网友您好, 请在下方输入框内输入要搜索的题目:

题目内容 (请给出正确答案)
单选题
The engine may lose power or slow down during running, when this occurs, the first cause possible may be hot bearings and () of the pistons in the cylinders.
A

crack

B

knocking

C

leaking

D

seizure


参考答案

参考解析
解析: 暂无解析
更多 “单选题The engine may lose power or slow down during running, when this occurs, the first cause possible may be hot bearings and () of the pistons in the cylinders.A crackB knockingC leakingD seizure” 相关考题
考题 单选题以下选项中,属于船舶构造和设备要求的检查的是()。A 现场集合B 载重线检查C 防护服穿戴D 油污应急计划检查

考题 单选题直航船未鸣放“五短声”怀疑警告声号,即独自采取操纵行动,以避免碰撞的做法,是:()A 对遵守《国际海上避碰规则》各条的疏忽B 对海员通常做法可能要求的任何戒备上的疏忽C 对特殊情况可能要求的任何戒备上的疏忽D 该做法并无违背《国际海上避碰规则》之处,是符合通常做法的

考题 判断题巡洋舰型尾仅用于巡洋舰上。A 对B 错

考题 单选题The crank throws are displaced from () to obtained the same number of degrees between the different crank throws.A one anotherB the otherC each otherD each others

考题 单选题一空心圆轴,两端受扭转力偶作用,若将轴的截面积增加一倍,内外径之比不变,则其抗扭刚度变为原来的()倍。A 16B 8C 4D 2

考题 单选题In order to properly remove air from the casing of a centrifugal pump when starting, the pump should have a ().A positive headB negative suction headC mechanical sealD vent valve attached to the casing at the top of the volute

考题 单选题精研时选用较细的研磨剂,较小的压力和较高的研磨速度是为了()。A 切削均匀B 迅速消除误差C 提高效率D 提高精度

考题 单选题The inner part of the condenser should be cleaned with ().A gas oilB diesel oilC chemical compoundD Freon-12

考题 单选题在NAKAKITA型燃油黏度控制系统中,若测黏计毛细管中间部位破损,则系统的故障现象为()。A 对柴油程序加温到上限值B 对重油进行油温上限值的定值控制C 重油黏度不断升高D 重油黏度不断降低

考题 单选题下列关于船舶证书说法正确的是()。 Ⅰ.展期的期限一律不得超过5个月; Ⅱ.未经展期的证书,给予最多1个月的宽限期限; Ⅲ.已经展期过的证书不得再展期。A Ⅰ+ⅢB Ⅱ+ⅢC Ⅱ+ⅢD 仅仅Ⅰ对

考题 单选题The transmission time duration of a single pulse of radio-frequency energy is a function of the().A persistenceB pulse repetition rateC pulse lengthD resolution

考题 单选题关于船舶进坞操纵,下列哪个说法正确。() Ⅰ进坞操纵掌握船在坞门外船位很关键 Ⅱ在静水港主要考虑风的影响 Ⅲ在潮流港一般浮船坞与流向垂直 Ⅳ在潮流港一般干船坞与流向垂直A Ⅰ~ⅣB Ⅰ~ⅢC Ⅰ、ⅡD Ⅰ、Ⅱ、Ⅳ

考题 单选题衰减率小的控制系统,说明系统的()。A 稳定性差B 稳定性好C 动态精度高D 静态精度高

考题 单选题How would you pass a red buoy in the maritime buoyage system “A”? ()A keep the buoy on the vessel's starboard side when approaching a port and on the vessel's port side when leavingB keep the buoy on the vessel's port side when approaching a port and on the vessel's starboard side when leavingC keep the buoy on the vessel's starboard side when approaching and leavingD keep the buoy on the vessel's port side when approaching and leaving

考题 问答题单吸式螺杆泵工作时所产生的轴向力是怎样平衡的?

考题 单选题齿面的点蚀的失效机理属于()。A 腐蚀B 磨损或腐蚀C 疲劳D 疲劳或磨损

考题 单选题大地水准面与以下哪个面相吻合?()A 地球自然表面B 地球椭圆体表面C 地球椭球体表面D 平均海面

考题 单选题水上移动业务标识MMSI为412345670是船舶电台的().A 国内型式B 区域型式C 全球型式D 群呼型式

考题 单选题动画文件辅机空压机循环,动画演示了单级压缩理论循环图,过程线1-2,1-2’1-2〞分别代表不同的压缩过程,如果是多变压过程,应使用()表示。A 1-2〞B 1-2’C 1-2D 无正确答案

考题 单选题值班水手应经谁的同意方可使用自动舵()。A 船长B 大副C 值班驾驶员D A或C

考题 单选题在采用比例调节器组成的控制系统受到扰动后,系统达到新的平衡状态时,调节器的输入为()。A 0B 给定值rC 静态偏差εD 测量值z

考题 单选题要使并联运行中的交流发电机输出有功功率增加,需()。A 开大油门B 减小励磁C 增加励磁D 减小油门

考题 单选题有关雷达的使用,下列说法正确的是()A 天气良好时,只要有可能,值班驾驶员应进行雷达方面的操练B 在能见度不良时,正确地使用雷达包括进行远距离的扫描和对观测到的物标进行雷达或与其相当的系统观测C A、B均正确D A、B均不正确

考题 单选题我国滑油质量指标中的酸值是指滑油中的()A 总酸值B 强酸值C 有机酸含量D 无机盐含量

考题 单选题1966年国际载重线公约不适用于长度小于()米的新船和小于()总吨的现有船舶。A 24/150B 2/500C 79/54D 50/400

考题 单选题回转机构的泵控制半闭式液压系统所用低压选择阀通常是()换向阀。A 三位四通B 三位三通C 二位二通D 二位三通

考题 单选题船舶锚设备按照链节在整根锚链中所处位置的不同,可分为()。 ①锚端链节; ②中间链节; ③末端链节A ①②③B ①②C ①③D ②③

考题 单选题载重线公约要求()。A 船舶在始发港应满足所适用的载重线B 船舶在目的港应满足所适用的载重线C 船舶在中途港应满足所适用的载重线D 船舶在整个航程都应满足所适用的载重线