网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
单选题
A gate valve installed in a pipeline should be （）.
A
used in either the fully dosed or fully opened position
B
installed with the stem down
C
used for steam service only
D
used to throttle or regulate the flow of liquid
参考答案
参考解析
解析：
暂无解析
更多 “单选题A gate valve installed in a pipeline should be （）.A used in either the fully dosed or fully opened positionB installed with the stem downC used for steam service onlyD used to throttle or regulate the flow of liquid” 相关考题
考题
If the head pressure of a reciprocating refrigeration compressor is excessiveA.the relief valve should open before the high pressure cutoutB.the relief valve should open and allow the excess refrigerant to flow to the receiverC.the high pressure cutout switch should operate before the relief valve opensD.you should close the discharging valve
考题
To add refrigerant to the low side of an air conditioning system, the refrigerant should be introduced through the_______ .A.suction service valve as a vaporB.suction service valve as a liquidC.discharge service valve as a vaporD.charging valve as a liquid
考题
In the piping systems of a vessel，what type of valve gives the least resistance to fluid flow when fully open ________．A.Globe valveB.Butterfly valveC.Gate valveD.Packless valve
考题
What is an advantage of a gate valve over a butterfly valve ________．A.Less frequent maintenanceB.Faster operationC.CheaperD.More compact
考题
单选题When operating the air supply system in a covered lifeboat the（）.A
fuel supply valve should be closedB
hatches，doors，and oar ports should be closedC
air cylinder shut-off valve should be closedD
engine should be shut off
考题
单选题If a refrigeration system compressor crankcase is sweating, you should （）.A
add refrigerant to the systemB
adjust the thermal expansion valve to the proper settingC
adjust the float valve to the proper holding pressureD
open the hand expansion valve
考题
单选题Which of the valves listed should be used either in the fully opened or the fully closed position?（）A
A gate valveB
A globe valveC
Any check valveD
Any needle valve
考题
单选题If a hydraulic governor has been refilled with oil, the engine should be operated until it reaches normal temperaturethen the air should be purged, and the（）A
rack position should be adjustedB
compensating needle valve should be opened fully compensatingC
needle valve should be adjusted to stabilize operationD
speed limiting device should be adjusted
考题
单选题In readying an auxiliary water-tube boiler for a routine hydrostatic test, which of the following procedures should be undertaken prior to filling the boiler with fresh water?（）A
The safety valve escape piping should be disconnected from the valve body and a blank insertedB
The boiler vent valves should be openedC
All handhole/manhole covers should be tightened up as much as possible to preclude any leaksD
All of the above
考题
单选题A single fitting installed in a pipeline that either blanks off the pipe or allows a full flow passage of a liquid through the pipe is referred to as a（）.A
blind flangeB
pivot couplingC
quick-release couplingD
spectacle flange
考题
单选题Fire protection regulations for towing vessels require any fuel line subject to internal head pressure from fuel in the tank to（）.A
be fitted with a positive fuel shut-off valve located at the tankB
have a shut-off valve at the top of the tankC
have a gate valve easily accessible in the space where the tank is locatedD
have a drain cock at the lowest point in the fuel line
考题
单选题Unlike the globe valve, gate valves give full bore flow without change of direction, such a valve is not suitable to partially open operationAccording to the above sentence, which of the following statements is not true?（）A
The globe valve may be suitable for partially open operationB
The globe valve will give full bore flow with change of directionC
The gate valve gives full bore flow with change of directionD
The gate valve is suitable for full bore operation only
考题
单选题If the head pressure of a reciprocating refrigeration compressor is excessive, （）.A
the relief valve should open before the high pressure cutoutB
the relief valve should open and allow the excess refrigerant to flow to the receiverC
the high pressure cutout switch should operate before the relief valve opensD
you should close in on the suction valve
考题
单选题The valve which is most suited for regulating the flow through a pipeline is a （）A
gate valveB
globe valveC
swing-check valveD
plug-cock valve
考题
单选题The valve best suited for throttling gas or liquid flow in a pipeline is the（）.A
gate valveB
globe valveC
check valveD
plug cock
考题
单选题If the head pressure is too high,（）A
the relief valve should open before the high-pressure cutoutB
the relief valve should open and let excess refrigerant go to receiverC
the high-pressure cutout switch should operate before the relief valve opensD
close in on the suction valve
考题
单选题Which of the listed statements is correct concerning the starting of centrifugal pumps?（）A
They should always be started with the discharge valve closedB
They should always be started with the discharge valve openedC
A priming pump is always required to flood the impeller suctionD
They should always be started with the sealing line valves closed
考题
单选题After fuel tanks have been topped off, which of the listed procedures should be followed next?（）A
The pressure-vacuum relief valve should be resetB
The tanks should be made seaworthy to prevent contaminationC
The tanks should be sounded to make sure the levels are not risingD
The tanks should be marked with a bull stamp on the manifold filling valve
考题
单选题A relief valve for a cargo pump is generally installed（）.A
after the discharge valveB
between the pump and discharge valveC
after the suction valveD
between the pump and suction valve
考题
单选题To add refrigerant to the low side of an air conditioning system, the refrigerant should be introduced through the （）A
suction service valve as a vaporB
suction service valve as a liquidC
discharge service valve as a vaporD
charging valve as a liquid
考题
单选题To add refrigerant to the high side of an air conditioning system, you should introduce the refrigerant through the （）.A
discharge service valve as a vaporB
suction service valve as a liquidC
charging valve as a liquidD
condenser purge valve as a vapor
考题
单选题A solenoid valve used in a refrigeration system should be installed （）.A
with the axis of the solenoid horizontal, sensing temperature of the box, and upstream of the thermal expansion valveB
upright, sensing temperature of the box, and upstream of the thermal expansion valveC
upright, sensing temperature of the box, and downstream of the thermal expansion valveD
upright, sensing heat of the tail coil, and upstream of the thermal expansion valve
考题
单选题To maintain the down stream pressure within defined limits over a range of flow and despite any changes in supply pressure, （） is fitted.A
a check valveB
a gate valveC
a pressure reducing valveD
a quick closing valve
考题
单选题A swing check valve is used in a pipeline to （）.A
maintain a preset pressure on the lineB
closely regulate the amount of flowC
relieve excessive pressure on the lineD
allow flow in one direction only
考题
单选题Vessels should not anchor or trawl in the vicinity of pipelines and are（）.in the pipeline area shown on the chart.A
prohibit to anchorB
prohibited to anchorC
not to anchorD
prohibited from anchoring
考题
单选题The major difference between the discharge and suction valves installed in most low pressure, reciprocating air compressors is that（）A
one valve seats upwards, while the other seats downwardsB
the reed valves used on the discharge are made substantially thicker and heavier than the suction valvesC
the suction valve springs exert a greater tension than the discharge valve springsD
the discharge valve springs exert a greater tension than the suction valve springs
考题
单选题During the dock repair, each sea valve must be disassembled, cleaned and ground well.Before it reassemble the sealing surface between the valve and the valve seat should be checked by （）A
chief engineerB
surveyorC
the engineerD
the technique personnel of the shipyard
热门标签
最新试卷