网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
What will an Ethernet switch do if it receives a unicast frame with a destination MAC that is listed in the switch table()。
A.The switch will not forward unicast frames.
B.The switch will forward the frame to a specific port.
C.The switch will return a copy of the frame out the source port.
D.The switch will remove the destination MAC from the switch table.
E.The switch will forward the frame to all ports except the port on which it was received.
参考答案
更多 “ What will an Ethernet switch do if it receives a unicast frame with a destination MAC that is listed in the switch table()。 A.The switch will not forward unicast frames.B.The switch will forward the frame to a specific port.C.The switch will return a copy of the frame out the source port.D.The switch will remove the destination MAC from the switch table.E.The switch will forward the frame to all ports except the port on which it was received. ” 相关考题
考题
What are two characteristics of "store and forward" switching? (Select two answer choices)A．Latency fluctuates regardless of frame. size.B．The switch receives the complete frame. before beginning to forward it.C．Latency through the switch varies with frame. length.D．The switch checks the destination address upon receipt of headers.
考题
A Ezonexam Ethernet switch receives a unicast frame. with a destination MAC that is listed in the switch table. What will this switch do with the frame?A. The switch will forward the frame. to a specific portB. The switch will forward the frame. to all ports except the port on which it was receivedC. The switch will return a copy of the frame. out the source portD. The switch will not forward unicast framesE. The switch will remove the destination MAC from the switch tableF. None of the above.
考题
What information is used by a switch to forward an Ethernet frame to its destination?()
A. IP addressB. destination MAC addressC. ARP table entryD. FCS checksum
考题
After connecting a PC to an available port on a switch, you find that the PC can not access any of the resources on the LAN. No other PC's connected to the switch appear to be having any issues. What is the most likely cause for this problem?A．The router lacks a routing table entry for the new hostB．The host switch port is assigned to the incorrect VLANC．The host MAC address is incorrectly configuredD．A STP instance for the new host has not been initializedE．The switch does not have the MAC address hard coded in the CAM table.
考题
What does a Layer 2 switch use to decide where to forward a received frame?()
A. source MAC addressB. source IP addressC. source switch portD. destination IP addressE. destination port addressF. destination MAC address
考题
Refer to the exhibit A frame on vlan 1 on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?()
A.trunk mode mismatchesB.vlans that do not correspond to a unique IP subnetC.native vlan mismatchesD.allowing only vlan 2 on the destination.
考题
If a switch is working in the fail-open mode， what will happen when the switch’s CAM table fills to capacityand a new frame arrives？（）A、A copy of the frame is forwarded out all switch ports other than the port the frame was received on.B、The frame is transmitted on the native VLAN.C、The switch sends a NACK segment to the frame’s source MAC address.D、The frame is dropped.
考题
What information is used by a switch to forward an Ethernet frame to its destination?（）A、IP addressB、destination MAC addressC、ARP table entryD、FCS checksum
考题
You suspect that a hacker may be performing a MAC address flooding attack somewhere within the network. Which description correctly describes a MAC address flooding attack？（）A、The attacking device spoofs a source MAC address of a valid host currently in the CAM table. The switch then forwards frames destined for the valid host to the attacking device.B、Frames with unique， invalid destination MAC addresses flood the switch and exhaust CAM table space. The result is that new entries cannot be inserted because of the exhausted CAM table space， and traffic is subsequently flooded out all ports.C、The attacking device crafts ARP replies intended for valid hosts. The MAC address of the attacking device then becomes the destination address found in the Layer 2 frames sent by the valid network device.D、The attacking device crafts ARP replies intended for valid hosts. The MAC address of the attacking device then becomes the source address found in the Layer 2 frames sent by the valid network device.E、The attacking device spoofs a destination MAC address of a valid host currently in the CAM table. The switch then forwards frames destined for the valid host to the attacking device.F、Frames with unique， invalid source MAC addresses flood the switch and exhaust CAM table space. The result is that new entries cannot be inserted because of the exhausted CAM table space， and traffic is subsequently flooded out all ports.G、None of the other alternatives apply
考题
What does a Layer 2 switch use to decide where to forward a received frame?（）A、source MAC addressB、source IP addressC、source switch portD、destination IP addressE、destination port addressF、destination MAC address
考题
What will an Ethernet switch do if it receives a unicast frame with a destination MAC that is listed in the switch table?（）A、The switch will not forward unicast frames.B、The switch will forward the frame to a specific port.C、The switch will return a copy of the frame out the source port.D、The switch will remove the destination MAC from the switch table.E、The switch will forward the frame to all ports except the port on which it was received.
考题
While you are troubleshooting network performance issues， you notice that a switch is periodically flooding all unicast traffic. Further investigation reveals that periodically the switch is also having spikes in CPU utilization， causing the MAC address table to be flushed and relearned. What is the most likely cause of this issue？（）A、a routing protocol that is flooding updatesB、a flapping port that is generating BPDUs with the TCN bit setC、STP is not running on the switchD、a user that is downloading the output of the show-tech commandE、a corrupted switch CAM table
考题
On a Cisco Nexus 7000 Series Switch， what is the purpose of this command？（） switch# config terminal switch（config）# mac address-table learning-mode conversational vlan 1-10 switch（config）# A、 Enable conversational learning on FabricPath vlans 1-10 for F-Series moduleB、 Enable FabricPath protocol on VLANs 1–10C、 No need for this command as conversational learning is enabled by default for all VLANs.D、 Enable conversational learning on Classical Ethernet VLAN for F-Series module
考题
Refer to the exhibit A frame on vlan 1on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?（）A、trunk mode mismatchesB、vlans that do not correspond to a unique IP subnetC、native vlan mismatchesD、allowing only vlan 2 on the destination.
考题
Which of one the following fields is contained within an IEEE Ethernet frame header?（）A、source and destination MAC addressB、source MAC address and destination network address onlyC、source and destination network address onlyD、source network address and destination MAC addressE、source and destination MAC address and source and destination network address
考题
What are two characteristics of "store and forward" switching?（）A、Latency fluctuates regardless of frame size.B、The switch receives the complete frame before beginning to forward it.C、Latency through the switch varies with frame length.D、The switch checks the destination address upon receipt of headers.
考题
What does a Layer 2 switch do if it receives a frame with a destination MAC address that is not found in its MAC address table?（）A、The frame is dropped.B、The frame is addressed with a broadcast MAC address and sent out all ports.C、The frame is sent out all ports except the receiving port.D、An ARP request is sent out all ports except the receiving port.E、A destination unreachable message is sent back to the source address.F、None of the above.
考题
单选题Refer to the exhibit A frame on vlan 1 on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?（）A
trunk mode mismatchesB
vlans that do not correspond to a unique IP subnetC
native vlan mismatchesD
allowing only vlan 2 on the destination.
考题
单选题What information is used by a switch to forward an Ethernet frame to its destination?（）A
IP addressB
destination MAC addressC
ARP table entryD
FCS checksum
考题
单选题Which of one the following fields is contained within an IEEE Ethernet frame header?（）A
source and destination MAC addressB
source MAC address and destination network address onlyC
source and destination network address onlyD
source network address and destination MAC addressE
source and destination MAC address and source and destination network address
考题
单选题Which statement describes multihop FCoE function when an FCoE switch receives an FCoE frame from the directly connected FCoE host？（）A
The switch receives the FCoE frame and forwards it to another switch over its VE port.B
The switch receives the FCoE frame， deapsulates it， and sends the Fibre Channel frame to the fabric over its Fibre Channel uplink port.C
The switch receives the FCoE frame， deapsulates it， and sends the Fibre Channel frame to the Fibre Channel target over its Fibre Channel port.D
The switch receives the FCoE frame and forwards it to another FCoE device over its VN port.
考题
单选题What will an Ethernet switch do if it receives a unicast frame with a destination MAC that is listed in the switch table（）。A
The switch will not forward unicast frames.B
The switch will forward the frame to a specific port.C
The switch will return a copy of the frame out the source port.D
The switch will remove the destination MAC from the switch table.E
The switch will forward the frame to all ports except the port on which it was received.
考题
单选题If a switch is working in the fail-open mode， what will happen when the switch’s CAM table fills to capacityand a new frame arrives？（）A
A copy of the frame is forwarded out all switch ports other than the port the frame was received on.B
The frame is transmitted on the native VLAN.C
The switch sends a NACK segment to the frame’s source MAC address.D
The frame is dropped.
考题
单选题While you are troubleshooting network performance issues， you notice that a switch is periodically flooding all unicast traffic. Further investigation reveals that periodically the switch is also having spikes in CPU utilization， causing the MAC address table to be flushed and relearned. What is the most likely cause of this issue？（）A
a routing protocol that is flooding updatesB
a flapping port that is generating BPDUs with the TCN bit setC
STP is not running on the switchD
a user that is downloading the output of the show-tech commandE
a corrupted switch CAM table
考题
多选题What three pieces of information can be used in an extended access list to filter traffic (Choose three.)（）。AprotocolBVLAN numberCTCP or UDP port numbersDsource switch port numberEsource IP address and destination IP addressFsource MAC address and destination MAC address
考题
单选题What dose a Layer 2 switch use to decide where to forward a received frame?（）A
source MAC addressB
source IP addressC
source switch portD
destination IP addressE
destination port addressF
destination MAC address
考题
多选题What are two characteristics of "store and forward" switching?（）ALatency fluctuates regardless of frame size.BThe switch receives the complete frame before beginning to forward it.CLatency through the switch varies with frame length.DThe switch checks the destination address upon receipt of headers.
热门标签
最新试卷