must be satisfied？（）A、Multicast Source Discovery Protocol mesh-groups must be configured between the two anycast RPs.B、The RPs must be within the same IGP domain.C、Multicast Source Discovery Protocol must be configured between the two anycast RPs.D、The two anycast RPs must be IBGP peers.
考题
Which two statements are true about Internet Group Management Protocol (IGMP) snooping?（）A、IGMP snooping and Cisco Group Membership Protocol (CGMP) can be used simultaneously on a switch.B、IGMP snooping a nd Cisco Group Membership Protocol (CGMP) were developed to help Layer 3 switches make intelligent forwarding decisions on their own.C、IGMP snooping examines IGMP join/leave messages so that multicast traffic is forwarded only to hosts that sent an IG MP message toward the router.D、IGMP snooping is an IP multicast constraining mechanism for Layer 2 switches.E、IGMP snooping is enabled with the ip multicast - routing global configuration command.
考题
Which two of these are characteristics of multicast routing？ （）A、 multicast routing uses RPFB、 multicast routing is connectionless.C、 In multicast routing， the source of a packet is known.D、 When network topologies change， multicast distribution trees are not rebuilt， but use the originalpathE、 Multicast routing is much like unicast routing， with the only difference being that it has a a groupof receivers rather than just one destination
考题
Which two statements are true about the rendezvo us point (RP) in a multicast network?（）A、The multicast sources must register with the RP to form the multicast distribution tree.B、An RP is required only in networks running Protocol Independent Multicast dense mode (PIM DM).C、The mu lticast receivers must register with the RP to form the multicast distribution tree.D、An RP is required only in networks running Protocol Independent Multicast sparse mode (PIM SM).E、An RP is required only in networks running Protocol Independent Mu lticast sparse - dense mode (PIM - SDM).F、To form the multicast distribution tree, the multicast sources register with and the receivers join the RP.
考题
Which two packet attributes contribute to the identification of a session? （）(Choose two.)A、destination portB、TTLC、IP optionsD、protocol number
考题
多选题Which two of these multicast deployments are most susceptible to attacks from unknown sources？（）AASMBBiDir PIMCPIM-SM RPDRP-SwitchoverESource Specific Multicast
考题
多选题Which two statements are true about the rendezvous poin t (RP) in a multicast network?（）AThe multicast sources must register with the RP to form the multicast distribution tree.BAn RP is required only in networks running Protocol Independent Multicast dense mode (PIM DM).CThe multicast receivers must register with the RP to form the multicast distribution tree.DAn RP is required only in networks running Protocol Independent Multicast sparse mode (PIM SM).EAn RP is required only in networks running Protocol Independent Multicast sparse - dense mode (PIM - SDM).FTo form the multicast distribution tree, the multicast sources register with and the receivers join the RP.
考题
多选题Which two of these multicast deployments are most susceptible to attacks from unknown sources?（）AASMBBiDirPIMCPIM-SMRPDRP-SwitchoverESourceSpecificMulticast
考题
单选题Which type of domains is interconnected using Multicast Source Discovery Protocol？（）A
PIM-SMB
PIM-DMC
PIM-SSMD
DVMRP
考题
多选题What are two commands that can be used to configure MBGP for multicast?（）AUnder the BGP group, configure family inet any.BUse the set protocol MBGP command to enable MBGP.CUnder the BGP group, configure family inet multicast.DUse the set rib-group command to copy the multicast routes into inet.1.
考题
多选题Which two statements are true about the rendezvo us point (RP) in a multicast network?（）AThe multicast sources must register with the RP to form the multicast distribution tree.BAn RP is required only in networks running Protocol Independent Multicast dense mode (PIM DM).CThe mu lticast receivers must register with the RP to form the multicast distribution tree.DAn RP is required only in networks running Protocol Independent Multicast sparse mode (PIM SM).EAn RP is required only in networks running Protocol Independent Mu lticast sparse - dense mode (PIM - SDM).FTo form the multicast distribution tree, the multicast sources register with and the receivers join the RP.
考题
多选题Which three statements are true about the Internet Group Management Protocol (IGMP)? （）AThere are three IGMP modes: dense mode, sparse mode, and sparse - dense modeBIGMP is used to register individual hosts with a multicast groupCIGMP version 3 enables a multicast receiving host to specify to the router which sources it should forward traffic fromDIGMP messages a re IP datagrams with a protocol value of 2, destination address of 224.0.0.2, and a TTL value of 1EIGMP is a multicast routing protocol that makes packet - forwarding decisions independent of other routing protocols such as EIGRPFIGMP snooping ru ns on Layer 3 routers
考题
多选题Which two multicast protocol statements are true？ （Choose two.） （）ADense mode multicast requires explicit join messages from their members.BDense mode multicast uses a push model to flood traffic throughout the network and then prunes the unwanted traffic.CSparse mode multicast uses a pull model to send multicast traffic to where it is requested.DSparse mode uses reverse path forwarding （RPF） to prune off redundant flows.EThe primary use of sparse mode multicast is for test labs and router performance testing.
考题
多选题Which two multicast protocol statements are true?（）ASparse mode multicast uses a pull model to send multicast traffic to where it is requestedBDense mode multicast uses a push model to flood traffic throughout the network and then prunes the unwanted trafficCDense mode multicast requires explicit join messa ges from their membersDSparse mode uses reverse path forwarding (RPF) to prune off redundant flowsEThe primary use of sparse mode multicast is for test labs and router performance testing
考题
多选题Which two protocols use UDP as a transport protocol by default?（）ATelnetBICMPCDHCPDRIP
热门标签
最新试卷