网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
A standalone wireless AP solution is being installed into the campus infrastructure. The access points appear to boot correctly， however， wireless clients are not obtaining correct access. You verify that the local switch configuration connected to the access point appears as the following： interface ethernet 0/1 switchport access vlan 10 switchport mode access spanning-tree portfast mls qos trust dscp What is the most likely issue causing the problem？（）
- A、QoS trust should not be configured on a port attached to a standalone AP.
- B、QoS trust for switchport mode access should be defined as "cos".
- C、switchport mode should be defined as "trunk" with respective QoS.
- D、switchport access vlan should be defined as "1".
参考答案
更多 “ A standalone wireless AP solution is being installed into the campus infrastructure. The access points appear to boot correctly， however， wireless clients are not obtaining correct access. You verify that the local switch configuration connected to the access point appears as the following： interface ethernet 0/1 switchport access vlan 10 switchport mode access spanning-tree portfast mls qos trust dscp What is the most likely issue causing the problem？（）A、QoS trust should not be configured on a port attached to a standalone AP.B、QoS trust for switchport mode access should be defined as "cos".C、switchport mode should be defined as "trunk" with respective QoS.D、switchport access vlan should be defined as "1".” 相关考题
考题
1个6/6/6配置基站需要两条2M传输，两条传输分别从1.3机柜入并同时级联2机柜，则从左到右3机柜的传输级联定义方式为：（）。A、standalone、standalone、cascadeB、cascade、standalone、cascadeC、standalone、cascadE、standaloneD、cascade、cascade、standalone
考题
You are troubleshooting a one-way call problem with a cisco 7920 wireless ip phone on a standalone wlan. What may cause this problem？（）A、the minimum data rate is not set to 11 mbps.B、an address resolution protocol has been disabledC、publicly secure packet forwarding is enabledD、the access point is set to the least congested channel.
考题
You are using standalone cisco aironet 1400 series wireless bridges for a nine-mile point-to-point wireless link between two buildings. Which distance setting should you use for the bridge configured as the root？（）A、20 km [12.4 miles]B、10 km [6.2 miles]C、5 km [3.1 miles]D、25 km [15.5 miles]E、15 km [9.3 miles]
考题
The Cisco 521 Wireless Express Access Point used in the Smart Business Communications System can be configured to operate in which mode?（）A、controller-based mode onlyB、either standalone mode or controller-based modeC、standalone mode only
考题
Your computer has a wireless network adapter installed. However， the computer fails to connect to the wireless network. You need to ensure that the computer is able to connect to the wireless network. What should you do？（）A、Change the Network Category setting of the wireless connection to Public.B、Enable the Internet Connection Sharing feature on the wireless network adapter.C、Rename the wireless network adapter to match the Service Set Identifier （SSID） of the wireless network.D、Configure the wireless network adapter to connect to the appropriate wireless network from the Connect to a network list.
考题
关于三个MULTIDROP的机架且采用两对PCM，下面的IDB设置正确的是（）。A、TEI：62、61、62PCM：CASCADED STANDALONE STANDALONEB、TEI：62、61、60PCM：CASCADED STANDALONE CASCADEDC、TEI：62、61、62PCM：CASCADED STANDALONE CASCADEDD、TEI：62、61、60PCM：CASCADED STANDALONE STANDALONE
考题
You are using standalone Cisco Aironet 1400 Series Wireless Bridges for a nine-mile point-to-point wireless link between two buildings. Which distance setting should you use for the bridgeconfigured as the root？（）A、20 km [12.4 miles]B、10 km [6.2 miles]C、5 km [3.1 miles]D、25 km [15.5 miles]E、15 km [9.3 miles]
考题
You are troubleshooting a one-way call problem with a cisco 7920 wireless ip phone on a standalone wlan. What may have caused this problem？（）A、the minimum data rate is not set to 11 mbps.B、publicly secure packet forwarding is enabled.C、the access point is set to the least congested channel.D、an address resolution protocol has been disabled.
考题
Which parameter， when enabled on a standalone access point， gives the highest priority to a voice packeteven when QoS is not enabled？（）A、QoS Element for Wireless PhonesB、IGMP SnoopingC、WMMD、AVVID Priority Mapping
考题
You are troubleshooting a problem with a cisco 7920 wireless ip phone on a standalone wlan. the phone rings but， when you Answer ，the call is dropped. What may have caused this problem？（）A、publicly secure packet forwarding is enabled.B、the minimum data rate is not set to 11 mbps.C、an address resolution protocol is enabled.D、the access point is set to the least congested channel.
考题
On a standalone access point， client association using EAP-Cisco Wireless （Cisco-LEAP） isfailing， but association using EAP-PEAP is functioning. What needs to be enabled on the standalone accesspoint to correct this issue？（）A、network EAPB、open authentication plus MACC、open authentication plus EAPD、a shared key
考题
Which of the following improves wireless performance by allowing only one wireless transmissionon the network at a time?（）A、CSMA/CAB、CSMA/CDC、Wireless encryptionD、Wireless bonding
考题
Wi-Fi所指的是（）。A、Wireless FiberB、WireleInteroperability ForumInstitutionC、Wireless FrequencyIndustryD、Wireless Fidelity
考题
单选题The Cisco 521 Wireless Express Access Point used in the Smart Business Communications System can be configured to operate in which mode?（）A
controller-based mode onlyB
either standalone mode or controller-based modeC
standalone mode only
考题
单选题You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN. What may cause this problem？（）A
The minimum data rate is not set to 11 Mbps.B
An address resolution protocol has been disabledC
Publicly Secure Packet forwarding is enabledD
The access point is set to the least congested channel.
考题
单选题Which parameter， when enabled on a standalone access point， gives the highest priority to a voice packet even when qos is not enabled？（）A
igmp snoopingB
wmmC
qos element for wireless phonesD
avvid priority mapping
考题
单选题On a standalone access point， client association using EAP-Cisco Wireless （Cisco-LEAP） is failing， butassociation using EAP-PEAP is functioning. What needs to be enabled on the standalone access point tocorrect this issue？（）A
a shared keyB
network EAPC
open authentication plus EAPD
open authentication plus MAC
考题
单选题You are using standalone Cisco Aironet 1400 Series Wireless Bridges for a nine-mile point-to-point wirelesslink between two buildings. Which distance setting should you use for the bridge configured as the root？（）A
5 km [3.1 miles]B
10 km [6.2 miles]C
15 km [9.3 miles]D
20 km [12.4 miles]E
25 km [15.5 miles]
考题
单选题You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but， when you answer， the call is dropped. What may cause this problem？（）A
The minimum data rate is not set to 11 Mbps.B
An address resolution protocol is enabled.C
Publicly Secure Packet forwarding is enabled.D
The access point is set to the least congested channel.
考题
单选题In a deployment using standalone access points， clients set up to authenticate with EAP-PEAP orEAP-Cisco Wireless （Cisco-LEAP） cannot authenticate. When you inspect the Failed Attemptsreport on the Cisco Secure ACS，you find this error："Unknown network access server NAS." Which problemmayhave caused this failure？（）A
misconfigured IP address of the AAA server on the access pointB
misconfigured EAP type on the access pointC
misconfigured IP address of the access point on the AAA serverD
misconfigured EAP type on the AAA server
考题
单选题You are using standalone Cisco Aironet 1400 Series Wireless Bridges for a nine-mile point-to-point wireless link between two buildings. Which distance setting should you use for the bridgeconfigured as the root？（）A
20 km [12.4 miles]B
10 km [6.2 miles]C
5 km [3.1 miles]D
25 km [15.5 miles]E
15 km [9.3 miles]
热门标签
最新试卷