网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
Refer to the exhibit. Which command would verify if PBR reacts to packets sourced from 172.16.0.0／16?()
A. show ip route
B. show policy - map
C. show access - lists
D. show route - map
参考答案
更多 “ Refer to the exhibit. Which command would verify if PBR reacts to packets sourced from 172.16.0.0／16?() A. show ip routeB. show policy - mapC. show access - listsD. show route - map ” 相关考题
考题
You have two IP addresses configured on the ge-0/0/6 interface, as shown in the exhibit. You want to select the 172.16.10.101 address as the source address for packets sent from this interface to hosts on a remote subnet.Which parameter would you add to the 172.16.10.101 address to complete this task?（）A. preferredB. broadcastC. primaryD. arp 172.16.10.101
考题
Refer to the exhibit. This shows the NetFlow statistics for a router. You are analyzing the traffic pattern and you are interested in the percentage of packets between 32 and 64 bytes in size and the number of flows in progress. Which of these identifies both numbers correctly?（）A. 69.4%, 4061B. 24.9%, 980C. 69.4%, 35D. 6.94%, 980E. cannot be determined from this output
考题
When policy － based routing (PBR) is being configured, which three criteria can the set command specify?()
A. all interfaces in the path toward the destinationB. all networks in the path toward the destinationC. adjacent next hop router in the path toward the destinationD. all routers in the path toward the destinationE. all interfaces through which the packets can be routedF. type of service and precedence in the IP packets
考题
Refer to the exhibit. R1 and R2 have been configured to share routing information via EIGRP. What will be the result of the configuration section shown for R2? ()
A. Any routes learned by R2 from the interface tied to the 172.16.0.0 network will not be advertised to neighbors on the 192.168.2.0 network.B. Only routes learned by R2 from the interface tied to the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network.C. Only the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network.D. All networks, except the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network .
考题
Refer to the exhibit. Which interoperability technique implemented on the dual - stack routers would allow connectivity between IPv6 sites across automatic created tunnels using the 2002::/16 prefix? （）A. Dual StackB. NAT - PTC. 6to4 tunnelD. GRE tunnelE. ISATAP tunnel
考题
Refer to the exhibit. OSPF has been configured on all routers in the network. However, router R1 does not receive a default route to router R2 as in tended. Which configuration change would ensure that R1 would receive a default route from R2? （）A. Add the area 1 stub command on routers R1.B. Add the always keyword to the default - information originate configuration command on router R2.C. Remov e the default information originate configuration command from router R2 and place it on router R1.D. Add the ip route 5.0.0.0 255.255.255.0 0.0.0.0 command to router R2.
考题
Refer to the exhibit. Which two Cisco IOS commands on R2 would verify its OSPF neighbor relationships?()
A.show ip ospfB.show ip ospf interfaceC.show ip ospf neighborD.show ip ospf databaseE.show ip ospf statisticsF.show running - config begin router ospf
考题
Refer to the exhibit. Router B is performing bidirectional redistribution between EIGRP an d OSPF.The network 10.100.1.0/24 should not be reachable from the 10.100.9.0/24 network. However, it needs to be reachable from any network within the EIGRP domain. All other networks should be seen in both domains. Which change to router B would accom plish these goals?（）A. Under the EIGRP process, insert the distribute - list block_net_1 out ospf 1 command.B. Under the OSPF process, insert the distribute - list block_net_1 in serial1/0 command.C. Under the EIGRP process, insert the distribute - list block_net_1 in serial1/0 command.D. Under the OSPF process, insert the distribute - list block_net_1 out eigrp 1 command.
考题
Refer to the exhibit. Based upon the configuration, you need to understand why the policy routi match counts are not increasing. Which would be the first logical step to take?()
A. Confirm if there are other problematic route - map statements that precede divert.B. Check the access list for log hits.C. Check the routing table for 212.50.185.126.D. Remove any two of the set clauses. (Multiple set clause entries will cause PBR to use the routing table.)
考题
Refer to the exhibit. OSPF is running throughout the network. You want to minimize the propagation of LSAs into and out of A rea 1. Which OSPF feature would best achieve this goal? ()
A. stubB. totally stubbyC. NSSAD. totally NSSA
考题
Refer to the exhibit. Routing updates for the 192.168.1.0 network are being received from all three neighbors. Which statement is correct regarding the result of the con figuration shown? ()
A. The router will prefer the next hop of 172.16.1.1 for packets destined for the 192.168.1.0 network.B. The router will prefer the next hop of 172.26.1.1 for packets destined for the 192.168.1.0 network.C. The router will adve rtise the 192.168.1.0 network only to 172.30.1.1.D. The router will advertise the 192.168.1.0 network only to 172.26.1.1.E. The router will prefer the next hop of 172.26.1.1 for packets except those destined for the 192.168.1.0 network.
考题
Refer to the exhibit. Which two statements are true?()
A. DHCPDISCOVER packets will reach the DHCP server.B. The router will not forward DHCPDIS COVER packets because it has not been configured to do so.C. This configuration is applied to interface Fa0/1.D. DHCPDISCOVER packets will not reach the DHCP server because DHCPDISCOVER packets are broadcasts.E. DHCPDISCOVER packets will not reach the DHCP server because ports 67 and 68 have not been explicitly allowed by the ip forward - protocol command.F. This configuration is applied to interface Fa0/0.
考题
Refer to the exhibit. Which statement is true about the configuration? ()
A. RTA will not establish an OSPF adjacency w ith RTBB. RTA will send OSPF hello packets, but will not send OSPF updatesC. RTA will not accept OSPF hello packets from RTBD. RTA will send OSPF updates, but will not establish an adjacency with RTB
考题
Refer to the exhibit. EIGRP is configured with the default configuration on all routers. Auto summariz ation is enabled on routers R2 and R3, but it is disabled on router R1.Which two EIGRP routes will be seen in the routing table of router R3?（）A. 10.0.0.0/8B. 172.16.10.0/24C. 172.16.0.0/24D. 10.10.10.0/24E. 172.16.0.0/16F. 10.10.0.0/16
考题
Refer to the exhibit. In this VLSM addressing scheme, what summary address would be sent from routerA?()
A.172.16.0.0/16B.172.16.0.0/20C.172.16.0.0/24D.172.32.0.0/16E.172.32.0.0/17F.172.64.0.0/16
考题
Refer to the exhibit. Which command would allow the translations to be created on the router?()
A.ip nat pool mynats 1.1.128.1 1.1.135.254 prefix-length 19B.ip nat outside mynats 1.1.128.1 1.1.135.254 prefix-length 19C.ip nat pool mynats 1.1.128.1 1.1.135.254 prefix-length 18D.ip nat outside mynats 1.1.128.1 1.1.135.254 prefix-length 18
考题
When policy - based routing (PBR) is being configured, which three criteria can the set command specify?（）A、all interfaces in the path toward the destinationB、all networks in the path toward the destinationC、adjacent next hop router in the path toward the destinationD、all routers in the path toward the destinationE、all interfaces through which the packets can be routedF、type of service and precedence in the IP packets
考题
After rebuilding the list of virtual devices used by the VIO server using the "cfgdev" command， which command would be run to verify that a newly configured virtual SCSI adapter is available？（）A、lsdev -virtualB、lsdev -Cs scsiC、lscfg -vlD、lsdev -adapter
考题
An administrator has set up serverA and serverB to use the /etc/hosts.equiv file so that applications on serverA can remotely run commands on serverB. Which command will verify if a new user from serverA is trusted on serverB?（）A、As the root user from serverA run the command rhost serverBB、As the root user from serverA run the command rlogin serverBC、As the desired user from serverB run the command rhost serverAD、As the desired user from serverA run the command rlogin serverB
考题
多选题Refer to the exhibit. Which two statements are correct？ （Choose two.）（）AAll six routes will be installed in the routing table.BTwo routes will be installed in the routing table.CFour routes will be installed in the routing table.DAll the routes were redistributed into BGP from an IGP.EAll the routes were originated by BGP with the network command.
考题
单选题Refer to the exhibit. In this VLSM addressing scheme, what summary address would be sent from routerA?（）A
172.16.0.0/16B
172.16.0.0/20C
172.16.0.0/24D
172.32.0.0/16E
172.32.0.0/17F
172.64.0.0/16
考题
单选题Refer to the exhibit. What is the effect on the trust boundary of configuring the command mls qos trust cos on the switch port that is connected to the IP phone？（）A
Effectively the trust boundary has been moved to the IP phone.B
The host is now establishing the CoS value and has effectively become the trust boundary. C
The switch is rewriting packets it receives from the IP phone and determining the CoS value. D
The switch will no longer tag incoming voice packets and will trust the distribution layer switch to set theCoSE
RTP will be used to negotiate a CoS value based upon bandwidth utilization on the link.
考题
多选题Refer to the exhibit. Which two statements are correct？（）AAll six routes will be installed in the routing tableBTwo routes will be installed in the routing tableCFour routes will be installed in the routing tableDAll the routes were redistributed into BGP from an IGPEAll the routes were originated by BGP with the network command
考题
多选题When policy - based routing (PBR) is being configured, which three criteria can the set command specify?（）Aall interfaces in the path toward the destinationBall networks in the path toward the destinationCadjacent next hop router in the path toward the destinationDall routers in the path toward the destinationEall interfaces through which the packets can be routedFtype of service and precedence in the IP packets
考题
单选题Refer to the exhibit. Which Catalyst switch interface command would be used to cause the switch to instruct the phone to override the incoming CoS from the PC before forwarding the packet to the switch？（）A
switchport priority extend trustB
switchport priority extend cos 2C
switchport priority extend cos 11D
mls qos cos 2E
mls qos cos 2 override
考题
单选题Which operational command would you use to quickly verify the state of all interfaces?（）A
show interfaces terseB
show interfacesC
show configuration interfacesD
show interface status
考题
多选题Refer to the exhibit. Which three statements accurately describe this GLBP topology？ （Choose three.）（）ARouter A is responsible for answering ARP requests sent to the virtual IP address.BIf Router A becomes unavailable， Router B will forward packets sent to the virtual MAC address of Router ACIf another router were added to this GLBP group， there would be two backup AVGsDRouter B is in GLBP listen state.ERouter A alternately responds to ARP requests with different virtual MAC addresses.FRouter B will transition from blocking state to forwarding state when it becomes the AVG
热门标签
最新试卷