网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()
A. STP
B. VTP
C. GVRP
D. SNMP
E. DHCP
参考答案
更多 “ Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?() A. STPB. VTPC. GVRPD. SNMPE. DHCP ” 相关考题
考题
You are an administrator of the Ezonexam switched network and your goal is to reduce some of the administrative overhead on your network. You plan on achieving this by configuring a new VLAN for each department in the Ezonexam network.However, you need to share the VLAN information across numerous switches. Which of the following would allow you accomplish this?A. STPB. GVRPC. SNMPD. VTPE. DHCPF. None of the above
考题
Which of the following steps are necessary in order to add a new VLAN to the Ezonexam switched network? (Select all that apply)A．Create the VLAN.B．Name the VLAN.C．Configure an IP address for the VLAN.D．Add the desired ports to the new VLAN.E．Add the VLAN to the VTP domain.
考题
A new switch is being installed in the Ezonexam network and you have been assigned the task of connecting it to an existing switch. In doing this, you want to set up the VLAN Trunking Protocol so that VLAN information can be passed between the switches. Which of the following must you do to accomplish this? (Choose all that apply).A．You must set each end of the trunk line to IEEE 802.1e encapsulation.B．You must set the same VTP management domain name on both switches.C．You must set all ports on the two switches as access ports.D．You must configure one of the switches as a VTP server.E．You must use a rollover cable to connect the two switches.
考题
A new switch is installed in the Ezonexam network. This switch is to be configured so that VLAN information will be automatically distributed to all the other Cisco Catalyst switches in the network.Which of the conditions below have to be met in order for this to occur? (Choose all that apply).A. The switch that will share the VLAN information must be in the VTP Server mode.B. The switches must be in the same VTP domain.C. The switch that will share the VLAN information must be configured as the root bridge.D. The switches must be configured to use the same VTP version.E. The switches must be configured to use the same STP version.F. The switches must be configured to use the same type of ID tagging.G. The switches must be connected over VLAN trunks.
考题
Which one of the following protocols allows the information about the configuration of a new VLAN to be distributed across entire switched network?A. STPB. VTPC. EIGRPD. SNMPE. CDPF. None of the above
考题
Which of the following steps are necessary in order to add a new VLAN to a switched network?()
A. Create the VLAN.B. Name the VLAN.C. Configure an IP address for the VLAN.D. Add the desired ports to the new VLAN.E. Add the VLAN to the VTP domain.
考题
Which one of the following protocols allows the information about the configuration of a new VLAN to be distributed across entire switched network?（）A、STPB、VTPC、EIGRPD、SNMPE、CDPF、None of the above
考题
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?（）A、STPB、VTPC、GVRPD、SNMPE、DHCP
考题
You are an administrator of a switched network and your goal is to reduce some of the administrative overhead on your network. You plan on achieving this by configuring a new VLAN for each department in your network. However, you need to share the VLAN information across numerous switches throughout your network. Which of the following would allow you accomplish this?（）A、STPB、GVRPC、SNMPD、VTPE、DHCP
考题
Which of the following steps are necessary in order to add a new VLAN to a switched network?（）A、Create the VLAN.B、Name the VLAN.C、Configure an IP address for the VLAN.D、Add the desired ports to the new VLAN.E、Add the VLAN to the VTP domain.
考题
The Company network utilizes the Multiple-instance Spanning Tree protocol in its switched LAN. Which three statements about the MST protocol （IEEE 802.1S） are true？ （）A、 To verify the MST configuration， the show pending command can be used in MST configuration mode.B、 When RSTP and MSTP are configured； UplinkFast and BackboneFast must also be enabled.C、 All switches in the same MST region must have the same VLAN-to-instance mapping， but different configuration revision numbers.D、 All switches in an MST region， except distribution layer switches， should have their priority lowered from the default value 32768.E、 An MST region is a group of MST switches that appear as a single virtual bridge to adjacent CST and MST regions.F、 Enabling MST with the "spanning-tree modemst" global configuration command also enables RSTP.
考题
Which statements describe two of the benefits of VLAN Trunking Protocol?（）A、VTP allows routing between VLANs.B、VTP allows a single switch port to carry information to more than one VLAN.C、VTP allows physically redundant links while preventing switching loops.D、VTP simplifies switch administration by allowing switches to automatically share VLAN configuration information.E、VTP helps to limit configuration errors by keeping VLAN naming consistent across the VTP domain.F、VTP enhances security by preventing unauthorized hosts from connecting to the VTP domain.
考题
Which three statements accurately describe layer 2 Ethernet switches?（）A、Microsegmentation decreases the number of collisions on the network.B、if a switch receives a frame for an unkown destination,it uses ARP to resolve the address.C、Spanning Tree Protocol allows switches to automatically share vlan information.D、In a properly functioning network with redundant switched paths,each switched aegment will contain one root bridge with all its ports in the forwarding state.All other switches in that broadcast domain will have only one root port.E、Establishing vlans increases the number of broadcast domains.F、Switches that are configured with vlans make forwarding decisions based on both layer 2 and layer 3 address information.
考题
An administrator is configuring a Catalyst switch with VLAN information that must be automatically distributed to other Catalyst switches in the network. What conditions must be met in order for the VLANs configured on this switch to be automatically configured on the other switches?（）A、The switch that will share its VLAN configuration must be in VTP server mode.B、The switches must be in the same VTP domain.C、The switch that will share the VLAN information must be configured as the root bridge.D、The switches must be connected over VLAN trunks.E、The switches must be configured to use the same STP version.F、The switches must have VTP pruning activated.
考题
Which protocol provides a method of sharing VLAN configuration information between switches?（）A、VTPB、STPC、ISLD、802.1QE、VLSM
考题
Before inserting a new switch in the network，the network administrator checks that the VTP domain name is correct，the VTP mode is set to server， and revision is lower than the switches in the network. The administrator then configures interfaces and trunks，erases existing VLANs，and connects the switch to the network. Following that procedure，there is no connectivity in the network. What is a possible cause of this problem？（）A、Because the configuration revision of the new switches is lower than the rest of the network， it can change the VLAN database of the other switches.B、As a VTP server， the new switch deleted all VLANs of the network.C、Erasing VLANs increases the VTP configuration revision.D、Since the configuration revision of the network is higher than the new switch， the VLAN database was automatically synchronized.
考题
A new switch is installed in the Testking network. This switch is to be configured sothat VLAN information will be automatically distributed to all the other Cisco Catalyst switches in the network. Which of the conditions below have to be met in order for this to occur?（）A、The switch that will share the VLAN information must be in the VTP Server mode.B、The switches must be in the same VTP domain.C、The switch that will share the VLAN information must be configured as the root bridge.D、The switches must be configured to use the same VTP version.E、The switches must be configured to use the same STP version.F、The switches must be configured to use the same type of ID tagging.G、The switches must be connected over VLAN trunks.
考题
Which three statements accurately describe layer 2 Ethernet switches？（）A、Microsegmentation decreases the number of collisions on the network.B、if a switch receives a frame for an unkown destination，it uses ARP to resolve the address.C、Spanning Tree Protocol allows switches to automatically share vlan information.D、In a properly functioning network with redundant switched paths，each swiched aegment will contain oneroot bridge with all its ports in the forwarding state.All other switches in that broadcast domain will haveonly one root port.E、Establishing vlans increases the number of broadcast domains.F、Switches that are configured with vlans make forwarding decisions based on both layer 2 and layer 3address information.
考题
多选题An administrator is configuring a Catalyst switch with VLAN information that must be automatically distributed to other Catalyst switches in the network. What conditions must be met in order for the VLANs configured on this switch to be automatically configured on the other switches?（）AThe switch that will share its VLAN configuration must be in VTP server mode.BThe switches must be in the same VTP domain.CThe switch that will share the VLAN information must be configured as the root bridge.DThe switches must be connected over VLAN trunks.EThe switches must be configured to use the same STP version.FThe switches must have VTP pruning activated.
考题
单选题You are an administrator of a switched network and your goal is to reduce some of the administrative overhead on your network. You plan on achieving this by configuring a new VLAN for each department in your network. However, you need to share the VLAN information across numerous switches throughout your network. Which of the following would allow you accomplish this?（）A
STPB
GVRPC
SNMPD
VTPE
DHCP
考题
多选题Which of the following steps are necessary in order to add a new VLAN to a switched network?（）ACreate the VLAN.BName the VLAN.CConfigure an IP address for the VLAN.DAdd the desired ports to the new VLAN.EAdd the VLAN to the VTP domain.
考题
多选题Which three statements accurately describe layer 2 Ethernet switches？（）AMicrosegmentation decreases the number of collisions on the network.Bif a switch receives a frame for an unkown destination，it uses ARP to resolve the address.CSpanning Tree Protocol allows switches to automatically share vlan information.DIn a properly functioning network with redundant switched paths，each swiched aegment will contain oneroot bridge with all its ports in the forwarding state.All other switches in that broadcast domain will haveonly one root port.EEstablishing vlans increases the number of broadcast domains.FSwitches that are configured with vlans make forwarding decisions based on both layer 2 and layer 3address information.
考题
多选题Which statements describe two of the benefits of VLAN Trunking Protocol？（）AVTP allows routing between VLANs.BVTP allows a single switch port to carry information to more than one VLAN.CVTP allows physically redundant links while preventing switching loops.DVTP simplifies switch administration by allowing switches to automatically share VLAN configuration information.EVTP helps to limit configuration errors by keeping VLAN naming consistent across the VTP domain.FVTP enhances security by preventing unauthorized hosts from connecting to the VTP domain.
考题
多选题Which three statements accurately describe layer 2 Ethernet switches?（）AMicrosegmentation decreases the number of collisions on the network.Bif a switch receives a frame for an unkown destination,it uses ARP to resolve the address.CSpanning Tree Protocol allows switches to automatically share vlan information.DIn a properly functioning network with redundant switched paths,each switched aegment will contain one root bridge with all its ports in the forwarding state.All other switches in that broadcast domain will have only one root port.EEstablishing vlans increases the number of broadcast domains.FSwitches that are configured with vlans make forwarding decisions based on both layer 2 and layer 3 address information.
考题
单选题Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?（）A
STPB
VTPC
GVRPD
SNMPE
DHCP
考题
多选题The Company network utilizes the Multiple-instance Spanning Tree protocol in its switched LAN. Which three statements about the MST protocol （IEEE 802.1S） are true？ （）ATo verify the MST configuration， the show pending command can be used in MST configuration mode.BWhen RSTP and MSTP are configured； UplinkFast and BackboneFast must also be enabled.CAll switches in the same MST region must have the same VLAN-to-instance mapping， but different configuration revision numbers.DAll switches in an MST region， except distribution layer switches， should have their priority lowered from the default value 32768.EAn MST region is a group of MST switches that appear as a single virtual bridge to adjacent CST and MST regions.FEnabling MST with the spanning-tree modemst global configuration command also enables RSTP.
考题
单选题Which one of the following protocols allows the information about the configuration of a new VLAN to be distributed across entire switched network?（）A
STPB
VTPC
EIGRPD
SNMPE
CDPF
None of the above
热门标签
最新试卷