网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
Refer to the exhibit. What switch proves the spanning－tree designated port role for the network segment that services the printers?()
A.Switch1
B.Switch2
C.Switch3
D.Switch4
参考答案
更多 “ Refer to the exhibit. What switch proves the spanning－tree designated port role for the network segment that services the printers?() A.Switch1B.Switch2C.Switch3D.Switch4 ” 相关考题
考题
You have a server that runs windows server 2008 you need to configure the server as a VPN server. What should you install on the server?()
A.Windows deployment Services role and deployment server role service.B.Windows deployment services role and deployment transport role service.C.Network policy and access services role and routing and remote access services role service.D.Network policy and access services and host credential authorization protocol role service.
考题
Refer to the exhibit. Switch port FastEthernet 0/24 on AlSwitch1 will be used to create an IEEE 802.1Q- complaint trunk to another switch. Based on the output shown, What is the reason the trunk does not form, even thought the proper cabling has been attached?（）A.VLANs have not been created yetB.An IP address must be configured for the portC.The port is currently configured for access modeD.The correct encapsulation type has not been configuredE.The no shutdown command has not been entered for the port
考题
Refer to the exhibit. Give this output for SwitchC, what should the network administrator‘s next action be?()
A.Check the trunk encapsulation mode for SwitchC‘s fa0/1 port.B.Check the duplex mode for SwitchC‘s fa0/1 port.C.Check the duplex mode for SwitchA‘s fa0/2 port.D.Check the trunk encapsulation mode for SwitchA‘s fa0/2 port.
考题
Refer to the exhibit. At the end of an RSTP election process, which access layer switch port will assume the discarding role?()
A.Switch3, port fa0/1B.Switch3, port fa0/12C.Switch4, port fa0/11D.Switch4, port fa0/2E.Switch3, port Gi0/1F.Switch3, port Gi0/2
考题
Refer to the exhibit. Given the output shown from this Cisco Catalyst 2950, what is the most likely reason that interface FastEthernet 0／10 is not the root port for VLAN 2?()
A.This switch has more than one interface connected to the root network segment in VLAN 2.B.This switch is running RSTP while the elected designated switch is running 802.1d Spanning Tree.C.This switch interface has a higher path cost to the root bridge than another in the topology.D.This switch has a lower bridge ID for VLAN 2 than the elected designated switch.
考题
A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port（）。A、This is a 10 Mb/s switch portB、This is a 100 Mb/s switch portC、This is an Ethernet port operating at half duplexD、This is an Ethernet port operating at full duplexE、This is a port on a network interface card in a PC
考题
What value is primarily used to determine which port becomes the root port on each nonroot switch in a spanning-tree topology？（）A、lowest port MAC addressB、port priority number and MAC addressC、VTP revision numberD、highest port priority numberE、path cost
考题
A port in a redundant topology is currently in the blocking state and is not receiving BPDUs. To ensure that this port does not erroneously transition to the forwarding state， which command should be configured to satisfy the requirement？（）A、Switch（config）#spanning-tree loopguard defaultB、Switch（config-if）#spanning-tree bdpufilterC、Switch（config）#udld aggressiveD、Switch（config-if）#spanning-tree bpduguard
考题
Which port role has interface Fa0/2 of switch 1 adopted for VLAN 47？（）A、Root portB、Nondesigned portC、Designated portD、Backup portE、Alternate portF、None of the other alternatives apply
考题
A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?（）A、This is a 10 Mb/s switch port.B、This is a 100 Mb/s switch port.C、This is an Ethernet port operating at half duplex.D、This is an Ethernet port operating at full duplex.E、This is a port on a network interface card in a PC
考题
What value is primarily used to determine which port becomes the root port on each non root switch in a spanning-tree topology?（）A、path costB、lowest port MAC addressC、VTP revision numberD、highest port priority numberE、port priority number and MAC address
考题
Refer to the exhibit. The two connected ports on the switch are not turning orange or green. What would be the most effective steps to troubleshoot this physical layer problem?（）A、Ensure that the Ethernet encapsulations match on the interconnected router and switch ports.B、Ensure that cables A and B are straight-through cables.C、Ensure cable A is plugged into a trunk port.D、Ensure the switch has power.E、Reboot all of the devices.F、Reseat all cables.
考题
You have a server that runs Windows Server 2008.You need to configure the server as a VPN server. What should you install on the server？ （）A、Windows Deployment Services server role and Deployment Server role service.B、Windows Deployment Services server role and Transport role Service.C、Network Policy and Access Services server role and Routing and Remote Access Services role service.D、Network Policy and Access Services server role and Host Credential Authorization Protocol role.
考题
What are the switch and bridge port characteristics of a layer two spanning-tree network that is fully converged?（）A、All switch and bridge ports are in the forwarding state.B、All switch and bridge ports are in the stand-by state.C、All switch and bridge ports are assigned as either root or designated ports.D、All switch and bridge ports are in either the forwarding or blocking state.E、All switch and bridge are either blocking or looping.
考题
Which statement is correct about RSTP port roles？（）A、The designated port is the switch port on every nonroot bridge that is the chosen path to theroot bridge. There can be only one designated port on every switch. The designated portassumes the forwarding state in a stable active topology. All switches connected to a given segment listen to all BPDUs and determine the switch that will be the root switch for a particular segment.B、The disabled port is an additional switch port on the designated switch with a redundant link to the segment for which the switch is designated. A disabled port has a higher port ID than the disabled port on the designated switch. The disabled port assumes the discarding state in astable active topology.C、The backup port is a switch port that offers an alternate path toward the root bridge. The backup port assumes a discarding state in a stable， active topology. The backup port will be present on nondesignated switches and will make a transition to a designated port if the current designated path fails.D、The root port is the switch port on every nonroot bridge that is the chosen path to the root bridge. There can be only one root port on every switch. The root port assumes the forwarding state in a stable active topology.
考题
You have a server that runs windows server 2008 you need to configure the server as a VPN server. What should you install on the server?（）A、Windows deployment Services role and deployment server role service.B、Windows deployment services role and deployment transport role service.C、Network policy and access services role and routing and remote access services role service.D、Network policy and access services and host credential authorization protocol role service.
考题
You have a server that runs Windows Server 2008 You need to configure the server as a VPN server. What should you install on the server（）A、Windows Deployment Services role and Deployment Server role serviceB、Windows Deployment Services role and Deployment transport role serviceC、Network Policy and Access services role and routing and remote access services role serviceD、Network Policy and access services and host credential authorization protocol role service
考题
单选题Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?（）A
The design will function as intendedB
Spanning-tree will need to be used.C
The router will not accept the addressing scheme.D
The connection between switches should be a trunk.E
The router interfaces must be encapsulated with the 802.1Q protocol.
考题
单选题Refer to the exhibit. At the end of an RSTP election process, which access layer switch port will assume the discarding role?（）A
Switch3, port fa0/1B
Switch3, port fa0/12C
Switch4, port fa0/11D
Switch4, port fa0/2E
Switch3, port Gi0/1F
Switch3, port Gi0/2
考题
单选题Which statement is correct about RSTP port roles？（）A
The designated port is the switch port on every nonroot bridge that is the chosen path to theroot bridge. There can be only one designated port on every switch. The designated portassumes the forwarding state in a stable active topology. All switches connected to a given segment listen to all BPDUs and determine the switch that will be the root switch for a particular segment.B
The disabled port is an additional switch port on the designated switch with a redundant link to the segment for which the switch is designated. A disabled port has a higher port ID than the disabled port on the designated switch. The disabled port assumes the discarding state in astable active topology.C
The backup port is a switch port that offers an alternate path toward the root bridge. The backup port assumes a discarding state in a stable， active topology. The backup port will be present on nondesignated switches and will make a transition to a designated port if the current designated path fails.D
The root port is the switch port on every nonroot bridge that is the chosen path to the root bridge. There can be only one root port on every switch. The root port assumes the forwarding state in a stable active topology.
考题
单选题Which statement describes a spanning-tree network that has converged?（）A
All switch and bridge ports are in the forwarding state.B
All switch and bridge ports are assigned as either root or designated ports.C
All switch and bridge ports are in either the forwarding or blocking state.D
All switch and bridge ports are either blocking or looping.
考题
单选题Refer to the exhibit. What switch proves the spanning-tree designated port role for the network segment that services the printers?（）A
Switch1B
Switch2C
Switch3D
Switch4
考题
多选题Refer to the exhibit. The two connected ports on the switch are not turning orange or green. What would be the most effective steps to troubleshoot this physical layer problem?（）AEnsure that the Ethernet encapsulations match on the interconnected router and switch ports.BEnsure that cables A and B are straight-through cables.CEnsure cable A is plugged into a trunk port.DEnsure the switch has power.EReboot all of the devices.FReseat all cables.
考题
单选题What value is primarily used to determine which port becomes the root port on each non root switch in a spanning-tree topology?（）A
path costB
lowest port MAC addressC
VTP revision numberD
highest port priority numberE
port priority number and MAC address
考题
单选题A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?（）A
This is a 10 Mb/s switch port.B
This is a 100 Mb/s switch port.C
This is an Ethernet port operating at half duplex.D
This is an Ethernet port operating at full duplex.E
This is a port on a network interface card in a PC
考题
单选题What value is primarily used to determine which port becomes the root port on each nonroot switch in a spanning-tree topology？（）A
lowest port MAC addressB
port priority number and MAC addressC
VTP revision numberD
highest port priority numberE
path cost
考题
单选题A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port（）。A
This is a 10 Mb/s switch portB
This is a 100 Mb/s switch portC
This is an Ethernet port operating at half duplexD
This is an Ethernet port operating at full duplexE
This is a port on a network interface card in a PC
热门标签
最新试卷