单选题A new system has been installed and the network connection is very slow. The network administrators are sure that the network port is set to 100 full duplex. What command will display the configured and current speed settings of the adapter?（）A lsdevB lsattrC entstatD ifconfig

考题 An administrator has just installed a new NIC into the server. The system POSTs fine and the NIC is recognized by the OS, but it does not receive an IP address. Which of the following is the MOST likely cause of this?（）A. The NIC is not on the HCL.B. The driver is incorrect on the server.C. The patch cable has not been seated properly.D. The NIC is not seated properly.

查看答案

考题 What is the cause of the error？（）A、 Missing control VLAN in VSM configurationB、 Missing packet VLAN in VSM configurationC、 VSM has no network connection to vCenterD、 VSM extension key is not installed on vCenterE、 vCenter extension key is not installed on VSM

查看答案

考题 A switch that is to be added to the production network has been preconfigured （trunks， VLANs， VTP， and STP） and was tested in your lab. After installing the switch into the network， the entire network went down. What might explain what happened？（）A、The new switch happened to be running Cisco Catalyst operating system， while the other network switches were running Cisco IOS Software.B、The configuration revision of the new switch was higher than the configuration revision of the production VTP domain.C、The link costs on the new switch are set to a high value， causing all ports on the new switch to go into a forwarding mode and none into blocking mode， thereby causing a spanning-tree loop.D、The ports connecting to the two switches have been configured incorrectly. One side has the command switchport mode access and the other switchport mode trunk.

查看答案

考题 An administrator has added a new device to a system and wants to determine if it has been correctly added to the ODM database. Which command would the system administrator use？（）A、odmgetB、odmaddC、odmshowD、odmcreate

查看答案

考题 Company.com with a newly installed cluster has been checking the logfiles to determine if the cluster has had any recent activity. The non-IP RS232 heartbeat connection seems to be having a difficulty. The serial network goes down，and then a couple of minutes later comes back up again. This pattern is repeated many times in the log. If this system was installed without regard to best practices， what is the most likely problem with the serial network？（） A、 The serial port is malfunctioning and needs to be repaired.B、 The baud rate is incorrectly specified in the AIX devices configuration.C、 The serial port is not a port approved to support HACMP heartbeat traffic.D、 The baud rate is incorrectly specified in the HACMP interface configuration.

查看答案

考题 The technician has suspicions that a browser has been hijacked. Which of the following should the technician look for in this situation?（）A、A new default gateway has been setup.B、A new Internet shortcut has been added.C、A new web browser has been installed and is now the default.D、A proxy server has been enabled.

查看答案

考题 An administrator has just installed a new NIC into the server. The system POSTs fine and the NIC is recognized by the OS, but it does not receive an IP address. Which of the following is the MOST likely cause of this?（）A、The NIC is not on the HCL.B、The driver is incorrect on the server.C、The patch cable has not been seated properly.D、The NIC is not seated properly.

查看答案

考题 A new server was installed for the purpose of monitoring network traffic. The network has been configured in such a way that all traffic will be mirrored out the port this server is connected to. When reviewing the network traffic logs on the server only traffic destined to the server is listed in the logs. Which of the following is preventing the server from seeing all network traffic?（）A、NIC filtering is enabled.B、Port security is configured.C、NIC is not in promiscuous mode.D、NIC is in promiscuous mode.

查看答案

考题 A customer has installed a new computer on their network. They can print to the printer but the option for duplex printing is not available. All other computers have the option. Which of the following is the cause of the problem？（）A、The new computer is printing to the wrong IP address.B、The new computer is using the wrong protocol.C、The driver port is not setup correctly.D、The option has not been selected on the driver.

查看答案

考题 A customer has just purchased six x346 servers running Windows 2003 Web Edition.They are expecting to add six additional x346’s in three months.They have a requirement to automatically deploy the current server image upon the new servers. What TWO actions are required to complete this task？（）A、Ensure Director Agent is installed on the new servers.B、Ensure a DHCP Sever is installed and configured in the environment.C、Ensure Server Plus Pack option has been installed and configured.D、Ensure Software Distribution has been installed on the IBM Director Server and an image has been created.E、Ensure Remote Deployment Manager has been installed on the IBM Director Server and an image has been created.

查看答案

考题 A new system has been installed and the network connection is very slow. The network administrators are sure that the network port is set to 100 full duplex. What command will display the configured and current speed settings of the adapter?（）A、lsdevB、lsattrC、entstatD、ifconfig

查看答案

考题 A customer has 5 older POWER5 systems and they want to consolidate them onto a POWER6 system. What information is important to analyze when deciding how to design the new machine using the System Planning Tool?（）A、 vmstat and iostat data from the older machines B、 The number of CPUs that were installed in the original machines C、 Data from Workload Estimator (WLE) and IBM Performance Management (PM) D、 Performance data that is collected from the new system after it has been put into production

查看答案

考题 What is a design consideration when using existing PCIe I/O drawers in a maximum bandwidth/throughput configuration on a new Power 750 system?（）A、The new system requires 1 installed processor card for the GX++ bus adapterB、The new system requires a minimum of 2 installed processor cards for the GX++ bus adapterC、The new system requires a minimum of 3 installed processor cards and the HPC InfiniBand cluster adapterD、The new system requires 1 installed processor card for the GX++ bus adapter and the HPC InfiniBand cluster adapter

查看答案

考题 Your company has a network that has 100 servers. You install a new server that runs Windows Server 2008. The server has the Web Server （IIS） role installed. You discover that the Reliability Monitor has no data， and that the system stablitiy chare has never been updated. You nede to configure the server to collect the reliability monitor data. What should you do（）？ A、Run the perfmon.exe /sys command on the serverB、Configure the Task schduler service to start automaticallyC、configuyre the Remote Registry serice to start automaticallyD、configure the Secondary Login service to start automatically.

查看答案

考题 You work as the IT professional in an international company which is named Wiikigo. You are experiencedin implementing and administering a network operating system. You are specialized in deploying servers，configuring Windows Server 2008 Terminal services and network application services， and configuring aweb services infrastructure. There is a server in your company. Windows Server 2008 is run by the serverand the server has the Hyper-V server role installed.A new virtual machine is created. You are required to configure the virtual machine， and the requirements listed below should be satisfied.First， network communications should be permitted between the virtual machine and the host system.Second， communications should be prevented with other network servers. To achieve the goal，which action should be performed first？（）A、To achieve the goal， the Connection should be set to None for the network interface card.B、To achieve the goal， the Microsoft Loopback Adapter should be installed.C、To achieve the goal， a new Virtual Network should be created.D、To achieve the goal， Internet Connection Sharing （ICS） should be enabled.

查看答案

考题单选题Company.com with a newly installed cluster has been checking the logfiles to determine if the cluster has had any recent activity. The non-IP RS232 heartbeat connection seems to be having a difficulty. The serial network goes down，and then a couple of minutes later comes back up again. This pattern is repeated many times in the log. If this system was installed without regard to best practices， what is the most likely problem with the serial network？（）A The serial port is malfunctioning and needs to be repaired.B The baud rate is incorrectly specified in the AIX devices configuration.C The serial port is not a port approved to support HACMP heartbeat traffic.D The baud rate is incorrectly specified in the HACMP interface configuration.

查看答案

考题单选题Purging air from a hydraulic system is necessary when（）A adding small amounts of oil to the systemB the system has been overheatedC the system has been drained and then filled with new oilD the system has been idle for a long period of time

查看答案

考题单选题A customer has installed a new computer on their network. They can print to the printer but the option for duplex printing is not available. All other computers have the option. Which of the following is the cause of the problem？（）A The new computer is printing to the wrong IP address.B The new computer is using the wrong protocol.C The driver port is not setup correctly.D The option has not been selected on the driver.

查看答案

考题单选题What is a design consideration when using existing PCIe I/O drawers in a maximum bandwidth/throughput configuration on a new Power 750 system?（）A The new system requires 1 installed processor card for the GX++ bus adapterB The new system requires a minimum of 2 installed processor cards for the GX++ bus adapterC The new system requires a minimum of 3 installed processor cards and the HPC InfiniBand cluster adapterD The new system requires 1 installed processor card for the GX++ bus adapter and the HPC InfiniBand cluster adapter

查看答案

考题单选题What is the cause of the error？（）A Missing control VLAN in VSM configurationB Missing packet VLAN in VSM configurationC VSM has no network connection to vCenterD VSM extension key is not installed on vCenterE vCenter extension key is not installed on VSM

查看答案

考题单选题You have a server that runs Windows Server 2008 and has the Windows Server Virtualization （WSv） server role installed. You create a new virtual machine. You need to configure the virtual machine to meet the following requirements： Allow network communications between the virtual machine and the host system. Prevent communications with other network servers. What should you do first？（）A Install the Microsoft Loopback Adapter.B Create a new Virtual Network Switch.C Enable Internet Connection Sharing （ICS）.D Set the Connection to None for the network interface card.

查看答案

考题单选题A just announced two-port Ethernet card has been installed on a system and it is not recognized. On the HMC the slot shows empty. The device driver has been installed and cfgmgr runs normally. What is the most appropriate action to solve this problem?（）A Update the HMC softwareB Update the system firmwareC Re-install the device driverD Flash update the two-port card

查看答案

考题单选题A new asynchronous connection is being installed in your network. Which pair of WAN encapsulations types is suitable for asynchronous lines?（）A PPP and ATMB PPP and SDLCC ATM and HDLCD SDLC and HDLC

查看答案

考题单选题You work as the IT professional in an international company which is named Wiikigo. You are experiencedin implementing and administering a network operating system. You are specialized in deploying servers，configuring Windows Server 2008 Terminal services and network application services， and configuring aweb services infrastructure. There is a server in your company. Windows Server 2008 is run by the serverand the server has the Hyper-V server role installed.A new virtual machine is created. You are required to configure the virtual machine， and the requirements listed below should be satisfied.First， network communications should be permitted between the virtual machine and the host system.Second， communications should be prevented with other network servers. To achieve the goal，which action should be performed first？（）A To achieve the goal， the Connection should be set to None for the network interface card.B To achieve the goal， the Microsoft Loopback Adapter should be installed.C To achieve the goal， a new Virtual Network should be created.D To achieve the goal， Internet Connection Sharing （ICS） should be enabled.

查看答案

考题单选题A customer has 5 older POWER5 systems and they want to consolidate them onto a POWER6 system. What information is important to analyze when deciding how to design the new machine using the System Planning Tool?（）A vmstat and iostat data from the older machines B The number of CPUs that were installed in the original machines C Data from Workload Estimator (WLE) and IBM Performance Management (PM) D Performance data that is collected from the new system after it has been put into production

查看答案

考题单选题An administrator has just installed a new NIC into the server. The system POSTs fine and the NIC is recognized by the OS, but it does not receive an IP address. Which of the following is the MOST likely cause of this?（）A The NIC is not on the HCL.B The driver is incorrect on the server.C The patch cable has not been seated properly.D The NIC is not seated properly.

查看答案

考题单选题Your company has a network that has 100 servers. You install a new server that runs windows server 2008. The server has the web server (IIS) role installed. You discover that the reliability monitor has no data, and that the system stablitiy share has never been updated. You need to configure the server to collect the reliability monitor data. What should you do?（）A Run the perfmon.exe /sys command on the server.B Configure the task scheduler service to start automatically.C Configure the remote registry serice to start automatically.D Configure the secondary login service to start automatically.

查看答案

考题单选题The technician has suspicions that a browser has been hijacked. Which of the following should the technician look for in this situation?（）A A new default gateway has been setup.B A new Internet shortcut has been added.C A new web browser has been installed and is now the default.D A proxy server has been enabled.

查看答案

网友您好， 请在下方输入框内输入要搜索的题目：

网友您好，请在下方输入框内输入要搜索的题目：