网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
What is the minimum amount of memory required for a new LPAR to be built via NIM on AIX6.1?（）
- A、128MB
- B、256MB
- C、512MB
- D、1024MB
参考答案
更多 “What is the minimum amount of memory required for a new LPAR to be built via NIM on AIX6.1?（）A、128MBB、256MBC、512MBD、1024MB” 相关考题
考题
What is the minimum amount of memory required for a new LPAR to be built via NIM on AIX 6.1?()
A.128MB.256MC.512MD.1024M
考题
What are two requirements to perform a warm Cisco IOS upgrade on a Cisco ISR router? （）(Choose two.)A、at least one enabled Ethernet interfaceB、Cisco IOS version 12.3(2)T or greaterC、enough memory to decompress the new Cisco IOS imageD、internal flash memory equaling two times the space required for the current Cisco IOS image
考题
A system administrator is creating four LPARs on a Power 550. The Power 550 has 64GB of memoryinstalled and 32GB activated. The system administrator sets the minimum dedicated memory to 8GB in the profile for each LPAR. After activating three LPARs, he is not able to activate the fourth LPAR. What is the likely cause of the problem?（）A、The Power 550 is licensed for three LPARs only.B、There is not enough memory to meet the minimum dedicated memory requirement for the fourth LPAR. A faulty memory DIMM is detected in the POWER5 550.C、There is not enough memory to meet the minimum dedicated memory requirement for the fourth LPAR. The HMC reserves some memory toperform logical partition tasks.D、There is not enough memory to meet the minimum dedicated memory requirement for the fourth LPAR. The hypervisor reserves some memory to perform logical partition tasks.
考题
On a Hardware Management Console (HMC) at version 7, an administrator has an LPAR defined with a minimum of 4GB of memory, 6GB desired and a maximum of 16 GB of memory. The administrator wants to go from 5 GB to 8 GB assigned memory for this partition. In order to make the change, what value should the administrator enter into the add processor resources window? （）A、2 B、3 C、4 D、8
考题
An administrator has implemented the following LPARs on a Power 570 with 32 GB memory with 512 MB remaining for allocation： LPAR 1 memory ： min = 10 GB des = 15 GB max = 24 GB LPAR 2memory ： min = 10 GB des = 15 GB max = 24 GB The administrator receives a request to add 2 GB to LPAR 1. The only way to do this is by moving memory from LPAR 2 to LPAR 1. The administrator attempts to move the memory， but the operation fails. The administrator can however allocate 512 MB that is free to LPAR 1 on the 570. What is the most likely cause of this failure when dynamically moving memory？（）A、 Maxperm% is set too low on LPAR 2B、 Insufficient paging space on LPAR 1C、 Service IBM.DRM is unavailable on LPAR 1D、 Insufficient pinnable memory frames available on LPAR 2
考题
A user is receiving an error about not having enough virtual memory. A technician wants to manually set the amount of available virtual memory for the computer. At a MINIMUM， the technician should set the virtual memory to be which of the following？（）A、0.5 times the amount of physical memoryB、1.5 times the amount of physical memoryC、2 times the amount of physical memoryD、Equal to the amount of physical memory
考题
In relation to the system’s Logical Memory Block （LMB） size， when creating an LPAR using Integrated Virtualization Manager （IVM）， what is the largest allocation of memory allowed？（）A、 128MBB、 256MBC、 512MBD、 1024MB
考题
A customer wants to add a new application to their existing IBM System Storage DS5300. Theyexpect that the new application will require a minimum of 15，000 additional IOPS. What toolshould be used to determine what additional disk is required to effectively add the newapplication？（）A、eConfigB、Disk MagicC、Capacity MagicD、Tivoli Storage Productivity Center for Data
考题
What is the minimum recommended amount of memory that can be assigned to a new VIO server？（）A、128MBB、256MBC、512MBD、1GB
考题
A System p customer is planning to implement virtualization and is concerned about how to respond to an increased workload and what limitations there are for very small workloads. Which of the following describes the minimum size for an LPAR and the minimum amount that can be transferred from on LPAR to another（）A、Smallest partition 10% of all available processors， as small as 1% of all available processors may be transferred.B、Smallest partition 10% of a processor， as small 1% of a processor may be transferred.C、Smallest partition one processor， as small 1% of a processor may be transferred.D、Smallest partition one core， as small 10% of a processor may be transferred.
考题
After purchasing the Active Memory Expansion （AME） Enablement Feature，what tasks must be completed before AME can be used？（）A、Enable using active partition properties with DLPARB、Enter the activation key via the AIX 6.1 command line and reboot AIXC、Enter the activation key via the HMC,power cycle the managed system and start the LPARD、Enter the activation key via the HMC,modify the partition profile and restart the LPAR
考题
For NIM to install client machines located in a non-adjacent network， which routing must be defined？（） A、Boot/install servers will be required on each intermediate network.B、When an install is initiated by the client， routing is only required from the LPAR back to the NIM master.C、When an install is initiated by the NIM master， routing is only required from the NIM master to the client.D、Appropriate network NIM resources need to be defined to the NIM master to allow routing in both directions.
考题
What is the minimum amount of memory required for a new LPAR to be built via NIM on AIX6.1（）？ A、128 MBB、256 MBC、512 MBD、1024 MB
考题
An application vendor wants to choose a fault tolerant platform for their new application. The application benefits from multiple processors and has been tested on Red Hat Advanced Server 3. To determine the memory requirements for the application， which of the following is the best procedure？（）A、The application should be tested and baselines should be measured with simulated user loads.B、The application should be tested with the minimum amount of memory then increase the memory in increments until an acceptable response is achieved.C、The application should be tested with differing amounts of memory and the fastest response time is reached it should be used as the acceptable configuration.D、The application should be tested with the maximum amount of memory then decrease the memory in increments until an acceptable price/performance ratio is reached.
考题
What is the minimum amount of memory required for a new LPAR to be built via NIM on AIX 6.1?（）A、128MB、256MC、512MD、1024M
考题
What are the advantages of variable extent size support for large ASM files?（）A、It improves resync operations when the disk comes online after being taken offline for maintenance purposes. B、It improves performance in the extended cluster configuration by reading from a local copy of an extent. C、Fewer extent pointers are needed to describe the file and less memory is required to manage the extent maps in the shared pool.D、This feature enables faster file opens because of the reduction in the amount of memory that is required to store file extents.
考题
单选题An administrator has implemented the following LPARs on a Power 570 with 32 GB memory with 512 MB remaining for allocation： LPAR 1 memory ： min = 10 GB des = 15 GB max = 24 GB LPAR 2memory ： min = 10 GB des = 15 GB max = 24 GB The administrator receives a request to add 2 GB to LPAR 1. The only way to do this is by moving memory from LPAR 2 to LPAR 1. The administrator attempts to move the memory， but the operation fails. The administrator can however allocate 512 MB that is free to LPAR 1 on the 570. What is the most likely cause of this failure when dynamically moving memory？（）A
Maxperm% is set too low on LPAR 2B
Insufficient paging space on LPAR 1C
Service IBM.DRM is unavailable on LPAR 1D
Insufficient pinnable memory frames available on LPAR 2
考题
单选题In relation to the system’s Logical Memory Block （LMB） size， when creating an LPAR using Integrated Virtualization Manager （IVM）， what is the largest allocation of memory allowed？（）A
128MBB
256MBC
512MBD
1024MB
考题
单选题What is the minimum recommended amount of memory that can be assigned to a new VIO server？（）A
128MBB
256MBC
512MBD
1GB
考题
单选题What is the minimum amount of memory required for a new LPAR to be built via NIM on AIX6.1?（）A
128MBB
256MBC
512MBD
1024MB
考题
单选题A user is receiving an error about not having enough virtual memory. A technician wants to manually set the amount of available virtual memory for the computer. At a MINIMUM， the technician should set the virtual memory to be which of the following？（）A
0.5 times the amount of physical memoryB
1.5 times the amount of physical memoryC
2 times the amount of physical memoryD
Equal to the amount of physical memory
考题
单选题On a Hardware Management Console (HMC) at version 7, an administrator has an LPAR defined with a minimum of 4GB of memory, 6GB desired and a maximum of 16 GB of memory. The administrator wants to go from 5 GB to 8 GB assigned memory for this partition. In order to make the change, what value should the administrator enter into the add processor resources window? （）A
2 B
3 C
4 D
8
考题
单选题What is the minimum amount of memory required for a new LPAR to be built via NIM on AIX6.1（）？A
128 MBB
256 MBC
512 MBD
1024 MB
热门标签
最新试卷