网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
单选题
A spur gear pump should be operated with the discharge valves （）.
A
slightly opened
B
throttled
C
fully opened
D
halfway opened
参考答案
参考解析
解析：
暂无解析
更多 “单选题A spur gear pump should be operated with the discharge valves （）.A slightly openedB throttledC fully openedD halfway opened” 相关考题
考题
A spur gear pump should be operated with the discharge valves ______.A.slightly openedB.throttledC.fully openedD.halfway opened
考题
Which method should be used to warm up the pump turbines prior to discharge ________．A.Lock the turbine rotor and slowly bleed in steam until operating temperature is reachedB.Run the pump at high speed with the discharge valves closedC.Run the turbine at slow speed with the pump disconnectedD.Shut the discharge valve and run the pump at slow speed
考题
单选题In （） pump a closed discharge valve will not cause excessive pressure to build up.A
gearB
vaneC
screwD
centrifugal
考题
单选题When the desired rudder angle is attained by a typical double mm electro-hydraulic steering gear,the（）.A
ram relief valves bypass oil to stop rudder movementB
six-way valve shifts to the neutral flow positionC
steering pump electric motor is de - energized by the transfer switchD
follow-up gear takes the hydraulic pump off stroke
考题
单选题When the helm demands a 20°right rudder movement from an electro-hydraulic steering gear, which of the listed actions will be the FIRST action to happen when this rudder position is attained?（）A
The six-way valve opensB
The steering service pump motor is stoppedC
The follow-up gear takes the pump off strokeD
The cylinder relief valves bypass oil to the suction side the pump
考题
单选题If a centrifugal bilge pump were continually operated with the discharge valve closed the （）.A
motor overload would openB
relief valve would openC
pump would eventually overheatD
motor would overheat
考题
单选题If a hydraulic governor has been refilled with oil, the engine should be operated until it reaches normal temperaturethen the air should be purged, and the（）A
rack position should be adjustedB
compensating needle valve should be opened fully compensatingC
needle valve should be adjusted to stabilize operationD
speed limiting device should be adjusted
考题
单选题Which of the following will be the advantage of a centrifugal pump as compared with a reciprocating pump?（） (1) Its discharge is continuous (2) It has no internal valves (3) Upon accidental closing of discharge valve, excessive pressure will not build upA
（1），（2）B
（2），（3）C
（1），（2），（3）D
（2）only
考题
单选题An advantage of a helical gear pump over a simple gear pump is that the helical gear pump is capable of （）.A
maintaining a steadier speedB
delivering liquids over greater distancesC
operating for longer periods of timeD
producing a smoother discharge flow
考题
单选题Which method should be used to warm up the pump turbines prior to discharge（）.A
Lock the turbine rotor and slowly bleed in steam until operating temperature is reachedB
Run the pump at high speed with the discharge valves closedC
Run the turbine at slow speed with the pump disconnectedD
Shut the discharge valve and run the pump at slow speed
考题
单选题Which of the following is NOT true according to the passage?（）A
Both the main steering gear and the auxiliary steering gear should be operatedB
The alarms fitted to the remote control system should be operatedC
The emergency generator compartment should be checkedD
The communication system between the bridge and the steering gear compartment should be operated
考题
单选题Which of the listed items should be secured before performing any maintenance on a solenoid operated air start valve?（）A
Electric power and starting airB
Lube oil standby pump and control airC
Hydraulic switch and engage jacking gearD
Motor drain and pneumatic control system power
考题
单选题The usual symptoms of cavitation in a centrifugal pump is （）.A
noise and vibrationB
an increase in discharge pressureC
an increase in suction pressureD
lifting of the relief valve
考题
单选题If the engine does start on air, but combustion does not immediately begin, the cause may not be （）.A
low compressionB
failure of the fuel pump to discharge fuelC
incorrect timing of fuel pumpD
turning gear being still on
考题
单选题Which of the listed statements is correct concerning the starting of centrifugal pumps?（）A
They should always be started with the discharge valve closedB
They should always be started with the discharge valve openedC
A priming pump is always required to flood the impeller suctionD
They should always be started with the sealing line valves closed
考题
单选题A relief valve for a cargo pump is generally installed（）.A
after the discharge valveB
between the pump and discharge valveC
after the suction valveD
between the pump and suction valve
考题
单选题If a centrifugal pump were continually operated with the discharge valve closed, the （）.A
motor controller overload would openB
pump would eventually overheatC
relief valve would continuously cycle openD
motor would overheat
考题
单选题When starting a centrifugal pump, the discharge valve should be （）.A
closedB
opened fullyC
cracked openD
partly open
考题
单选题The advantage of a centrifugal pump as compared with a reciprocating pump is that （）.A
discharge is continuousB
it has no internal valvesC
upon accidental closing of discharge valve, excessive pressure will not build upD
all of the above are true
考题
单选题The valve on the discharge side of a cargo pump on a tanker will usually be a（）.A
butterfly valveB
spectacle valveC
check valveD
globe valve
考题
单选题One of the consequences in continuing to operate a centrifugal bilge pump with the discharge valve closed, is that the （）.A
motor overload will openB
relief valve will openC
pump will overheatD
motor will overheat
考题
单选题The simplest method to use for determining if a centrifugal pump is operating as designed, is to （）.A
closely observe the pump discharge temperatureB
close off the discharge valve, and watch for a rise in pressureC
momentarily close off the suction valve, and watch for a rise in pressureD
use a clamp on ammeter and compare the readings to past records
考题
单选题If an operating bilge pump is developing good vacuum, but is unable to discharge any water, which of the following problems is the most probable cause?（）A
The wearing rings are excessively wornB
The suction strainer is cloggedC
The discharge valve is cloggedD
The shaft is worn
考题
单选题With reference to operating a four-ram steering gear system under emergency conditions, which one of the following statements is incorrect?（）A
Only one pump should be used at any timeB
The ship speed should be reduced to 70% of the normalC
Watch keeping of the steering gear should be increasedD
Limitations of the steering gear should be logged but the bridge need not be informed
考题
单选题What is the purpose of a relief valve?（）A
to fill 2 tanks at the same timeB
to use pump at a higher pressureC
to return liquid to suction side if discharge valve is closedD
All of the above are true
考题
单选题The valve on the discharge side of a cargo pump on a tank vessel will usually be a（）.A
butterfly valveB
spectacle valveC
check valveD
globe valve
考题
单选题If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.A
a low load on the unitB
a clogged pump suction strainerC
a blockage in the line between the pump and hydraulic motorD
the hydraulic motor turning too fast
热门标签
最新试卷