网友您好, 请在下方输入框内输入要搜索的题目:
题目内容
(请给出正确答案)
单选题
The temperature of a refrigerant gas is the highest ().
A
at the compressor discharge
B
at the compressor suction
C
in the expansion valve
D
in the receiver
参考答案
参考解析
解析:
暂无解析
更多 “单选题The temperature of a refrigerant gas is the highest ().A at the compressor dischargeB at the compressor suctionC in the expansion valveD in the receiver” 相关考题
考题
The temperature of the refrigerant in the evaporator coil depends mostly upon the ___.A.refrigerant pressure in the evaporatorB.cooling water temperature to the condenserC.heat load in the refrigerator compartmentD.solenoid valve in the liquid line
考题
The expansion valve used in a refrigeration system regulates theA.superheat of the gas leaving the compressorB.back pressure in the evaporatorC.temperature in the refrigerated spaceD.degree of superheat of the gas leaving the evaporator
考题
If the superheat value of a thermostatic expansion valve is set too low, the _.A.the suction line will be abnormally cold and liquid may slug back to the compressorB.the suction line will be hot due to a reduced amount of refrigerant returning to the compressorC.the temperature of the refrigerant within the condenser will remain the sameD.the temperature of the refrigerant passing through the sub-cooler will decrease
考题
Sub-cooling is a method of reducing the temperature of the liquid refrigerant below its ______.A.freezing pointB.floc point(浊点)C.condensing temperatureD.compression temperature
考题
Which statement about inert gas pressures in a cargo tank is TRUE ________.A.The pressures of the inert gas in the tank may create excessive pressure at the pump while dischargingB.Gas pressures should be maintained at the highest permissible level throughout the discharging processC.High gas pressures may cause pyrophoric oxidation in the tankD.High gas pressures may cause loss of suction when stripping
考题
单选题When the temperature of the refrigerant flowing out from the condenser is below the condensing temperature, it is said to be ().A
dryB
wetC
super-cooledD
superheated
考题
单选题Each inert gas system gas main must have an automatic shut down valve at the outlet of the gas production plant. This valve must close automatically upon().A
cargo pump failureB
blower failureC
deck seal low water levelD
low inert gas temperature
考题
单选题An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by ().A
restriction in refrigerant pipingB
air and non-condensable gases in the condenserC
water in the refrigerantD
flooding back of liquid refrigerant from the evaporator
考题
单选题For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?()A
the temperature and flow quantity of the exhaust gas from M.EB
the quantity of steam demandedC
the rotary speed and the cooling water temperature of main engineD
efficiency of M.E turbocharger
考题
单选题In the condenser, the hot, high pressure refrigerant gas is cooled by the sea water and becomes().A
fresh waterB
vaporC
mixtureD
liquid
考题
单选题Water evaporates or steam condenses at the saturation temperature, which depends upon the pressure, the higher the pressure () the saturation temperature.A
the moreB
the higherC
the lowerD
the highest
考题
单选题In the combustion chamber, the part whose surface is exposed to the highest temperature is the ().A
cylinder linerB
cylinder coverC
pistonD
exhaust valve
考题
单选题If a liquid sight flow indicator in a refrigeration system shows gas bubbles in motion passing inside of the glass, there is ().A
too much refrigerant in the systemB
oil entrained in the refrigerantC
less than a full charge of refrigerant in the systemD
ice crystals forming in the refrigerant
考题
单选题The refrigerant gas returning to the compressor should be ().A
superheatedB
saturatedC
denseD
flooded
考题
单选题A pressure drop through the refrigerant liquid line may cause ().A
solenoid valve to seizeB
compressor to huntC
formation of flash gas in the liquid lineD
expansion valve to freeze open
考题
单选题The saturation temperature of the refrigerant must be () that required in the evaporator refrigerated space.A
aboveB
belowC
equal toD
None of the above
考题
单选题The temperature of the refrigerant in the evaporator coil depends mostly upon the ().A
refrigerant pressure in the evaporatorB
cooling water temperature to the condenserC
heat load in the refrigerator compartmentD
solenoid valve in the liquid line
考题
单选题A refrigerant with oil in solution has a ().A
higher boiling temperature for a given pressure than does a pure refrigerantB
lower boiling temperature for a given pressure than does a pure refrigerantC
boiling pressure equal to that of a pure refrigerant at a given pressureD
boiling point will not be affected by entrained oil
考题
单选题In a compression refrigeration plant the hot, high pressure refrigerant gas is cooled by the sea water and becomes liquid in the ().A
compressorB
condenserC
throttle valveD
evaporator
考题
单选题In terms of pressure and temperature in the refrigerant in the compressor, what happens to the primary?()A
its pressure and temperature are both loweredB
its pressure and temperature are both raisedC
its pressure is lowered and its temperature is raisedD
its pressure is raised and its temperature is lowered
考题
单选题Both the temperature and the pressure of the refrigerant are increased in the ().A
compressorB
condenserC
evaporatorD
expansion valve
考题
单选题The refrigerant leaves the evaporator of a refrigeration system as a low pressure ().A
sub-cooled liquidB
high temperature liquidC
oil saturated liquidD
superheated vapor
考题
单选题Which of the listed statements is a characteristic of the liquid charged power element used with thermostatic expansion valves?()A
At the designed operating temperature, the liquid refrigerant charge has changed to a vaporB
The liquid refrigerant tends to collect at the bellows or diaphragm and reduces the valve sensitivityC
The sensing bulb is empty of liquid refrigerant charge at the designed operating temperatureD
The sensing bulb is never emptied of liquid refrigerant under normal operating conditions
考题
单选题Sub-cooling is a method of reducing the temperature of the liquid refrigerant below its ().A
freezing pointB
floc pointC
condensing temperatureD
compression temperature
考题
单选题For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?()A
the temperature and flow quantity of the exhaust gas from M/EB
the quantity of steam demandedC
the rotary speed and the cooling water temperature of main engineD
efficiency of M/ turbocharger
考题
单选题If the compressor-discharge temperature is higher than the receiver temperature()A
increase the amount of cooling water to the condenserB
decrease the amount of cooling water to the condenserC
add more refrigerant to the systemD
remove some of the refrigerant from the system
热门标签
最新试卷