网友您好, 请在下方输入框内输入要搜索的题目:

题目内容 (请给出正确答案)
单选题
What is used as an indicator of initial stability? ()
A

GM

B

KG

C

KM

D

GZ


参考答案

参考解析
解析: 暂无解析
更多 “单选题What is used as an indicator of initial stability? ()A GMB KGC KMD GZ” 相关考题
考题 What is(are) standard operating procedure(s) used on a Ro-Ro vessel?A.Periodic inspection and retensioning of lashings as required during voyageB.Lashings may be completed after the vessel leaves portC.One QMED assigned to oversee the initial loading and lashingD.All of the above

考题 An oxygen indicator can be used to determine if there is ______.A.sufficient oxygen in a compartment to support lifeB.combustible gases presentC.hyfrogen gases presentD.All of the above

考题 GM is a measure of ______.① The initial stability of a vessel.② The rightingness of the vessel.A.① onlyB.② onlyC.Both ① and ②D.Neither ① nor ②

考题 GM cannot be used as an indicator of stability at all angles of inclination because ______.A.M is not fixed at large anglesB.there is no M at large anglesC.G is not fixed at large anglesD.there is no G at large angles

考题 What is Phantom RP used for?()A、it is used for load balancing in bidirectional PIMB、it is used for redundancy in bidirectional PIMC、it is used for redundancy in PIM-SMD、it is used for load balancing in PIM-SM

考题 设置PDCCH信道是否使用发射分集的参数是()A、Cell Open-loop Spatial Multiplexing Used IndicatorB、Transmit Diversity Indicator for Common ChannelC、Cell transmit Diversity Used IndicatorD、Cell Closed-loop Spatial Multiplexing Used Indicator

考题 What is the next state of initial in spanning-tree protocol?

考题 单选题What is(are) standard operating procedure(s) used on a Ro-Ro vessel? ()A Periodic inspection and retensioning of lashings as required during voyageB Lashings may be completed after the vessel leaves portC One QMED assigned to oversee the initial loading and lashingD All of the above

考题 单选题What is the stability term for the distance from the center of gravity (G) to the Metacenter (M),when small-angle stability applies? ()A metacentric heightB metacentric radiusC height of the metacenterD righting arm

考题 单选题The angle of loll is a stability term which applies to a floating ship with().A off-center loadingB stiff characteristicsC excessive pitch or rollD negative initial stability

考题 单选题If the cause of a sudden severe list or trim is negative initial stability,counter flooding into empty tanks may().A increase the righting momentB cause an increase in the righting armC bring the unit to an upright equilibrium positionD cause the unit to flop to a greater angle

考题 单选题Initial stability of a vessel may be improved by().A removing loose waterB adding weight low in the vesselC closing crossover valves between partly filled double bottom tanksD All of the above

考题 单选题Initial stability refers to stability().A at small angles of inclinationB when loaded with minimum deck loadC when at transit draftD when GZ is zero

考题 单选题A salinity indicator is used to determine the ().A cause of salt contaminationB location of salt water contaminationC chemical makeup of feed-waterD level of alkalinity in condensate

考题 多选题What are two valid initial configuration methods supported on Juniper routers?()ACLIBJ-WebCJUNOScopeDPCMCIA flash card

考题 单选题What does a broad-spectrum interferer lower?()A SNRB noise floorC level of interferenceD Received Signal Strength Indicator

考题 单选题Which of the following is the reason that the metacentric height is a valid measure of only the initial stability?().A The metacenter does not remain in the same position for large angles of inclinationB The center of gravity shift due to inclinationC The center of gravity shifts above the metacenter as the vessel is inclinedD The mean draft will change as the vessel is inclinded

考题 单选题GM cannot be used as an indicator of stability at all angles of inclination because().A M is not fixed at large anglesB there is no M at large anglesC G is not fixed at large anglesD there is no G at large angles

考题 单选题Initial stability is indicated by().A GMB KMC deck loadD maximum allowed KG

考题 单选题The effect of free surface on initial stability depends upon().A the amount of liquid in the compartmentB the dimensions of the liquid surface and the vessel's displacementC only the length of the compartmentD the vertical position of the liquid in the vessel

考题 单选题What will NOT decrease the stability of a vessel?()A Topside icingB Running with a following seaC Using 35% of the fuel in a full tankD Lowering a weight suspended by a boom onto the deck

考题 单选题The effects of free surface on initial stability depend upon the dimensions of the surface of the free liquids and the().A volume of liquid in the tankB volume of displacement of the vesselC location of the tank in the vesselD height of the center of gravity of the vessel

考题 单选题The important initial stability parameter,GM,is the().A metacentric heightB height of the metacenter above the keelC height of the center of buoyancy above the keelD height of the center of gravity above the keel

考题 单选题Diesel engine cylinder head test cocks are used to ()A check cylinder lubricationB connect the pressure indicator pressureC test cylinder headsD connect the exhaust gas pyrometers

考题 单选题An oxygen indicator can be used to determine if there is().A sufficient oxygen in a compartment to support lifeB combustible gases presentC hydrogen gases presentD All of the above

考题 单选题If the cause of a sudden severe list is negative initial stability,counterflooding into empty tanks may().A increase the righting momentB cause an increase in the righting armC bring the vessel to an upright equilibrium positionD cause the vessel to flop to a greater angle

考题 问答题What is the next state of initial in spanning-tree protocol?