网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
单选题
The interface between the liquid seal (water) and the oil should be positioned （） possible to the bowl periphery.
A
as far as
B
as soon as
C
as close as
D
as closer as
参考答案
参考解析
解析：
暂无解析
更多 “单选题The interface between the liquid seal (water) and the oil should be positioned （） possible to the bowl periphery.A as far asB as soon asC as close asD as closer as” 相关考题
考题
One of the reasons that causes oil flowed from sludge outlet of a self-cleaning purifier isA.seal water supply be cut offB.make-up water supply be cut offC.oil outlet valve closed or not open sufficientlyD.the flow rate of oil is too much
考题
A high rate of separation between oil and water is favored by ______.A.large size of oil globule(小球)B.low temperatureC.high viscosityD.high flow rate
考题
A centrifugal pump may fail to deliver water when first started if the ______.A.water seal pipe is pluggedB.pump is not primedC.seal ring is properly locatedD.impeller is flooded
考题
OIL-IN-WATER are ______．A.sediment of oil in waterB.oil dissolvents in waterC.solid oil aggregatesD.droplets of oil suspended in water
考题
Before loading bulk grain, bilge wells must be covered to ______.A.add strength to the bilge well strainerB.permit rapid flow of water to the bilge wellsC.prevent cargo sifting into the bilge wellsD.prevent oil, water, or other liquid from reaching the cargo
考题
单选题A high rate of separation between oil and water is favored by （）.A
large size of oil globuleB
low temperatureC
high viscosityD
high flow rate
考题
单选题You should frequently compare drum-mounted and remote-reading water level indicators（） between these have contributed to failures because of overheating through shortage of water, when a boiler was being oil-fired.A
descriptionsB
discrepanciesC
differentD
deflections
考题
单选题Factor influencing the position of the interface between the liquid seal and the oil in a purifier is （）.A
throughputB
back pressureC
gravity discD
None of the above is wrong
考题
单选题Before loading bulk grain，bilge wells must be covered to（）.A
add strength to the bilge well strainerB
permit rapid flow of water to the bilge wellsC
prevent cargo sifting into the bilge wellsD
prevent oil，water，or other liquid from reaching the cargo
考题
单选题Which of the following conditions indicates the dilution of diesel engine lube oil by fuel oil?（）A
Water discharging from the water outlet of the lube oil purifierB
Fuel oil discharging from the water outlet of the lube oil purifierC
Lube oil discharging from the water outlet of the lube oil purifierD
A change in the lube oil viscosity
考题
单选题Oil pressure in the lubrication system is（）than the static sea water head to ensure that sea water cannot enter the sterntube in the event of seal failure.A
higherB
lowerC
very higherD
very lower
考题
单选题In a disk-type lubricating oil purifier, （）A
the purifier driving gears are lubricated by the reclaimedB
oil as it leaves the bowl all dirt and sludge are automatically discharged with the cooling waterC
sealing water must never be supplied until after oil is fed to the unitD
deterioration of the bowl ring gasket will cause the purifier to lose its water seal
考题
单选题A definite advantage of using water as a fire extinguishing agent is its characteristic of（）.A
alternate expansion and contraction as water in a liquid state becomes a vaporB
absorption of smoke and gases as water is converted from a liquid to a vaporC
rapid contraction as water is converted from a liquid to a vaporD
rapid expansion as water absorbs heat and changes to steam
考题
单选题The remaining oil/water mixture now flows down into the fine separating compartment and moves slowly between the（） in the Turbulo separator.A
catch platesB
swash platesC
cover platesD
bedplates
考题
单选题Which of the following statements is true concerning an oil cooler?（）A
The oil temperature is less than the cooling water temperatureB
The oil pressure is less than the cooling water pressureC
The oil pressure is greater than the cooling water pressureD
The oil flow control valve is always installed in the oil input line
考题
单选题The film of oil between the rings and the liner is not only essential for the lubrication but also （） achieving a gas seal.A
play a great part onB
run a role inC
plays an important part inD
acts as important part at
考题
单选题The position of the interface between oil and water within the centrifuge is achieved by the use of （）.A
gravity discB
centrifugal bowlC
a stack of discsD
main sealing ring
考题
单选题The principle of separation by which all commercially available oily water separators function is （） differential between oil and water.A
the temperatureB
the viscosityC
the gravityD
the size
考题
单选题For a L√Opurifier, if the back pressure of the oil outlet is too high, the interface between oil and water in the bowl will （）.A
be interruptedB
move downwardsC
move outwardsD
retain original position
考题
单选题Which of the following influences the position of the interface between the liquid seal and the oil in a purifier?（）A
Height of the machineB
Temperature of the liquid sealC
Gravity discD
Bowl diameter
考题
单选题A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）A
purge lube oil from the liquid refrigerantB
recover water purged from the systemC
separate foul gases from the receiverD
purge non-condensable gases without losing refrigerant
考题
单选题The function of lubricating oil is to （）A
maintain even distribution of bearing wearB
maintain a constant oil temperatureC
maintain a pressurized film between moving surfacesD
remove entrained water
考题
单选题The separating effect of oil separator is not very good, the reason may be（）A
too little seal waterB
improper gravity discC
oil discharging pump not working very wellD
low water level of the working water
考题
单选题To minimize the formation of carbon deposits on fuel injection nozzles, you should （）A
avoid using liquid-cooled nozzles whenever possibleB
avoid low cooling water temperaturesC
avoid prolonged overloading of the engineD
make certain the gasket seal between the nozzle and cylinder head is tight
考题
单选题Coalescence is the breakdown of surface tension between oil droplets in an oil/water mixture, which causes them to join and （） in size.A
expandB
extractC
increaseD
decrease
考题
单选题In a purifier, the interface between the liquid seal and the oil should be positioned as close as possible to （）.A
the outlet of oilB
the outlet of waterC
the bowl peripheryD
the center of bowl
热门标签
最新试卷